化工进展 ›› 2016, Vol. 35 ›› Issue (08): 2569-2574.DOI: 10.16085/j.issn.1000-6613.2016.08.42

• 资源与环境化工 • 上一篇    下一篇

Fe(Ⅱ)(EDTA)/O3工艺处理含聚废水实验

于忠臣1, 魏震1, 董喜贵2, 刘书孟2, 王松1, 钟柳波1   

  1. 1. 东北石油大学土木建筑工程学院, 黑龙江 大庆 163318;
    2. 大庆油田公司第二采油厂, 黑龙江 大庆 163414
  • 收稿日期:2016-01-06 修回日期:2016-03-03 出版日期:2016-08-05 发布日期:2016-08-05
  • 通讯作者: 于忠臣(1975—),男,硕士,副教授,从事有机废水高级氧化技术、新型油-水分离理论和技术研究和教学工作。E-mail:yuzi7777@163.com。
  • 作者简介:于忠臣(1975—),男,硕士,副教授,从事有机废水高级氧化技术、新型油-水分离理论和技术研究和教学工作。E-mail:yuzi7777@163.com。
  • 基金资助:
    黑龙江省自然科学基金(B2015012)及黑龙江省博士后项目(161260)。

Study on the degradation of polymer-contained wastewater by the Fe(Ⅱ)(EDTA)/O3 process

YU Zhongchen1, WEI Zhen1, DONG Xigui2, LIU Shumeng2, WANG Song1, ZHONG Liubo1   

  1. 1. School of Civil Engineering and Architecture, Northeast Petroleum University, Daqing 163318, Heilongjiang, China;
    2. Oil Production Plant No.2, Daqing Oilfield Co., Ltd., Daqing 163414, Heilongjiang, China
  • Received:2016-01-06 Revised:2016-03-03 Online:2016-08-05 Published:2016-08-05

摘要: 采用Fe(Ⅱ)(EDTA)/O3工艺处理含聚废水,研究EDTA浓度、Fe2+浓度、水力停留时间(HTR)、初始pH对聚丙烯酰胺(PAM)去除率和COD降解效能的影响,探讨了Fe(Ⅱ)络合催化臭氧反应动力学特征及其机理。结果表明:当EDTA浓度为0.050mmol/L、Fe2+浓度为0.050mmol/L和HRT为120min时,PAM去除率为75%;增加水样初始pH有利于提高PAM去除率,同时水样pH随HRT增加缓慢下降;废水COD值在HRT为30min内逐渐增至最大,随后逐渐减小并达到稳定。Fe(II)(EDTA)/O3工艺处理含聚废水的反应符合二级动力学反应,初始PAM质量浓度在50~100mg/L范围内,二级反应速率常数为2.35×10-4~3.35×10-4L/(mg·min)。

关键词: Fe(Ⅱ)(EDTA)/O3工艺, 含聚废水, 催化, 聚丙烯酰胺, 动力学, 反应

Abstract: The Fe(II)(EDTA)/O3 process was used to degrade polymer-contained wastewater. The effects of influencing factors such as EDTA concentration,Fe2+ concentration,hydraulic retention time (HRT) and initial pH on removal rate of polyacrylamide (PAM) and degradation efficiency of COD were studied. Moreover,the kinetic characteristics and mechanism of Fe (Ⅱ) complexing and catalysis reaction of ozone were discussed. Results showed that the PAM removal rate reached at 75% when the EDTA concentration was 0.050mmol/L,Fe2+ concentration was 0.050mmol/L and HRT was 120min. The increase of initial pH was in favor of PAM removal rate. At the same time,the pH of the wastewater decreased slowly along with the HRT. In addition,the COD values of the wastewater gradually increased to maximum when the HRT was during 30min and then decreased with the time gradually to a stable value. Furthermore,the degradation of polymer-contained wastewater conformed to the second-order kinetics whose rate constant was 2.35×10-4—3.35×10-4L/(mg·min) when the initial PAM concentration was 50—100mg/L.

Key words: Fe(Ⅱ)(EDTA)/O3 process, polymer-contained wastewater, catalysis, polyacrylamide (PAM), kinetics, reaction

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn