化工进展 ›› 2018, Vol. 37 ›› Issue (11): 4168-4173.DOI: 10.16085/j.issn.1000-6613.2018-0471

• 化工过程与装备 • 上一篇    下一篇

合成间甲基苯甲酸的微通道连续流工艺

程昊1,2, 严生虎1,2, 张跃2, 刘建武1,2, 张勇超1,2, 沈介发1,2, 陈代祥1,2, 魏进1,2   

  1. 1 常州大学制药与生命科学学院, 江苏 常州 213164;
    2 石油和化工行业连续流技术工程实验室, 江苏 常州 213164
  • 收稿日期:2018-03-08 修回日期:2018-07-06 出版日期:2018-11-05 发布日期:2018-11-05
  • 通讯作者: 严生虎,教授级高级工程师,硕士生导师,研究方向为流动合成化学、连续流工程与工艺。E-mail:ysh@cczu.edu.cn。
  • 作者简介:程昊(1991-),男,硕士研究生。

Microchannel continuous process for synthesis of m-methyl benzoic acid

CHENG Hao1,2, YAN Shenghu1,2, ZHANG Yue2, LIU Jianwu1,2, ZHANG Yongchao1,2, SHEN Jiefa1,2, CHEN Daixiang1,2, WEI Jin1,2   

  1. 1 School of Pharmaceutical and Life Sciences, Changzhou University, Changzhou 213164, Jiangsu, China;
    2 Continuous Flow Engineering Laboratory of National Petroleum and Chemical Industry, Changzhou 213164, Jiangsu, China
  • Received:2018-03-08 Revised:2018-07-06 Online:2018-11-05 Published:2018-11-05

摘要: 目前,对合成间甲基苯甲酸的研究主要局限于氧化釜的间歇反应工艺,对连续流反应工艺少有报道。针对这一问题,本文提出了在脉冲混合结构微通道反应器中液相氧化合成间甲基苯甲酸的连续流工艺。采用间二甲苯为原料,过氧乙酸为氧化剂,乙酸钴和溴化钠为催化剂,通过对反应物料比、催化剂的用量、反应停留时间、反应温度、溶剂用量等条件的考察,获得最佳工艺条件。得出当n(间二甲苯)∶n(过氧乙酸)∶n(乙酸钴)∶n(溴化钠)∶n(乙酸)=1∶4∶0.015∶0.02∶5、反应温度120℃、反应停留时间15min时,反应效果最佳。研究结果表明:此工艺充分利用微通道连续流反应器优良的传质传热特点,大大缩短了反应时间,提高了反应速率,扩大工艺条件选择区间,增加了安全系数,实现对氧化反应过程的有效控制。

关键词: 微通道反应器, 连续流, 氧化, 传质, 传热

Abstract: At present, the research on synthesis of m-methyl benzoic acid is mainly limited to the intermittent reaction process of the oxidation vessel, and there are few reports on the continuous flow reaction process. In response to this problem, a continuous flow process for the synthesis of m-methyl benzoic acid in liquid-phase oxidation in pulsed hybrid microchannel reactors was proposed. Using m-xylene as the raw material, peracetic acid as the oxidant, cobalt acetate and sodium bromide as catalysts. Through the inspection of the reaction material ratio, the amount of catalyst, the reaction residence time, the reaction temperature and the amount of solvent, etc, the optimum process conditions were obtained. When n(m-xylene):n(peracetic acid):n(cobalt acetate):n(sodium bromide):n(acetic acid)=1:4:0.015:0.02:5, reaction temperature at 120℃, the residence time at 15min, the reaction performance was the best. The results showed that this process takes full advantage of the excellent mass and heat transfer characteristics of the microchannel continuous flow reactor, greatly shortens the reaction time, increases the reaction rate, expands the selection range of the process conditions, increases the safety factor and realizes the effective control of the oxidation reaction process.

Key words: microchannel reactor, continuous flow process, oxidation, mass transfer, heat transfer

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn