化工进展 ›› 2018, Vol. 37 ›› Issue (03): 822-831.DOI: 10.16085/j.issn.1000-6613.2017-0797

• 化工过程与装备 • 上一篇    下一篇

NH3-SCR工艺中硫酸铵盐的生成与分解机理研究进展

唐昊1, 李慧1, 杨江毅1, 蔺卓玮1, 庄柯2, 陆强1, 李文艳1   

  1. 1 华北电力大学生物质发电成套设备国家工程实验室, 北京 102206;
    2 国电环境保护研究院, 江苏 南京 210031
  • 收稿日期:2017-05-02 修回日期:2017-11-02 出版日期:2018-03-05 发布日期:2018-03-05
  • 通讯作者: 陆强,副教授,硕士生导师,主要从事固体燃料热化学转化以及烟气污染物治理的研究。
  • 作者简介:唐昊(1992-),男,硕士研究生。E-mail:tanghao530326@163.com。
  • 基金资助:
    国家重点基础研究发展计划(2015CB251501)、北京市科技新星项目(Z171100001117064)及中央高校基本科研业务专项资金项目(2015ZD08,2016YQ05)。

Research progress on the formation and decomposition mechanism of ammonium-sulfate salts in NH3-SCR technology

TANG Hao1, LI Hui1, YANG Jiangyi1, LIN Zhuowei1, ZHUANG Ke2, LU Qiang1, LI Wenyan1   

  1. 1 National Engineering Laboratory for Biomass Power Generation Equipment, North China Electric Power University, Beijing 102206, China;
    2 State Power Environmental Protection Research Institute, Nanjing 210031, Jiangsu, China
  • Received:2017-05-02 Revised:2017-11-02 Online:2018-03-05 Published:2018-03-05

摘要: 以氨为还原剂的选择性催化还原(NH3-SCR)脱硝法具有脱硝效率高、选择性好和技术完善等优点,是目前应用最广泛的燃煤电厂等行业的烟气脱硝技术。然而,烟气中的SO2流经SCR催化剂时,在V2O5的催化作用下部分氧化为SO3,随后与NH3和水蒸气反应生成硫酸氢铵和硫酸铵。当烟气温度低于硫酸铵盐的凝结温度时,会沉积在催化剂、空预器及其附属设备上,引发诸多严重的问题。本文首先介绍了硫酸铵盐的形成机理,随后从反应物浓度和反应温度等角度概括了影响硫酸铵盐生成的因素,分析了硫酸铵盐的沉积及其所带来的危害。然后介绍了硫酸铵盐的分解机理,重点分析了催化剂与硫酸氢铵之间的相互作用,指出了这种相互作用对硫酸氢铵分解的影响,由此提出了控制硫酸铵盐生成的措施。最后指出,系统研究NH3-SCR工艺中硫酸铵盐的生成与分解机理将为催化剂的失活与再生、低温SCR催化剂的开发和燃煤机组等相关设备的设计和运行优化等提供理论依据。

关键词: 选择性催化还原, 催化剂, 硫酸铵盐, 生成与分解机理, 沉积物

Abstract: Selective catalytic reduction denitrification method with ammonia as the reducing agent (NH3-SCR) has high denitrification efficiency,good selectivity and high level of refinement,and thus,is the most widely used flue gas denitrification technology in coal-fired power plants and other industries at present. However,when the flue gas flows through the SCR catalyst,SO2 in the flue gas is oxidized into SO3 by the V2O5. Ammonium sulfate and ammonium bisulfate are then produced when SO3 reacts with NH3 and water vapor. These ammonium-sulfate salts will probably be deposited in the catalyst,air preheater and affiliated equipment when the flue gas temperature is below their condensation temperatures,which may cause many serious problems. In this review,the formation mechanism of ammonium-sulfate salts is introduced at first. Then the main factors that affect the formation of ammonium-sulfate salts are summarized in terms of concentration of the reactants and the reaction temperature. Afterwards,the deposition of the ammonium-sulfate salts and its harm are analyzed. The decomposition mechanism of ammonium-sulfate salts is introduced,and the interaction between the catalyst and ammonium bisulfate is discussed in detail,whose influence on the decomposition of ammonium bisulfate is pointed out. Finally,the measures for controlling the formation of ammonium-sulfate salts are proposed. Overall,systematic research on the formation and decomposition mechanism of ammonium-sulfate salts in the NH3-SCR process provides theoretical basis for the deactivation and regeneration of SCR catalysts,the development of low temperature SCR catalysts and the optimization of operation and design of the related equipments in coal-fired power plants,which therefore deserves further research.

Key words: selective catalytic reduction(SCR), catalyst, ammonium-sulfate salts, formation and decomposition mechanism, deposition

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn