化工进展 ›› 2020, Vol. 39 ›› Issue (3): 1095-1100.DOI: 10.16085/j.issn.1000-6613.2019-0643

• 材料科学与技术 • 上一篇    下一篇

基于阳极氧化法的TiO2纳米管制备及生成过程分析

成先雄(),陈于梁,孔张亮,廖金明,连军锋,黄雅莲   

  1. 江西理工大学赣江流域水质安全保障工程技术研究中心,江西 赣州 341000
  • 收稿日期:2019-04-23 出版日期:2020-03-05 发布日期:2020-04-03
  • 通讯作者: 成先雄
  • 作者简介:成先雄(1977—),男,副教授,从事水处理高级氧化技术与饮用水消毒技术研究。E-mail:2233950601@qq.com
  • 基金资助:
    国家自然科学基金青年科学基金(51808268);江西理工大学大学生创新创业训练计划(DC2018-009)

Preparation of titanium dioxide nanotubes by anodic oxidation and analysis of the formation process

Xianxiong CHENG(),Yuliang CHEN,Zhangliang KONG,Jinming LIAO,Junfeng LIAN,Yalian HUANG   

  1. Research Center for Water Quality Security Technology at Ganjiang River Basin, Jiangxi University of Science and Technology, Ganzhou 341000, Jiangxi, China
  • Received:2019-04-23 Online:2020-03-05 Published:2020-04-03
  • Contact: Xianxiong CHENG

摘要:

运用阳极氧化法制备TiO2纳米管,探讨了TiO2纳米管紫外光催化净化头孢噻肟钠抗生素废水的效果,采用扫描电镜(SEM)和X射线衍射仪(XRD)对TiO2纳米管进行了表征分析。SEM结果显示,制备的TiO2材料表面呈阵列排布的多孔状,内径大小均匀,管径分布在30~45nm之间,管阵列呈蜂窝状,与钛板表面垂直,对比煅烧前后的TiO2纳米管XRD图,发现煅烧后样品的XRD图出现了TiO2锐钛矿型特征衍射峰和金红石型特征衍射峰。讨论了TiO2纳米管的生成机理,认为纳米管的形成过程主要有最初氧化层的形成、孔核的形成、由孔核演变成微孔、微孔生长并出现空隙、形成纳米阵列管过程。

关键词: 阳极氧化法, TiO2纳米管, 光化学, 催化, 降解

Abstract:

In this paper, TiO2 nanotubes were prepared using an anodic oxidation method, and their performance in the photocatalytic degradation of cefotaxime in wastewater was discussed. The TiO2 nanotubes were characterized by scanning electron microscope and X-ray diffraction. The SEM images showed that the surface of the prepared titanium dioxide was porous and the inner diameter distribution was uniform. The diameters of the tubes were distributed in 30—45nm. The tube arrays were honeycomb-like and perpendicular to the surface of the titanium plate. Compared with the XRD images of the TiO2 nanotubes before and after calcination, that after calcination showed the characteristic diffraction peaks of anatase and rutile types. The formation mechanism of TiO2 nanotubes during the electrolysis process was discussed, which might include five stages: the formation of initial oxide layers, the architecture of pore nucleus, the evolution of pore nucleus into micropores, the growth of micropores with gap appearance, and the final formation of the target nanotube arrays.

Key words: anodic oxidation method, TiO2 nanotubes, photochemistry, catalysis, degradation

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn