Chemical Industry and Engineering Progress ›› 2024, Vol. 43 ›› Issue (6): 2950-2960.DOI: 10.16085/j.issn.1000-6613.2023-0771

• Chemical processes and equipment • Previous Articles    

Multi-objective optimal design of evaporative condenser using zeotropic working fluid

XIONG Yuanfan1,2(), LI Huashan1,2, GONG Yulie1,2()   

  1. 1.School of Energy Science and Engineering, University of Science and Technology of China, Guangzhou 510640, Guangdong, China
    2.Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, Guangzhou 510640, Guangdong, China
  • Received:2023-05-09 Revised:2023-06-21 Online:2024-07-02 Published:2024-06-15
  • Contact: GONG Yulie

非共沸工质蒸发式冷凝器多目标优化设计

熊远帆1,2(), 李华山1,2, 龚宇烈1,2()   

  1. 1.中国科学技术大学能源科学与技术学院,广东 广州 510640
    2.中国科学院广州能源研究所,广东 广州 510640
  • 通讯作者: 龚宇烈
  • 作者简介:熊远帆(1999—),男,硕士研究生,研究方向为中深层地热开发与利用。E-mail:jhxyf2021@mail.ustc.edu.cn
  • 基金资助:
    广东省基础与应用基础研究基金(2022A1515011210)

Abstract:

Applying evaporative condenser to zeotropic organic Rankine cycle can effectively improve the thermal economy of the system. After establishing the Kriging surrogate model of evaporative condenser, by taking the R601a component mass fraction, air flow rate and spray water flow rate flow as decision variables, and the heat exchange area and exergy efficiency as objective functions, analysis of influencing factors of the objective function was conducted, and multi-objective optimization was carried out using non-dominated sorting genetic algorithm and TOPSIS decision method. The results showed that in the analysis of influencing factors, the influence of air flow rate on the objective function was greater than that of spray water flow rate, and when the mass fraction of R601a was about 0.7, the heat exchange area had a minimum value and the exergy efficiency had a maximum value. In Pareto front, the mass fraction of R601a component had the best value range for the design of evaporative condenser, while the value range of air flow rate and spray water flow rate was wide, covering almost the whole range of variation. The scheme with low cost, small occupied space and high effective utilization of available energy was: R601a component mass fraction of 0.725, air flow rate of 81.017kg/s, spray water flow rate of 58.302kg/s, corresponding heat exchange area of 316.883m2, and exergy efficiency of 0.428.

Key words: evaporative condenser, zeotropic, surrogate model, multi-objective, optimal design

摘要:

将蒸发式冷凝器应用于非共沸有机朗肯循环可以有效提高系统的热经济性。建立了蒸发式冷凝器的Kriging代理模型,以R601a组分质量分数、空气流量、喷淋水流量作为决策变量,换热面积和㶲效率为目标函数,开展了目标函数的影响因素分析,并采用非支配排序遗传算法和TOPSIS决策法开展多目标优化。结果表明,影响因素分析中,空气流量对目标函数的影响程度比喷淋水流量更大,而R601a组分质量分数为0.7左右时,换热面积有最小值且㶲效率有最大值;Pareto前沿中,R601a组分质量分数对蒸发式冷凝器的设计存在最佳的取值范围,而空气流量、喷淋水流量的取值范围较广,几乎涵盖其整个变化范围。成本低、占用空间小且对可用能的有效利用程度大的方案为:R601a组分质量分数0.725,空气流量81.017kg/s,喷淋水流量58.302kg/s。对应的换热面积为316.883m2,㶲效率为0.428。

关键词: 蒸发式冷凝器, 非共沸, 代理模型, 多目标, 优化设计

CLC Number: 

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd