化工进展 ›› 2024, Vol. 43 ›› Issue (2): 565-578.DOI: 10.16085/j.issn.1000-6613.2023-1341

• 专栏:多相流测试 •    下一篇

气力输送颗粒系统中静电的研究进展

刘浩宇1(), 赵彦琳1(), 姚军1, WANG Chi-Hwa2   

  1. 1.中国石油大学(北京)机械与储运工程学院,清洁能源科学与技术国际联合实验室,过程流体过滤与分离技术 北京市重点实验室,北京 102249
    2.新加坡国立大学化学与生物分子工程系,新加坡 肯特岗 117585
  • 收稿日期:2023-08-07 修回日期:2023-09-14 出版日期:2024-02-25 发布日期:2024-03-07
  • 通讯作者: 赵彦琳
  • 作者简介:刘浩宇(1998—),女,博士研究生,研究方向为多相流数值计算、颗粒静电。E-mail:3462693752@qq.com
  • 基金资助:
    国家自然科学基金(52376156);外国专家项目(G2022122006L)

Research advances of electrostatics in pneumatic conveying granules systems

LIU Haoyu1(), ZHAO Yanlin1(), YAO Jun1, WANG Chi-Hwa2   

  1. 1.International Joint Laboratory on Clean Energy Science and Technology, Beijing Key Laboratory of Process Fluid Filtration and Separation, College of Mechanical and Transportation Engineering, China University of Petroleum-Beijing, Beijing 102249, China
    2.Department of Chemical and Biomolecular Engineering, National University of Singapore, Kent Ridge 117585, Singapore
  • Received:2023-08-07 Revised:2023-09-14 Online:2024-02-25 Published:2024-03-07
  • Contact: ZHAO Yanlin

摘要:

在过去的几十年里,由于许多工业问题和相关新技术的发展,颗粒和颗粒流的静电学得到了越来越多的关注。颗粒-颗粒和颗粒-壁面之间发生碰撞从而产生静电。静电的发生会受多种因素的影响,随着颗粒与壁面之间的接触会在它们的表面产生静电荷的积累,静电量可以达到饱和状态。本文分别综述了气力输送颗粒系统中的静电发生及静电平衡,着重分析了颗粒与壁面之间接触带电的两种方式(碰撞带电和摩擦带电)、颗粒流模式及受力情况,讨论了颗粒带电过程所受的影响因素,包括外界条件(温度、相对湿度)、颗粒几何条件(尺寸、形状、接触面积、粗糙度)以及受力条件(摩擦力、常压)等。此外,对气力输送颗粒系统中静电的数值计算作了简单介绍。最后,为澄清气力输送颗粒系统中静电发生的机理,对单颗粒发生静电的物理机制进行了分析。根据对相关研究结果的总结,发现由于碰撞或摩擦造成的电荷转移的工作机制尚未完全明了,这些问题将在未来逐步得到解决。

关键词: 静电效应, 颗粒, 气力输送, 接触带电

Abstract:

In past decades, the electrostatics of granules and granular flows has obtained more and more attention due to many industrial problems and development of new technologies. The collisions between granule-granule and granule-wall generate electrostatics. The occurrence of electrostatic can be affected by a variety of factors. As the contact between the granular and the wall, the accumulation of electrostatic charge on their surfaces can reach to an equilibrium state. The present work reviewed electrostatic generation and electrostatic equilibrium in pneumatic conveying granules systems. Two main contact charging ways between granule and wall (collision electrification and friction electrification), granular flow pattern and dynamic analysis were analyzed emphatically. The factors affecting the charging process of granules were discussed, including external conditions (temperature, relative humidity), granules geometry conditions (size, shape, contact area, roughness) and stress conditions. Besides, the numerical calculations of electrostatics in pneumatic conveying granules systems were introduced briefly. Finally, in order to clarify the mechanism of electrostatics in the pneumatic conveying granules systems, the physical mechanism of electrostatics in single granules was analyzed. This review revealed that the working mechanism of electron transfer due to collision or friction remains was not fully understood. These issues is expected to be resolved gradually in the future.

Key words: electrostatic interactions, granules, pneumatic conveying, contact electrification

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn