化工进展 ›› 2023, Vol. 42 ›› Issue (2): 614-623.DOI: 10.16085/j.issn.1000-6613.2022-0469

• 专栏:工业污泥/精馏釜残的热化学转化利用 • 上一篇    下一篇

含油污泥多相复合调质降黏破乳分离过程

杨娟娟1,2(), 何林1,2,3(), 贺常晴1,2, 李鑫钢1,2,3, 隋红1,2   

  1. 1.天津大学化工学院,天津 300072
    2.精馏技术国家工程研究中心,天津 300072
    3.天津大学浙江研究院,浙江 宁波 315201
  • 收稿日期:2022-03-24 修回日期:2022-05-30 出版日期:2023-02-25 发布日期:2023-03-13
  • 通讯作者: 何林
  • 作者简介:杨娟娟(1999—),女,硕士研究生,研究方向为非常规石油分离过程。E-mail:yangjuanjuan@tju.edu.cn
  • 基金资助:
    国家自然科学基金(22178252)

Treatment of oily sludge through multiphase compound conditioning and demulsification separation process

YANG Juanjuan1,2(), HE Lin1,2,3(), HE Changqing1,2, LI Xingang1,2,3, SUI Hong1,2   

  1. 1.School of Chemical Engineering and Technology, Tianjin University, Tianjin 300072, China
    2.National Engineering Research Centre of Distillation Technology, Tianjin 300072, China
    3.Zhejiang Institute of Tianjin University, Ningbo 315201, Zhejiang, China
  • Received:2022-03-24 Revised:2022-05-30 Online:2023-02-25 Published:2023-03-13
  • Contact: HE Lin

摘要:

含油污泥普遍存在于石油开采、加工及使用等过程中,因其高黏度、复杂稳定乳化特性导致处理难度大,处理效率低。针对传统工艺分离效率低的问题,本文基于工程应用的目标,提出油泥多相复合调质降黏破乳分离工艺,对油泥进行资源化分离。首先,对含油污泥进行了不同的降黏处理,分别通过添加正庚烷和水多相复合调质的方法,可以调控体系乳化状态,溶解重质组分,破坏其空间结构,有效降低含油污泥表观黏度。在此基础上,将调质降黏与破乳相耦合对含油污泥进行资源化回收处理,分别探究了调质过程和破乳过程对处理效果的影响。结果表明,加入水辅助调质降黏,可有效分散含油污泥团聚体,促进重油溶解与传质,正庚烷通过稀释降低油组分黏度,并从固体表面溶解剥离。通过对油泥乳化态的调控,协同使用高效破乳剂可实现油、水、固的高效分离。当溶剂用量130%,水用量30%时,体系为油包水状态,添加400mg/kg油包水型破乳剂TJU-3处理后,重油回收率可达92.86%,油相清洁。本研究可以为含油污泥大规模资源化回收处理提供参考。

关键词: 含油污泥, 多相复合, 降黏, 破乳, 资源化

Abstract:

Oily sludge widely exists in the petroleum exploration, petrochemical processing and application. Because of its high viscosity, complex and stable emulsification characteristics, the treatment of oily sludge is fairly difficult with low treatment efficiency. Aiming at the problem of low separation efficiency of traditional process, this study put forward the resourceful treatment of oily sludge through multiphase compound conditioning and demulsification separation process, based on the engineering application. Firstly, the different viscosity reduction methods of oily sludge was studied. It was found that the viscosity of oily sludge could be effectively reduced by multiphase composite method, owning to the control of the emulsification state, the dissolution of the heavy components and the destruction of its spatial structure. On this basis, the resourceful treatment of oily sludge was carried out by the combination of multiphase compound conditioning and demulsification, and the influence of conditioning and demulsification process on the treatment effect was studied respectively. The results showed that the addition of water could assist the conditioning process to reduce the viscosity effectively, help disperse oily sludge aggregates and promote the dissolution and mass transfer of heavy oil. The oil was dissolved and liberated from the solid surface by the solvent. Through the control of the emulsification state and the use of high-efficiency demulsifier, the efficient separation of oil, water and solid could be realized. When the solvent dosage was 130% and the water dosage was 30%, the system was in water-in-oil state. After adding 400mg/kg water-in-oil demulsifier TJU-3, the heavy oil recovery could reach to 92.9%, and the oil phase was clean. This study could provide reference for the large-scale resource recovery and treatment of oily sludge.

Key words: oily sludge, multiphase composite, viscosity reduction, demulsification, resourceful treatment

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn