化工进展 ›› 2023, Vol. 42 ›› Issue (1): 546-552.DOI: 10.16085/j.issn.1000-6613.2022-1067

• 资源与环境化工 • 上一篇    下一篇

表面活性雾滴联合金属网栅增效除尘

邓权龙1(), 丁厚成1, 徐远迪1, 蒋仲安2, 杨岚1, 孙雪霏1   

  1. 1.安徽工业大学建筑工程学院,安徽 马鞍山 243002
    2.北京科技大学土木与资源工程学院,北京 100083
  • 收稿日期:2022-06-08 修回日期:2022-07-12 出版日期:2023-01-25 发布日期:2023-02-20
  • 通讯作者: 邓权龙
  • 作者简介:邓权龙(1990—),男,博士,讲师,研究方向为尘毒防治。E-mail:dql3316@ahut.edu.cn
  • 基金资助:
    安徽高校自然科学研究项目(KJ2019A0052);国家级大学生创新训练项目(202110360050);省级大学生创新训练项目(S202110360232);安徽工业大学青年基金项目(QZ202016)

Synergistic dust removal performance of surfactant droplets combined with metal mesh grid

DENG Quanlong1(), DING Houcheng1, XU Yuandi1, JIANG Zhong’an2, YANG Lan1, SUN Xuefei1   

  1. 1.School of Civil Engineering and Architecture, Anhui University of Technology, Maanshan 243002, Anhui, China
    2.School of Civil and Resource Engineering, University of Science and Technology Beijing, Beijing 100083, China
  • Received:2022-06-08 Revised:2022-07-12 Online:2023-01-25 Published:2023-02-20
  • Contact: DENG Quanlong

摘要:

为进一步探索新型高效的复合式湿式除尘方法,基于表面活性剂增效润湿、喷雾降尘、水膜捕尘理论,构建了喷雾协同金属网栅除尘试验装置,通过对表面活性溶液性质的测试,优选出AES、LAB-35、X-100共三种活性剂进行试验,探究风速、喷雾压力、网孔目数、网栅层数和粉尘浓度对除尘性能的影响规律。研究结果表明:除尘效率随着风速增大呈现先逐渐升高、后缓慢下降的趋势,当风速为0.8m/s时达到峰值;随着目数、层数、喷雾压力增加,除尘效率有所升高,同时导致系统阻力或耗水量的增加,需要综合平衡;入口粉尘浓度的增大致使除尘效率先增大然后降低,当浓度为400mg/m3时,效率最高达96.74%;三种表面活性雾滴中,0.4%LAB-35雾滴除尘效率最高,其次为0.4%AES雾滴,最低为0.4%X-100雾滴。综上,与纯水喷雾联合金属网栅除尘相比,表面活性喷雾具有较好的增效作用,能够为新型湿式除尘设备的研发提供参考。

关键词: 湿式除尘, 喷雾, 表面活性剂, 金属网栅, 粉体技术, 优化

Abstract:

In order to further explore new and efficient composite wet dust removal technology, the experimental research on the synergistic dust removal performance of surfactant droplets combined with metal mesh grid was carried out. Based on the theories of surfactant-enhanced wetting, spray dust prevention, and water-film separator, a novel test device for dust removal was constructed. Further-more, AES, LAB-35 and X-100 were selected for the experiment by testing the surface tension. The influence of air velocity, spray pressure, mesh number, number of layers and inlet dust concentration on the efficiency of dust removal was investigated in detail. The research results showed that with the increase of wind speed, the dust removal efficiency firstly increased and then slowly decreased, and the dust removal efficiency reached peak value when the wind speed was 0.8m/s. Increasing the number of layers, mesh number and spray pressure could raise the dust removal efficiency while the system resistance or water consumption increased, therefore, a comprehensive balance needed to be considered. Similarly, with the increase of the inlet dust concentration, the dust removal efficiency first increased and then decreased. When the dust concentration was 400mg/m3, the maximum dust removal efficiency was up to 96.74%. Among the three surface active droplets, 0.4% LAB-35 droplets had the highest dust removal efficiency, followed by 0.4% AES drop-lets and 0.4% X-100 droplets. In summary, the surfactant droplets had better synergistic effect than the pure water droplets combined with the metal mesh grid for dust removal, which has significant reference value for the design of new wet dust removal equipment.

Key words: wet dust removal, spray, surfactants, metal mesh grid, powder technology, optimization

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn