化工进展 ›› 2021, Vol. 40 ›› Issue (8): 4624-4630.DOI: 10.16085/j.issn.1000-6613.2020-1773

• 资源与环境化工 • 上一篇    下一篇

硫酸铵与钛酸钙焙烧动力学

刘维燥1(), 胡金鹏2, 刘清才1, 李春2   

  1. 1.重庆大学材料科学与工程学院,重庆 400044
    2.四川大学化学工程学院,四川 成都 610065
  • 收稿日期:2020-09-03 出版日期:2021-08-05 发布日期:2021-08-12
  • 通讯作者: 刘维燥
  • 作者简介:刘维燥(1992—),男,博士,助理研究员,研究方向为CO2矿物封存、矿产资源利用。E-mail:liuwz@cqu.edu.cn
  • 基金资助:
    国家重点研发计划(2016YFB0600904);中国博士后科学基金(2020TQ0392)

Roasting kinetics of ammonium sulfate and calcium titanate

LIU Weizao1(), HU Jinpeng2, LIU Qingcai1, LI Chun2   

  1. 1.College of Materials Science and Engineering, Chongqing University, Chongqing 400044, China
    2.School of Chemical Engineering, Sichuan University, Chengdu 610065, Sichuan, China
  • Received:2020-09-03 Online:2021-08-05 Published:2021-08-12
  • Contact: LIU Weizao

摘要:

近年来,以硫酸铵为助剂,采用含钛高炉渣矿化CO2同时提取其中的有价钛铝组分的研究日益受到关注。钛酸钙是含钛高炉渣的主要物相之一,其与硫酸铵焙烧过程的机理及动力学研究有助于深刻理解含钛高炉渣分解过程。本文分别采用等温法和非等温法研究了硫酸铵与钛酸钙的焙烧动力学,考察了焙烧反应的动力学参数和控制步骤。等温动力学结果表明,硫酸铵与钛酸钙的焙烧过程分为两步,即硫酸铵分解和硫酸氢铵与钛酸钙反应,其中硫酸铵分解为限制环节,受化学反应控制。单一硫酸铵分解反应活化能为65.56kJ/mol,加入钛酸钙后促进硫酸铵的分解,活化能降低至50.15kJ/mol。采用基辛格法、FWO法、KAS法三种非等温动力法测得整个焙烧过程的表观活化能分别为53.96kJ/mol、76.67kJ/mol和71.05kJ/mol,其中基辛格法的表观活化能结果与等温动力学相一致,而FWO法和KAS法所得表观活化能变化趋势验证了等温动力学结果对焙烧过程中控制步骤的选择。

关键词: CO2矿化, 硫酸铵, 含钛高炉渣, 钛酸钙, 动力学

Abstract:

Recently, more and more attention has been paid to simultaneously mineralize CO2 and extraction of valuable components from titanium-bearing blast furnace slag by ammonium sulfate roasting. Calcium titanate is one of the main phases of titanium-bearing blast furnace slag. The study on the mechanism and kinetics of the reaction between titanium-bearing blast furnace slag and ammonium sulfate is helpful to understand the decomposition process of the slag. In this study, isothermal and non-isothermal kinetics research methods were adopted to study the roasting reaction of (NH4)2SO4 and CaTiO3. The kinetic parameter and control step of the roasting reaction were investigated. Isothermal kinetics research results showed that the roasting reaction was divided into two steps, i.e. the decomposition of (NH4)2SO4 and reaction between NH4HSO4 and CaTiO3. The former was the limited step controlled by chemical reaction. The decomposition activation energies of single (NH4)2SO4 was calculated as 65.56kJ/mol, while it decreased to 50.15kJ/mol after adding CaTiO3. The apparent activation energies of the roasting reaction were measured as 53.96kJ/mol, 76.67kJ/mol and 71.05kJ/mol by three non-isothermal kinetics research methods including Kissinger, FWO and KAS, respectively. The apparent activation energy gained by Kissinger method was consistent with that in isothermal kinetics research method, and the trend of the apparent activation energy gained by FWO and KAS verified the rate control steps measured by isothermal kinetics research method.

Key words: CO2 mineralization, ammonium sulfate, titanium-bearing blast furnace slag, calcium titanate, kinetics

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn