1 |
HE Y L, HAN H, TAO W Q. Numerical study of heat-transfer enhancement by punched winglet-type vortex generator arrays in fin-and-tube heat exchangers[J]. International Journal of Heat and Mass Transfer, 2012, 55(21/22): 5449-5458.
|
2 |
HAN H, HE Y L, TAO W Q, et al. A parameter study of tube bundle heat exchangers for fouling rate reduction[J]. International Journal of Heat and Mass Transfer, 2014, 72: 210-221.
|
3 |
韩中合, 李鹏. 低温省煤器对凝汽器真空及机组热经济性影响[J]. 化工进展, 2015, 34(11): 4114-4119.
|
|
HAN Zhonghe, LI Peng. Impacts of adding low-temperature economizer on condenser vacuum and thermal economic[J]. Chemical Industry and Engineering Progress, 2015, 34(11): 4114-4119.
|
4 |
雷健康, 王浩楠, 赵伶玲. 空气预热器蓄热板硫酸氢铵动态积灰模型[J]. 热力发电, 2020, 49(9): 52-57.
|
|
LEI Jiankang, WANG Haonan, ZHAO Lingling. Dynamic ash deposition model of hydrogen sulfate in an air preheater[J]. Thermal Power Generation, 2020, 49(9): 52-57.
|
5 |
罗闽. SCR脱硝改造后空气预热器受热面积灰特性的数值研究[D]. 南京: 东南大学, 2016.
|
|
LUO Min. Study on numerical simulation of deposition characteristics of air preheater regenerator after SCR denitrification reform[D]. Nanjing: Southeast University, 2016.
|
6 |
胡双南. H型鳍片省煤器简介及其与光管省煤器的比较[J]. 电站系统工程, 2012, 28(5): 44, 46.
|
|
HU Shuangnan. Introduction of H-type bar economizer and compare with private economizer[J]. Power System Engineering, 2012, 28(5): 44, 46.
|
7 |
JIN Y, TANG G H, HE Y L, et al. Parametric study and field synergy principle analysis of H-type finned tube bank with 10 rows[J]. International Journal of Heat and Mass Transfer, 2013, 60: 241-251.
|
8 |
WANG H, LIU Y W, YANG P, et al. Parametric study and optimization of H-type finned tube heat exchangers using Taguchi method[J]. Applied Thermal Engineering, 2016, 103: 128-138.
|
9 |
黄远东, 阎满存, 张红武, 等. 气固两相流体绕圆柱流动的数值模拟[J]. 中国沙漠, 2001, 21(2): 200-203.
|
|
HANG Yuandong, YAN Mancun, ZHANG Hongwu, et al. Numerical simulation of gas-particle two-phase flows passing circular cylinder[J]. Journal of Desert Research, 2001, 21(2): 200-203.
|
10 |
MU L, ZHAO L, YIN H C. Modelling and measurements of the characteristics of ash deposition and distribution in a HRSG of wastewater incineration plant[J]. Applied Thermal Engineering, 2012, 44: 57-68.
|
11 |
王飞龙, 何雅玲, 汤松臻, 等. 典型烟气余热换热器气侧积灰特性[J]. 科学通报, 2017, 62(12): 1292-1301.
|
|
WANG Feilong, HE Yaling, TANG Songzhen, et al. Numerical study of fouling characteristics on two kinds of typical heat exchangers used in the waste heat recovery systems[J]. Chinese Science Bulletin, 2017, 62(12): 1292-1301.
|
12 |
CHEN H, WANG Y G, ZHAO Q X, et al. Experimental investigation of heat transfer and pressure drop characteristics of H-type finned tube banks[J]. Energies, 2014, 7(11): 7094-7104.
|
13 |
HAN H, HE Y L, TAO W Q. A numerical study of the deposition characteristics of sulfuric acid vapor on heat exchanger surfaces[J]. Chemical Engineering Science, 2013, 101: 620-630.
|
14 |
HE Y L, HAN H, TANG S Z, et al. Sulfuric acid deposition characteristics of H-type finned tube bank with 10 rows[J]. International Journal of Heat and Mass Transfer, 2015, 81: 137-141.
|
15 |
SHI Y T, GAO M, TANG G H, et al. Experimental research of CFB ash deposition on helical finned tubes[J]. Applied Thermal Engineering, 2012, 37: 420-429.
|
16 |
马大卫, 黄齐顺, 查智明, 等. 燃煤电厂空预器结垢成因分析及处理措施[J]. 电力科技与环保, 2017, 33(2): 56-59.
|
|
MA Dawei, HUANG Qishun, Zhiming CHA, et al. Analysis and solution of air-preheater scaling in coal-fired power plants[J]. Electric Power Environmental Protection, 2017, 33(2): 56-59.
|
17 |
刘建民, 陈国庆, 黄启龙, 等. 燃煤脱硝机组空气预热器蓄热片表面飞灰沉积板结机理研究[J]. 中国电机工程学报, 2016, 36(S1): 132-139.
|
|
LIU Jianming, CHEN Guoqing, HUANG Qilong, et al. Study on mechanism of fly ash deposition and hardening on the air preheater regenerative piece surface of the coal-fired and denitration unit[J]. Proceedings of the Chinese Society for Electrical Engineering, 2016, 36(S1): 132-139.
|
18 |
梁登科. 脱硝过程伴生硫酸氢氨对于烟气灰颗粒性质影响的实验研究[D]. 济南: 山东大学, 2014.
|
|
LIANG Dengke. Experimental research on the effects to flue ash particles characteristics of NH4HSO4 generating during the denitrification process[D]. Jinan: Shandong University, 2014.
|
19 |
刘海啸. 硫酸氢氨造成的空预器堵塞治理对策研究[D]. 北京: 华北电力大学,2017.
|
|
LIU Haixiao. Air preheater jams caused by ammonia hydrogen sulfate governance countermeasure research[D]. Beijing: North China Electric Power University, 2017.
|
20 |
MU L, ZHAO L, YIN H C. Modelling and measurements of the characteristics of ash deposition and distribution in a HRSG of wastewater incineration plant[J]. Applied Thermal Engineering, 2012, 44: 57-68.
|
21 |
MANUEL García Pérez, Vakkilainen ESA. A comparison of turbulence models and two and three dimensional meshes for unsteady CFD ash deposition tools[J]. Fuel, 2019, 237: 806-811.
|
22 |
TOMECZEK J, WACLAWIAK K. Two-dimensional modelling of deposits formation on platen superheaters in pulverized coal boilers[J]. Fuel, 2009, 88(8): 1466-1471.
|
23 |
RAYMOND M B, PATRICK F D. A mathematical model of the impact and adhesion of microsphers[J]. Aerosol Science and Technology, 1992, 16(1): 51-64.
|
24 |
王诚雨. 硫酸氢铵对回转式空预器积灰特性的影响[D]. 北京: 华北电力大学, 2019.
|
|
WANG Chengyu. Effect of ammonium bisulfate on ash deposition characteristics of rotary air preheater[D]. Beijing: North China Electric Power University, 2019.
|
25 |
ŽUKAUSKAS A, ULINSKAS R. Efficiency parameters for heat transfer in tube banks[J]. Heat Transfer Engineering, 1985, 6(1): 19-25.
|
26 |
TANG S Z, HE Y L, WANG F L, et al. Parametric study on fouling mechanism and heat transfer characteristics of tube bundle heat exchangers for reducing fouling considering the deposition and removal mechanisms[J]. Fuel, 2018, 211: 301-311.
|