高通量换热器用于低温发电系统的研究

doi:10.16085/j.issn.1000-6613.2018-0127

摘要/Abstract

摘要： 针对高通量换热器用于有机朗肯循环（organic Rankine cycle，ORC）低温发电系统进行了理论研究，以芳烃装置二甲苯塔余热回收为实例，选取6种工质运用Aspen Plus模拟软件分析了普通光管蒸发器夹点温差对ORC系统的影响，并将使用高通量蒸发器时ORC系统的发电性能与使用普通蒸发器时进行了对比分析。结果表明：芳烃装置ORC发电系统蒸发器夹点温差越小，发电性能越好，但小于10℃后普通换热器面积急剧增大，成本升高，限制了ORC系统发电性能的提升。以最佳工质R601夹点温差12℃时作为基础工况，高通量蒸发器的总换热系数比普通蒸发器可增加26%以上，使用高通量蒸发器比普通蒸发器的换热面积减小21%，若换热面积保持不变，夹点温差可减小2.5℃，此时ORC系统的净输出功率可增加约49kW，R601流量减少1559kg/h，发电性能得到了提升。

关键词: 有机朗肯循环, 余热回收, 高通量换热器, 芳烃装置, 工质, 夹点温差

Abstract: In this paper, high flux heat exchanger used for organic Rankine cycle (ORC) for low-temperature cogeneration system was studied. In the case of waste heat recovery of xylene tower in aromatic unit, six working fluids were used to analyze the influence of general evaporator pinch-point temperature difference on ORC system performance by Aspen Plus simulation software. Then, the generation performances of ORC system were compared when general evaporator and high flux evaporator were used separately. The results showed that the smaller pinch-point temperature difference of general evaporator is, the better generation performance of ORC system in aromatic unit is, but the evaporator area increases sharply when pinch-point temperature difference is less than 10℃, leading to higher costs and then limiting the generation performance boost of ORC system. The most suitable organic working fluid is R601 for ORC system, when the general evaporator pinch-point temperature difference is 12℃, the total heat transfer coefficient of high flux evaporator is more than 26% higher than that of general evaporator, and the application of high flux evaporator can reduce the heat transfer area by 21%. If the heat transfer area remains unchanged, the pinch-point temperature difference can decrease by 2.5℃, at this time, net generation power of ORC system can increase about 49kW, the reduction of R601 mass flow is 1559kg/h, so the generation performance has been improved.

Key words: organic Rankine cycle, waste heat recovery, high flux heat exchanger, aromatic unit, working fluid, pinch-point temperature difference

中图分类号:

TM617

姚玉婷, 李士雨. 高通量换热器用于低温发电系统的研究[J]. 化工进展, 2018, 37(10): 3737-3743.

YAO Yuting, LI Shiyu. A study on high flux heat exchanger used for low-temperature cogeneration system[J]. Chemical Industry and Engineering Progress, 2018, 37(10): 3737-3743.

参考文献

[1] 甘德华. 芳烃抽提节能改造方案及效果[J]. 石油石化节能与减排, 2011, 1(9):15-19. GAN Dehua. Energy conservation measures for aromatics extraction unit[J]. Energy Conservation and Emission Reduction in Petroleum and Petrochemical Industry, 2011, 1(9):15-19.
[2] 陶良权, 刘京雷, 夏翔鸣, 等. 不锈钢基高通量换热管多孔层的耐乙酸腐蚀特性[J]. 化工进展, 2017, 36(6):2255-2261. TAO Liangquan, LIU Jinglei, XIA Xiangming, et al. Corrosion resistance properties of stainless steel-based porous layer of high flux exchanging tube in acetic acid solution[J]. Chemical Industry and Engineering Progress, 2017, 36(6):2255-2261.
[3] DEWANGAN A K, KUMAR A, KUMAR R. Pool boiling of iso-butane and quasi azeotropic refrigerant mixture on coated surfaces[J]. Experimental Thermal and Fluid Science, 2017, 85:176-188.
[4] 杨君祺. 高效管在制冷系统中的蒸发传热性能研究[D]. 上海:华东理工大学, 2015. YANG Junqi. The evaporation characteristic of high efficient heat transfer tube in refrigeration system[D]. Shanghai:East China University of Science and Technology, 2015.
[5] NISHIKAWA K, ITO T, TANAKA K. Enhanced heat transfer by nucleate boiling on a sintered metal layer[J]. Heat Transfer-Japanese Research, 1979, 8(2):65-81.
[6] YILMAZ S, WESTWATER J W. Effect of commercial enhanced surfaces on the boiling heat transfer curve[J]. American Society of Mechanical Engineers, Heat Transfer Division, 1981, 18:73-91.
[7] WANG X S, WANG Z B, CHEN Q Z. Research on manufacturing technology and heat transfer characteristics of sintered porous surface tubes[C]//JIANG Z, ZHANG C L. Manufacturing Science and Engineering, PTS 1-5. Switzerland:Advanced Materials Research, 2010:1161-1165.
[8] 郭兆阳, 徐鹏, 王元华, 等. 烧结型多孔表面管外池沸腾传热特性[J]. 化工学报, 2012, 63(12):3798-3804. GUO Zhaoyang, XU Peng, WANG Yuanhua, et al. Pool boiling heat transfer on sintered porous coating tubes[J]. CIESC Journal, 2012, 63(12):3798-3804.
[9] 王宏智, 刘京雷, 戴玉林, 等. 高效换热器用烧结型复合粉末多孔管研究[J]. 华北电力大学学报(自然科学版), 2010, 37(1):33-35. WANG Hongzhi, LIU Jinglei, DAI Yulin, et al. Study on sintered porous coating tubes with composite cowder in high efficiency heat exchangers[J]. Journal of North China Electric Power University, 2010, 37(1):33-35.
[10] JUNG D S, AN K Y, PARK J. Nucleate boiling heat transfer coefficients of HFC22, HFC134a, HFC125, and HFC32 on various enhanced tubes[J]. International Journal of Refrigeration-Revue Internationale Du Froid, 2004, 27(2):202-206.
[11] 孙兆虎, 公茂琼, 李志坚, 等. 多元混合工质池核沸腾传热实验研究[J]. 制冷学报, 2006(1):9-14. SUN Zhaohu, GONG Maoqiong, LI Zhijian, et al. Experiment study of pool boiling heat transfer of multicomponent mixed-refrigerants[J]. Journal of Refrigeration, 2006(1):9-14.
[12] 徐宏, 戴玉林, 夏翔鸣, 等. 高通量换热器研制及在大型石化装置中的节能应用[J]. 太原理工大学学报, 2010, 41(5):577-580. XU Hong, DAI Yulin, XIA Xiangming, et al. Manufacture of high flux heat exchanger and its application in large scale petrochemical equipment[J]. Journal of Taiyuan University of Technology, 2010, 41(5):577-580.
[13] O'Neill P S, GOTTZMANN C F, TERBOT J W. Heat exchanger for NGL[J]. Chemical Engineering Progress, 1971, 67(7):80.
[14] NISHITH B D, SANTANU B. Process integration of organic Rankine cycle[J]. Energy, 2009, 34(10):1674-1686.
[15] GU W, WENG Y W, WANG Y Z, et al. Theoretical and experimental investigation of an organic Rankine cycle for a waste heat recovery system[J]. Journal of Power and Energy, 2009, 223(5):523-533.
[16] SCHUSTER A, KARELLAS S, KAKARAS E, et al. Energetic and economic investigation of organic Rankine cycle applications[J]. Applied Thermal Engineering, 2009, 29(8):1809-1817.
[17] 叶依林. 基于太阳能的有机朗肯循环低温热发电系统的研究[D]. 北京:华北电力大学, 2012. YE Yilin. The study of low-temperature power generation based on solar organic rankine cycle[D]. Beijing:North China Electric Power University, 2012.
[18] FREDY V. Selecting working fluids in an organic Rankine cycle for power generation from low temperature heat sources[J]. Universidad Nacional De Colombia, 2014, 81(188):173-180.
[19] 王大彪, 段捷, 胡哺松, 等. 有机朗肯循环发电技术发展现状[J]. 节能技术, 2015, 33(3):235-242. WANG Dabiao, DUAN Jie, HU Busong, et al. Status of organic rankine cycle power generation technology[J]. Energy Conservation Technology, 2015, 33(3):235-242.
[20] SALEH B, KOGLBAUER G, WENDLAND M, et al. Working fluids for low-temperature organic Rankine cycles[J]. Energy, 2007, 7(32):1210-1221.
[21] PAPADOPOULOS AI, STIJEPOVIC M, LINKE P. On the systematic design and selection of optimal working fluids for organic Rankine cycles[J]. Applied Thermal Engineering, 2010, 6(30):760-769.
[22] ZHU K, ZHANG M, WANG Y B, et al. Parametric optimization of low temperature ORC system[J]. Energy Procedia, 2015, 75:1596-1602.
[23] 李虎, 张于峰, 李鑫钢, 等. 低温发电系统在精馏工艺中的节能技术[J]. 化工进展, 2013, 32(5):1187-1193. LI Hu, ZHANG Yufeng, LI Xingang, et al. Energy-saving technology research of low-temperature cogeneration system in rectifying process[J]. Chemical Industry and Engineering Process, 2013, 32(5):1187-1193.
[24] KASKA O. Energy and exergy analysis of an organic Rankine for power generation from waste heat recovery in steel industry[J]. Energy Conversion and Management, 2014, 77:108-117.
[25] 姚玉婷, 李士雨. 芳烃装置中二甲苯塔顶冷凝热用于有机朗肯循环低温热发电[J]. 石油化工, 2018, 47(4):356-361. YAO Yuting, LI Shiyu. Use of overhead condensation heat of xylene column in aromatic plant for organic Rankine cycle low-temperature cogeneration[J]. Petrochemical Technology, 2018, 47(4):356-361.
[26] TCHANCHE B F, PAPADAKIS G, LAMBRINOS G, et al. Fluid selection for a low-temperature solar organic rankine cycle[J]. Applied Thermal Engineering, 2009, 29(11/12):2468-2476.
[27] 王建永, 王江峰, 王红阳, 等. 有机朗肯循环地热发电系统工质选择[J]. 工程热物理学报, 2017, 38(1):11-17. WANG Jianyong, WANG Jiangfeng, WANG Hongyang, et al. Selection of working fluid for organic Rankine cycle used in geothermal power plant[J]. Journal of Engineering Thermophysics, 2017, 38(1):11-17.
[28] 俞佳, 陆友俊, 张冠文, 等. 高通量换热管与烧结型高通量换热管性能介绍[J]. 中国冶金, 2017, 27(8):50-55. YU Jia, LU Youjun, ZHANG Guanwen, et al. Introduction of high flux heat exchange tube and performance of sintered high flux heat exchange tube[J]. China Metallurgy, 2017, 27(8):50-55.