工质表面张力和黏度对脉动热管启动及传热热阻的影响

doi:10.16085/j.issn.1000-6613.2016-2309

化工进展 ›› 2017, Vol. 36 ›› Issue (08): 2816-2821.DOI: 10.16085/j.issn.1000-6613.2016-2309

工质表面张力和黏度对脉动热管启动及传热热阻的影响

郑开明, 徐荣吉, 王瑞祥, 邢美波, 蔡骥驰, 苑亚

北京建筑大学北京市建筑能源高效综合利用工程技术研究中心, 北京 100044

收稿日期:2016-12-13 修回日期:2017-03-21 出版日期:2017-08-05 发布日期:2017-08-05
通讯作者: 王瑞祥,教授,研究方向为制冷与空调系统热物理过程、纳米材料与工质技术。
作者简介:郑开明(1991-),男,硕士研究生,研究方向为制冷系统热物理过程。E-mail:zhengkaiming2015@163.com。
基金资助:
国家自然科学基金青年基金（51506004）及北京市自然科学基金（3162009）项目。

Influence of surface tension and viscosity on the start-up time and thermal resistance of pulsating heat pipe

ZHENG Kaiming, XU Rongji, WANG Ruixiang, XING Meibo, CAI Jichi, YUAN Ya

Beijing Engineering Research Centre of Sustainable Energy and Buildings, Beijing University of Civil Engineering and Architecture, Beijing 100044, China

Received:2016-12-13 Revised:2017-03-21 Online:2017-08-05 Published:2017-08-05

摘要/Abstract

摘要： 以表面活性剂全氟辛酸钾（potassium perfluorooctanoate，PFOK）为溶质，以纯水为基液，配制了质量分数为0.02%、0.05%、0.1%、0.2%、0.5%共5种溶液并进行了物性测试，发现PFOK对水的表面张力改变较大，黏度其次，比热容、密度、热导率等参数影响较小；实验研究了不同表面张力及黏度工质对内径为2.5mm的脉动热管在不同加热功率下的启动时间和传热热阻的变化规律。结果表明：加热功率对启动时间的促进作用在≤ 60W时较为明显；由于黏度增加的影响，表面张力对启动时间及传热热阻的变化规律都呈现W形图像；并且随着加热功率的增加，表面张力和黏度对传热热阻的影响作用下降。

关键词: 脉动热管, 表面张力, 黏度, 启动时间, 传热热阻

Abstract: Thermo-physical properties of aqueous solutions of potassium perfluorooctanoate(PFOK),with mass fractions of 0.02%,0.05%,0.1%,0.2%,0.5%,were tested respectively. It was found that significant changes in a little amount of PFOK could lead to surface tension of water,viscosity followed,while the specific heat,density,thermal conductivity and other parameters of water were less affected. An experimental study on characteristics of the pulsating heat pipe(PHP),with the inner diameter of 2.5mm of copper pipe,using water of different surface tensions and viscosities was carried out. The results showed that promotion of heating power on startup time is obvious if the heating power input is no more than 60W. Change laws of startup time and thermal resistance with the effect of surface tension present "W" type image due to the increment of viscosity. Besides,the effect of surface tension and viscosity on the thermal resistance is decreased with the increase of the heating power.

Key words: pulsating heat pipe, surface tension, viscosity, startup time, thermal resistance

中图分类号:

郑开明, 徐荣吉, 王瑞祥, 邢美波, 蔡骥驰, 苑亚. 工质表面张力和黏度对脉动热管启动及传热热阻的影响[J]. 化工进展, 2017, 36(08): 2816-2821.

ZHENG Kaiming, XU Rongji, WANG Ruixiang, XING Meibo, CAI Jichi, YUAN Ya. Influence of surface tension and viscosity on the start-up time and thermal resistance of pulsating heat pipe[J]. Chemical Industry and Engineering Progress, 2017, 36(08): 2816-2821.

参考文献

[1] AKACHI H.Structure of a heat pipe:US 4921041[P].1990.
[2] 杨洪海,肖荪,GROLL M.工质热物性对脉动热管运行性能的影响[J].工程热物理学报,2010,31(1):97-99. YANG H H,XIAO S,GROLL M.Effect of thermo physical properties of working fluids on operational performance in pulsating heat pipes[J].Journal of Engineering Thermophysics,2010,31(1):97-99.
[3] 史维秀,李惟毅,潘利生.乙醇水溶液脉动热管传热特性研究[J].机械工程学报,2011,47(24):117-121. SHI W X,LI W Y,PAN L S.Study on heat transfer properties of aqueous ethanol pulsating heat pipe[J].Journal of Mechanical Engineering,2011,47(24):117-121.
[4] SHAFⅡ M B,FAGHRI A,ZHANG Y W.Thermal modeling of unlooped and looped pulsating heat pipes[J].ASME Journal of Heat Transfer,2002,123(6):1159-1172.
[5] SHAFⅡ M B,FAGHRI A,ZHANG Y W.Analysis of heat transfer in unlooped and looped pulsating heat pipes[J]. International Journal of Numerical Methods for Heat and Fluid Flow,2002,12(12):585-609.
[6] ZHANG Y W,FAGHRI A.Heat transfer in a pulsating heat pipe with open end[J].International Journal of Heat and Mass Transfer,2002,45(4):755-764.
[7] ZHANG X M,XU J L,ZHOU Z Q.Experimental study of a pulsating heat pipe using FC-72,ethanol,and water as working fluids[J].Experimental Heat Transfer,2004,17(1):47-67.
[8] 崔晓钰,王妍,翁建华,等.不同工质振荡热管的传热性能[J].上海理工大学学报,2009,31(6):539-543. CUI X Y,WANG Y,WENG J H,et al.Experimental study on pulsating heat pipe with different working fluids[J].Journal University of Shanghai for Science and Technology,2009,31(6):539-543.
[9] 崔晓钰,于洋,朱悦,等.振荡热管传热性能与工质物性关系分析[J].化工进展,2013,32(9):2035-2042. CUI X Y,YU Y,ZHU Y,et al.Correlation on physical properties of working fluids and heat transfer performance of pulsating heat pipes[J].Chemical Industry and Engineering Progress,2013,32(9):2035-2042.
[10] WANG X H,ZHENG H C,SI M Q,et al.Experimental investigation of the influence of surfactant on the heat transfer performance of pulsating heat pipe[J].International Journal of Heat and Mass Transfer,2015,83:586-590.
[11] 蔡骥驰,王瑞祥,徐荣吉,等.SDBS对铜-水脉动热管启动及传热性能影响[J]. 化工学报,2016,67(5):1852-1857. CAI J C,WANG R X,XU R J,et al.Influence of SDBS on start time and heat transfer performance of pulsating heat pipe[J].CIESC Journal,2016,67(5):1852-1857.
[12] IVEY H J.Relationships between bubble frequency, departure diameter and rise velocity in nucleate boiling[J].International Journal of Heat & Mass Transfer,1967,10(8):1023-1040.
[13] YANG H H,XIAO S,GROLL M.Effect of thermo physical properties of working fluids on operational performance in pulsating heat pipes[J].Journal of Engineering Thermophysics,2010,31(1):97-99.
[14] SHAFⅡ M B,FAGHRI A,ZHANG Y W.Thermal modeling of unlooped and looped pulsating heat pipes[J].Journal of Heat Transfer,2001,123(6):1159-1172.
[15] KHANDEKAR S,SCHNEIDER M,SCHAFER P,et al.Dynamic study of flat plate closed loop pulsating heat pipe[J].Microscale Thermo Physical Engineering,2002,6(4):303-317.

工质表面张力和黏度对脉动热管启动及传热热阻的影响

Influence of surface tension and viscosity on the start-up time and thermal resistance of pulsating heat pipe

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	惠博, 侯宏艺, 张涛, 车生文. 圆柱形环状脉动热管烧干特性[J]. 化工进展, 2023, 42(S1): 33-40.
[2]	卜治丞, 焦波, 林海花, 孙洪源. 脉动热管计算流体力学模型与研究进展[J]. 化工进展, 2023, 42(8): 4167-4181.
[3]	陈蔚阳, 宋欣, 殷亚然, 张先明, 朱春英, 付涛涛, 马友光. 矩形微通道内液相黏度对气泡界面的作用机制[J]. 化工进展, 2023, 42(7): 3468-3477.
[4]	谢志伟, 吴张永, 朱启晨, 蒋佳骏, 梁天祥, 刘振阳. 植物油基Ni_0.5Zn_0.5Fe₂O₄磁流体的黏度特性及磁黏特性[J]. 化工进展, 2023, 42(7): 3623-3633.
[5]	孙征楠, 李洪晶, 荆国林, 张福宁, 颜飚, 刘晓燕. EVA及其改性聚合物在原油降凝剂领域的应用[J]. 化工进展, 2023, 42(6): 2987-2998.
[6]	高婷婷, 蒋振, 吴晓毅, 郝婷婷, 马学虎, 温荣福. 微乳液脉动热管应用于锂离子电池的散热性能[J]. 化工进展, 2023, 42(3): 1167-1177.
[7]	李光文, 华渠成, 黄作鑫, 达志坚. 聚甲基丙烯酸酯类黏度指数改进剂的研究进展[J]. 化工进展, 2023, 42(3): 1562-1571.
[8]	余俊声, 朱晔, 李乾坤, 徐士轩, 张昕阳, 汪城, 屈健. 升降热流条件下的脉动热管性能[J]. 化工进展, 2023, 42(3): 1178-1186.
[9]	朱启晨, 吴张永, 王志强, 蒋佳骏, 李翔. 低温下硅油基纳米磁流体沉降稳定性与黏度特性[J]. 化工进展, 2023, 42(10): 5101-5110.
[10]	李鲁, 鲍穗, 张李明, 汪然, 陶正红, 杨兴祥. 卡拉胶-魔芋胶复合凝胶基香精微胶囊的制备与表征[J]. 化工进展, 2022, 41(S1): 376-381.
[11]	杨洪海, 张苗, 刘利伟, 周屹, 沈俊杰, 施伟刚, 尹勇. 氧化石墨烯/水脉动热管传热强化及性能预测[J]. 化工进展, 2022, 41(4): 1725-1734.
[12]	崔文宇, 蒋振, 郝婷婷, 温荣福, 马学虎. 液态金属微液滴脉动热管的传热性能[J]. 化工进展, 2022, 41(1): 95-103.
[13]	陈萌, 李静静. 脉动热管用于电动汽车锂电池散热性能试验[J]. 化工进展, 2021, 40(6): 3163-3171.
[14]	胡波, 庞明军. 特征时间对剪切稀化流体气泡上浮特性的影响[J]. 化工进展, 2021, 40(5): 2440-2451.
[15]	刘铮, 刘燃, 花儿, 冀健龙. 水分含量对正己胺-Tf₂N型质子化离子液体物理化学性质的影响[J]. 化工进展, 2021, 40(4): 2270-2277.