化工进展 ›› 2022, Vol. 41 ›› Issue (3): 1528-1538.DOI: 10.16085/j.issn.1000-6613.2021-1712

• 减污降碳协同化工节能减排技术 • 上一篇    下一篇

鼓泡床中电石渣加速碳酸化分析与响应面优化

郑鹏(), 李蔚玲(), 郭亚飞, 孙健, 王瑞林, 赵传文   

  1. 南京师范大学能源与机械工程学院,江苏 南京 210046
  • 收稿日期:2021-08-11 修回日期:2021-09-29 出版日期:2022-03-23 发布日期:2022-03-28
  • 通讯作者: 李蔚玲
  • 作者简介:郑鹏(1997—),男,硕士研究生,研究方向为鼓泡床多相流反应器。E-mail:411533280@qq.com
  • 基金资助:
    国家自然科学基金(51706108);江苏省高校自然科学研究面上项目(17KJB470008);南京师范大学科研启动项目(184080H202B73)

Analysis of carbide slag accelerated carbonation in bubble column and response surface optimization

ZHENG Peng(), LI Weiling(), GUO Yafei, SUN Jian, WANG Ruilin, ZHAO Chuanwen   

  1. School of Energy and Mechanical Engineering, Nanjing Normal University, Nanjing 210046, Jiangsu, China
  • Received:2021-08-11 Revised:2021-09-29 Online:2022-03-23 Published:2022-03-28
  • Contact: LI Weiling

摘要:

搭建了鼓泡床碳酸化反应器,研究常温常压下电石渣直接液相碳酸化矿化封存CO2的能力,揭示了重要操作参数表观气速、液固比和CO2浓度对电石渣矿化封存CO2能力和碳酸化效率的影响规律。同时构建响应面模型,分析各参数对电石渣碳酸化效率的影响强度,优化获得最大碳酸化效率及相应操作工况。结果表明,增加气速有利于钙离子溶解和CO2吸收,但反应器中过高气速易导致气相通道效应,不利于气液充分接触。当液固比降低,溶液中钙离子浓度提高,更有利于碳酸化反应,但液固比过低会影响固液间传质。适当增加CO2浓度有利于提高碳酸化效率,但CO2浓度增至到一定值后,对碳酸化效率影响降低。响应面建模分析发现,各因素对碳酸化效率影响顺序为:液固比>CO2浓度>表观气速。优化结果发现碳酸化效率最高为93.58%,工况为表观气速0.07m/s,液固比为8.26mL/g和CO2体积分数为20.91%。研究可知,鼓泡床中常温常压下电石渣直接液相加速碳酸化反应,具有较大的CO2固定量和高的碳酸化效率,实验结果为电石渣加速矿化封存CO2技术的发展提供了基础数据。

关键词: 鼓泡反应器, 温室气体, 二氧化碳捕集, 多相反应器, 加速碳酸化, 响应面模型, 电石渣

Abstract:

A bubble column carbonation reactor was set up. The CO2 mineralization capacity through the direct aqueous carbonation of carbide slag under ambient temperature and atmospheric pressure was evaluated. The effects of the important operating parameters, including the superficial gas velocity, liquid to solid ratio and CO2 concentration, on the capacity of CO2 mineral carbonation and carbonation efficiency of carbide slag were revealed. The response surface model was built to analyze the effects of the operating parameters and to obtain the maximum of the carbonation efficiency. The results indicated that the increase in the gas velocity was beneficial to the calcium ion dissolution and CO2 absorption, but it will have the gas channeling effect in the reactor when the gas velocity was high, which has an effect on the solid-liquid mass transfer and reduces the carbonation efficiency. When the liquid to solid ratio reduced, the concentration of calcium ions rose, which was good for the carbonation reactions. However, when the liquid to solid ratio was very small, it was disadvantageous for the solid-liquid mass transfer. Proper increase in the CO2 concentration was beneficial to enhance the carbonation efficiency. When the CO2 concentration increased to a certain level, it had a rare effect on the carbonation efficiency. According to the response surface modeling, the impact degree on the carbonation efficiency ranged as liquid-solid ratio > CO2 concentration > superficial gas velocity. The optimization carbonation efficiency was 93.58% found by the response surface optimization, and the corresponding superficial gas velocity was 0.07m/s, the liquid-solid ratio 8.26mL/g and the CO2 concentration was 20.91%. Therefore, the results showed that it had a good CO2 mineralization capacity and a high carbonation efficiency for the direct aqueous carbonation of carbide slag under ambient temperature and pressure in a bubble column. This study provides the theoretical data for CO2 capture by aqueous mineral carbonation of carbide slag. Accelerated carbonation of carbide slag in the bubble column is a promising process for CO2 capture due to its higher carbonation conversion of carbide slag within a shorter reaction time.

Key words: bubble column reactor, greenhouse gas, CO2 capture, multiphase reactor, accelerated carbonation, response surface model, carbide slag

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn