化工进展 ›› 2017, Vol. 36 ›› Issue (11): 4293-4300.DOI: 10.16085/j.issn.1000-6613.2017-0374

• 资源与环境化工 • 上一篇    下一篇

光催化对多通道陶瓷膜错流超滤去除腐植酸膜污染的影响

杨涛1,2, 乔波1, 李国朝1,2, 刘芬1,2, 柏凌2   

  1. 1. 九江学院化学与环境工程学院, 江西 九江 332005;
    2. 江西省生态化工工程技术研究中心, 江西 九江 332005
  • 收稿日期:2017-03-07 修回日期:2017-05-06 出版日期:2017-11-05 发布日期:2017-11-05
  • 通讯作者: 杨涛(1977-),男,博士,副教授,主要研究方向为光催化及膜分离技术。
  • 作者简介:杨涛(1977-),男,博士,副教授,主要研究方向为光催化及膜分离技术。E-mail:yangtao558@163.com。
  • 基金资助:
    国家自然科学基金项目(21566013)。

Effects of photocatalysis on membrane fouling in cross-flow system with multichannel ceramic ultrafiltration membrane for removal of humic acid

YANG Tao1,2, QIAO Bo1, LI Guochao1,2, LIU Fen1,2, BO Ling2   

  1. 1. School of Chemistry and Enviroment Engineering, Jiujiang University, Jiujiang 332005, Jiangxi, China;
    2. Jiangxi Province Engineering Research Center of Ecological Chemical Industry, Jiujiang 332005, Jiangxi, China
  • Received:2017-03-07 Revised:2017-05-06 Online:2017-11-05 Published:2017-11-05

摘要: 为研究光催化作用对多通道陶瓷超滤膜去除水中腐植酸膜污染行为的影响,采用光催化陶瓷膜组合工艺,考察了不同光催化剂浓度下膜通量、污染物去除率、膜污染模式、膜污染阻力变化趋势以及在线反冲洗对膜通量变化的影响。结果表明:光催化可有效减缓陶瓷膜通量衰减程度,并提高污染物去除率;催化剂浓度为0.4g/L时膜通量衰减最小,最终相对膜通量达58.6%,催化剂浓度为0.6g/L时污染去除率最高,其中DOC为76.5%,UV254为87.3%,UV436为96.8%;光催化膜工艺在过滤初期经过短暂膜堵塞及过渡阶段后,膜污染以污染物在膜表面沉积为主;光催化可明显减低膜污染总阻力及可逆污染阻力;光催化作用下在线反冲洗对膜通量的恢复作用较小,但每次反冲前的膜通量衰减程度也小,使得在周期性在线反冲洗工艺中,光催化作用下的膜通量整体运行区间明显高于无光催化时的情况。

关键词: 多通道陶瓷膜, 催化, 膜污染, 腐植酸, 超滤, 氧化

Abstract: In order to investigate the effects of photocatalysis on membrane fouling behaviors using hybrid process of photocatalysis and multichannel ceramic ultrafiltration membrane for removal of humic acid from water,the membrane flux variations,pollutant removal rates,membrane fouling models and membrane fouling resistances under different photocatalyst concentrations were discussed. The backwash effects on membrane flux variations were also observed. The results showed that the photocatalysis could effectively improve the steady permeate fluxes and removal rates of pollutants. As the catalyst concentration was 0.4g/L,the relative membrane flux reached the lowest value of 58.6%. As the catalyst concentration was 0.6g/L,the pollutants removal rates gained the highest level,in which the DOC,UV254 and UV436 reached 76.5%,87.3% and 96.8%, respectively. In the hybrid process of photocatalysis and ceramic membrane,the membrane fouling firstly underwent a short time of membrane pore blocking and transition stage,and then were mainly controlled by the deposition of pollutants on the membrane surface. The photocatalysis can significantly reduce the total and reversible membrane fouling resistances. Under the photocatalysis, although on-line backwashing had less effect on membrane flux recovery,its membrane fluxes also decreased limitedly prior to every backwashing. Therefore,in the periodic on-line backwashing process,the overall running range of the membrane flux under the photocatalysis was much higher than that of the situation without using photocatalysis.

Key words: multichannel ceramic membranes, catalysis, membrane fouling, humic acid, ultrafiltration, oxidation

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn