化工进展 ›› 2017, Vol. 36 ›› Issue (12): 4371-4377.DOI: 10.16085/j.issn.1000-6613.2017-0625

• 化工过程与装备 • 上一篇    下一篇

旋流器的微米级颗粒分级性能分析

袁惠新1,2, 方勇1,2, 付双成1,2, 叶娟1,2, 方毅1,2   

  1. 1 常州大学机械工程学院, 江苏 常州 213164;
    2 常州大学江苏省绿色过程装备重点实验室, 江苏 常州 213164
  • 收稿日期:2017-04-11 修回日期:2017-05-22 出版日期:2017-12-05 发布日期:2017-12-05
  • 作者简介:袁惠新(1957-),博士,教授,博士生导师,主要研究方向为多相流与机械分离净化技术与设备。E-mail:yuanhuixin2016@163.com。

Analysis of the classification performance of micron particles with hydrocyclones

YUAN Huixin1,2, FANG Yong1,2, FU Shuangcheng1,2, YE Juan1,2, FANG Yi1,2   

  1. 1 School of Mechanical Engineering, Changzhou University, Changzhou 213164, Jiangsu, China;
    2 Jiangsu Key Laboratory of Green Process Equipment, Changzhou University, Changzhou 213164, Jiangsu, China
  • Received:2017-04-11 Revised:2017-05-22 Online:2017-12-05 Published:2017-12-05

摘要: 微型旋流器中的超重力场和剪切湍流场可以强化微米级颗粒的分级。为了分析旋流器的微米级颗粒分级性能,本文通过试验与数值模拟相结合的方法研究了入口速度和底流分率对旋流分级的影响。数值模拟方面使用雷诺应力模型模拟了微型旋流器内的流场,试验方面使用直径为20mm的微型旋流器来分级粒度分布为2~50μm的颗粒物料。结果表明,随着入口速度的增大,分割粒度x50减小,可达4.8μm,分级精度H提高,可达0.45;随着底流分率Rf的增大,不会显著改变切向和径向速度,颗粒在旋流器内的沉降速度变化不大,但轴向速度会减小,使得颗粒在旋流器内的停留时间增加,分级效率提高;当底流分率Rf < 0.6时,随着Rf的增大,分割粒度x50减小,可达4.7μm,分级精度H提高,可达0.6;当底流分率Rf > 0.6时,分割粒度x50增大,分级精度H降低。

关键词: 微型旋流器, 数值模拟, 粒度分布, 颗粒物料

Abstract: The high gravity field and turbulent shear field can strengthen the classification of micron particles in micro hydrocyclone. In order to analyze the classification performance of micron particles with hydrocyclones,the effect of inlet velocity and underflow ratio on hydrocyclone classification were studied by combination of experiment and numerical simulation. The Reynolds stress model was used to simulate the flow field of micro hydrocyclone in numerical simulation,the micro hydrocyclone of 20mm in diameter was used to classify granular materials whose particle size distribution was 2-50μm in the experiments. The results showed that with the increase of inlet velocity,the cut size x50 decreases,the x50 is 4.8μm,and the classification precision H increases,the H is 0.45. With the increase of underflow ratio Rf,the tangential and radial velocity are not significantly changed. The settling velocity of particles has no obvious change in the hydrocyclone,but the axial velocity will decrease,which makes the residence time of particles increase in the hydrocyclone. The classification efficiency improves. When underflow ratio Rf is less than 0.6,with the increase of Rf,the cut size x50 decreases. The x50 is 4.7μm and the classification precision H increases,the H is 0.6. When underflow ratio Rf is greater than 0.6,the cut size x50 increases,and the classification precision H decreases.

Key words: micro hydrocyclone, numerical simulation, particle size distribution, granular materials

中图分类号: 

版权所有 © 《化工进展》编辑部


本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn