化工进展 ›› 2015, Vol. 34 ›› Issue (02): 514-518.DOI: 10.16085/j.issn.1000-6613.2015.02.033

• 精细化工 • 上一篇    下一篇

1-甲基-2,4,5-三碘基咪唑的合成新工艺

冯璐璐, 王建龙, 张楠, 柳沛宏, 吴娜娜, 刘春花, 张迪   

  1. 中北大学化工与环境学院, 山西 太原 030051
  • 收稿日期:2014-05-26 修回日期:2014-07-06 出版日期:2015-02-05 发布日期:2015-02-05
  • 通讯作者: 王建龙,博士,教授,从事精细化学品和含能材料的合成。E-mail:wangjianlong@nuc.edu.com
  • 作者简介:冯璐璐(1988-),女,硕士研究生。E-mail:fenglulu728@sina.com

New process in the synthesis of 1-methyl-2,4,5-triiodoimidazole

FENG Lulu, WANG Jianlong, ZHANG Nan, LIU Peihong, WU Nana, LIU Chunhua, ZHANG Di   

  1. School of Chemical and Environmental Engineering, North University of China, Taiyuan 030051, Shanxi, China
  • Received:2014-05-26 Revised:2014-07-06 Online:2015-02-05 Published:2015-02-05

摘要: 为了改进1-甲基-2,4,5-三碘基咪唑(MTII)的合成路线,提高总得率,探索了其新的合成工艺。新工艺以N-甲基咪唑为原料,在CH3COOH/I2/HIO3体系中碘化,然后在丙酮/水中精制,得到MTII。对目标产物进行了红外光谱、质谱、核磁等分析,并推断了反应机理,同时讨论了加料顺序、物料比、反应时间及反应温度对目标物得率的影响。通过单因素实验得到正确的加料顺序和最佳的反应条件分别为:将碘溶解于冰乙酸中,碘酸溶解于稀硫酸中,使两种溶液均匀混合,随后再加入N-甲基咪唑和四氯化碳且n(碘酸)/n(N-甲基咪唑)=1.8,n(碘)/n(N-甲基咪唑)=1.7,反应温度为75℃,反应时间为2.5h。,最高得率为70%。相对于传统合成工艺而言,新工艺在合成路线、反应时间、总得率等方面具有显著优点,有更好的实际应用价值。

关键词: 炸药, N-甲基咪唑, 1-甲基-2,4,5-三硝基咪唑(MTNI), 中间体, 1-甲基-2,4,5-三碘基咪唑(MTII), 碘化, 炸药, N-甲基咪唑, 1-甲基-2,4,5-三硝基咪唑, 中间体, 1-甲基-2,4,5-三碘基咪唑, 碘化

Abstract: In order to improve the synthetic route of 1-methyl-2,4,5-triiodoimidazole (MTII) and increase the rate of it,a new synthetic process was explored. MTII was synthesized by using N-methylimidazole as starting material via iodination of CH3COOH/I2/HIO3 aqueous solution and then refined in acetone/water. The target product was characterized by IR,1H NMR,MS and elemental analysis. The mechanism of reaction was discussed and effects of charging sequence,material ratio, reaction temperature and reaction time on the yield of the title compound were investigated. Through single factor experiments,the optimum reaction condition was determined that the molar ratio of HIO3 and N-methylimidazole was 1.8:1,the molar ratio of I2 and N-methylimidazole was 1.7:1,the reaction temperature was 75℃,and the reaction time was 2.5h. The two solutions were mixed uniformly when I2 and HIO3 dissolved in acetic acid and dilute sulfuric acid respectively,then N-methylimidazole and CCl4 were put in the reaction liquid as the optimum feeding sequence obtained. The yield of the MTII was up to 70% under the above condition. The new synthetic process has significant advantages and a better practical application value than traditional synthetic process,such as synthetic route,reaction time,the yield and so on.

Key words: explosive, N-methylimidazole, 1-methyl-2,4,5-triiodoimidazole(MTNI), intermediate, 1-methyl-2,4,5-triiodoimidazole(MTII), iodination, explosive, N-methylimidazole, 1-methyl-2,4,5-trinitroimidazole(MTNI), intermediate, 1-methyl-2,4,5-triiodoimidazole(MTII), iodination

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn