Chemical Industry and Engineering Progress ›› 2018, Vol. 37 ›› Issue (09): 3618-3628.DOI: 10.16085/j.issn.1000-6613.2017-2557

Previous Articles     Next Articles

A review on surface sulfidization of typical copper/lead/zinc oxide minerals flotation

SONG Kaiwei, LI Jialei, CAI Jinpeng, LIU Siyan, CAO Yang, SU Chao, LIU Dianwen   

  1. Faculty of Land Resource Engineering, State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization, Kunming University of Science and Technology, Kunming 650093, Yunnan, China
  • Received:2017-12-12 Revised:2018-04-16 Online:2018-09-05 Published:2018-09-05

典型氧化铜铅锌矿物浮选的表面硫化研究进展

宋凯伟, 李佳磊, 蔡锦鹏, 刘思言, 曹阳, 苏超, 刘殿文   

  1. 昆明理工大学国土资源工程学院, 复杂有色金属资源清洁利用国家重点实验室, 云南 昆明 650093
  • 通讯作者: 刘殿文,教授,博士生导师,研究方向为资源综合利用与环保、浮选理论与工艺。
  • 作者简介:宋凯伟(1986-)男,博士研究生,研究方向为浮选理论与工艺;李佳磊(1993-),男,硕士研究生,研究方向为资源综用与环保。
  • 基金资助:
    国家自然科学基金项目(51264019)。

Abstract: With the exhaust of sulphide ores, development and utilization of oxide ores have been received increasing attention in recent years. Sulfidization flotation is an extensively used method to recover copper/lead/zinc oxide minerals, and sulfidization is a key part of this methodology. In this review, five oxidized minerals bearing copper, lead or zinc were introduced. Roles on oxidized minerals flotation of sulfidation were dissected. The surface sulfidization mechanism of oxide minerals and its influenced factors were presented. Two stages are involved in the sulphidizing process:chemical adsorption and chemical reaction. After adsorption on the particle surface, the sulfide ions might react with oxide minerals to form a metal sulfide coating, which activate minerals flotation. The sulphidizing reactions are affected by pH and slurry temperature, sulphidizing reactions time, sulphidizing agent dosage and its addition form, metal ions and minerals characteristic, etc. There may be interaction among the factors. Surface sulfidization can be enhanced with some reagents which can improve the rate and limit of sulphidizing reactions, or mechanical strength of reaction products. The results suggested that some influence factors and mechanism of enhanced sulfidization are unclear. In order to guide practice better, further studies on them are needed based on multidiscipline approaches, in-situ measuring technique and computer simulation which are also the research directions and inevitable requirement for flotation.

Key words: copper/lead/zinc oxide, flotation, sulfidization, surface, chemical reaction, chemical adsorption, enhanced sulfidization

摘要: 近年来随着硫化矿石资源的枯竭,氧化矿石资源的开发利用越来越受到关注。工业上普遍使用硫化浮选来回收氧化铜铅锌矿物资源,硫化是该工艺的关键环节。本文简述了5种典型的氧化矿物,分析了硫化的作用,重点综述了氧化矿物表面硫化机理及其影响因素的研究进展。指出氧化矿物的硫化过程包括化学吸附和化学反应两个阶段,硫离子在矿物表面吸附后,与氧化矿物反应生成金属硫化物层进而活化浮选;矿浆pH与温度、硫化时间、硫化剂用量及其添加方式、金属离子和矿物自身特征等多种因素能显著影响氧化矿物的硫化反应,且各因素之间可能存在交互影响;通过添加某些药剂可以强化氧化矿物的表面硫化,能提高硫化反应的速率与程度,或增大硫化产物的机械强度。分析认为目前表面硫化的一些影响因素及强化硫化的机制仍不清楚,应通过多学科交叉、原位表征技术和计算机模拟等手段加强研究,从而更好地指导生产;同时利用3种手段也是浮选研究的发展方向和必然要求。

关键词: 氧化铜/氧化铅/氧化锌, 浮选, 硫化, 表面, 化学反应, 化学吸附, 强化硫化

CLC Number: 

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd