化工进展 ›› 2024, Vol. 43 ›› Issue (3): 1157-1166.DOI: 10.16085/j.issn.1000-6613.2023-0420

• 化工过程与装备 • 上一篇    

聚丙烯酰胺对高黏油-水环状流流动特性的影响

尹晓云1,2(), 李静1,2, 林冬1,2, 胡金燕1,2, 张良1,2, 敬加强3,4(), KARIMOV Rinat M5, 孙杰3,4   

  1. 1.中国石油西南油气田分公司安全环保与技术监督研究院,四川 成都 610041
    2.页岩气评价与开采四川省重点实验室,四川 成都 610041
    3.西南石油大学石油与天然气工程学院,四川 成都 610500
    4.油气消防四川省重点实验室,四川 成都 611731
    5.Department of Transport and Storage of Oil and Gas,Ufa State Petroleum Technological University,Russia Ufa 450062
  • 收稿日期:2023-03-20 修回日期:2023-09-29 出版日期:2024-03-10 发布日期:2024-04-11
  • 通讯作者: 敬加强
  • 作者简介:尹晓云(1995—),女,博士,在站博士后,研究方向为油气集输多相流、油气田节能减排。E-mail:yinxy0122@163.com
  • 基金资助:
    国家自然科学基金(U19B2012);四川省自然科学基金(2023NSFSC0924)

Effect of polyacrylamide on flow characteristics of highly viscous oil-water annular flow

YIN Xiaoyun1,2(), LI Jing1,2, LIN Dong1,2, HU Jinyan1,2, ZHANG Liang1,2, JING Jiaqiang3,4(), KARIMOV Rinat M5, SUN Jie3,4   

  1. 1.Safety, Environment and Technology Supervision Research Institute of PetroChina Southwest Oil and Gas Field Company, Chengdu 610041, Sichuan, China
    2.Shale Gas Evaluation and Exploitation Key Laboratory of Sichuan Province, Chengdu 610041, Sichuan, China
    3.School of Oil & Natural Gas Engineering, Southwest Petroleum University, Chengdu 610500, Sichuan, China
    4.Oil & Gas Fire Protection Key Laboratory of Sichuan Province, Chengdu 611731, Sichuan, China
    5.Department of Transport and Storage of Oil and Gas, Ufa State Petroleum Technological University, Ufa 450062, Russia
  • Received:2023-03-20 Revised:2023-09-29 Online:2024-03-10 Published:2024-04-11
  • Contact: JING Jiaqiang

摘要:

针对稠油水环输送的水环流动改进问题,提出稠油流动边界层在聚丙烯酰胺(PAM)水环作用下的模拟实验方法,基于自主研发设计的室内油-水两相流可视化环道实验装置,采用500#白油模拟旅大稠油,实验研究了稠油-水环状流外环水相中添加PAM前后的流型特征与阻力特性,评价了PAM对水环润滑的协同减阻效果,分析了PAM对水环流动稳定性的作用机理。实验结果表明:PAM对稠油-水环状流的流型特征与阻力特性均有显著影响,使环状流的分布区域缩小,其缩减区域转变为分层流和塞状流,当其为分层流时减阻作用丧失;当油相表观流速为0.23~0.90m/s时,PAM减阻率随含水率增加先迅速增大后缓慢减小,在测试范围内最高达35%。研究结果可为稠油水环输送工艺优化提供理论指导和技术支持,也可为稠油管输流动改进提供新理念与新方法。

关键词: 聚丙烯酰胺, 油水环状流, 流型转变, 压力梯度, 减阻率

Abstract:

Aiming at the problem of flowability improvement of water annulus for heavy oil transportation in water ring, a simulation experiment method for heavy oil flow boundary layer under the action of water ring with anionic polyacrylamide (PAM) was proposed. On the basis of self-developed design of indoor visualization experimental loop device of heavy oil-water two-phase flow, taking 500# industrial white oil as simulated oil sample of Lyuda highly viscous oil, the flow regime characteristics and friction resistance properties of heavy oil-water annular flow before and after the addition of PAM in outer aqueous phase were investigated experimentally. The synergistic drag reduction effect of PAM on water ring lubrication was evaluated, and the mechanism of PAM on flow stability of water ring was analyzed. The experimental results showed that the presence of PAM had a significant effect on the flow pattern and resistance characteristics of heavy oil-water annular flow. After the addition of PAM, the region of annular flow reduced and changed to either stratified flow or plug flow, and when it transformed into stratified flow, the drag reduction effect of PAM was lost. As the oil superficial velocity varied from 0.23m/s to 0.90m/s, with the raise in water volume fraction, the drag reduction rate first increased rapidly and then decreased slowly. The maximum drag reduction rate in the test range reached 35%. The research results could provide a theoretical guidance and technical support for the technology optimization of heavy oil-water ring transportation, as well as a new concept and method for the flow improvement of heavy oil pipeline transportation.

Key words: polyacrylamide, oil-water annular flow, flow regime transition, pressure gradient, drag reduction rate

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn