化工进展 ›› 2021, Vol. 40 ›› Issue (8): 4456-4462.DOI: 10.16085/j.issn.1000-6613.2020-1790

• 材料科学与技术 • 上一篇    下一篇

氧化石墨烯改性环氧树脂涂料的制备及防腐性能

马骏1(), 孙冬1, 张明爽2, 张兰河2, 陈子成2()   

  1. 1.国网吉林省电力有限公司通化供电公司,吉林 通化 134000
    2.东北电力大学化学工程学院,吉林 吉林 132012
  • 收稿日期:2020-09-04 出版日期:2021-08-05 发布日期:2021-08-12
  • 通讯作者: 陈子成
  • 作者简介:马骏(1975—),男,工程师,研究方向为输电线路锈蚀监测与防腐技术。E-mail:105388896@qq.com
  • 基金资助:
    国网吉林省电力有限公司通化供电公司科学技术项目(SGJLTH00YJJS2000330);吉林省发改委产业技术研究与开发项目(2020C028-5)

Preparation of graphene oxide modified epoxy resin coating and research on its anti-corrosive performance

MA Jun1(), SUN Dong1, ZHANG Mingshuang2, ZHANG Lanhe2, CHEN Zicheng2()   

  1. 1.Tonghua Power Supply Company, State Grid Jilin Electric Power Co. , Ltd. , Tonghua 134000, Jilin, China
    2.School of Chemical Engineering, Northeast Electric Power University, Jilin 132012, Jilin, China
  • Received:2020-09-04 Online:2021-08-05 Published:2021-08-12
  • Contact: CHEN Zicheng

摘要:

环氧树脂在溶剂蒸发过程中容易产生微孔,影响其防腐蚀性能。为了提高其对腐蚀介质的阻碍能力,本文采用密闭氧化法制备氧化石墨烯,再利用湿式转移法将氧化石墨烯水溶液分散在环氧树脂中,制备氧化石墨烯/环氧树脂防腐涂料。通过红外光谱(FTIR)、X射线衍射(XRD)和拉曼光谱(Raman)分析氧化石墨烯的结构变化,利用开路电位测试(OCP)、水接触角、腐蚀形貌和气体透过率分析氧化石墨烯/环氧树脂涂料的防腐性能。结果表明,氧化石墨烯/环氧树脂(GO/EP)涂料的开路电位和水接触角分别为0.181V和86.12°,与纯环氧树脂涂料相比,分别提高了0.066V和10.5°;当GO/EP浸泡在3.5%NaCl溶液中腐蚀20天后,表面仅产生了粗糙化,涂层稳定性好,屏障性能强;与EP涂层相比,GO/EP涂层的O2和H2O渗透率分别降低了51.2%和65.5%。

关键词: 腐蚀, 环氧树脂, 氧化石墨烯, 复合材料, 防腐性能, 机械性能

Abstract:

Epoxy resin is easy to produce micropore during the process of solvent evaporation, which can impact its corrosion resistance performance. In order to improve the corrosion resistance of epoxy resin, the closed oxidation method was applied to prepare grapheme oxide. Graphene oxide/epoxy resin anti-corrosion coatings were prepared by dispersing the grapheme oxide aqueous solution into epoxy resin using wet transfer method. The structure change of graphene oxide was characterized by infrared spectroscopy (FTIR), X-ray diffraction (XRD) and Raman spectroscopy (Raman). The anti-corrosion performance of graphene oxide/epoxy resin coating was analyzed by origination potential (OCP), water contact angle, corrosion morphology and gas permeation rate. The results showed that in comparison with EP coatings, the open circuit potential and water contact angle of GO/EP were 0.181V and 86.12°, which were increased by 0.066V and 10.5°, respectively. When GO/EP was immersed in 3.5% NaCl solution and corroded for 20 days, the surface only had roughness. The coating had good stability and strong barrier performance. Compared with EP coating, the O2 and H2O permeability of GO/EP coating were decreased by 51.2% and 65.5%, respectively.

Key words: corrosion, epoxy resin, graphene oxide, composites, anti-corrosion performance, mechanical properties

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn