化工进展 ›› 2017, Vol. 36 ›› Issue (08): 2962-2970.DOI: 10.16085/j.issn.1000-6613.2016-2247

• 工业催化 • 上一篇    下一篇

还原介质和还原温度对Ru-Zn催化苯选择加氢制环己烯性能的影响

孙海杰1, 陈凌霞1, 黄振旭1, 孙良玲1, 李永宇1, 刘寿长2, 刘仲毅2   

  1. 1. 郑州师范学院化学化工学院, 环境与催化工程研究所, 河南 郑州 450044;
    2. 郑州大学化学与分子工程学院, 河南 郑州 450001
  • 收稿日期:2016-12-05 修回日期:2017-02-28 出版日期:2017-08-05 发布日期:2017-08-05
  • 通讯作者: 李永宇,博士,副教授,主要研究方向为无机纳米材料。
  • 作者简介:孙海杰(1982-),男,博士,讲师。E-mail:sunhaijie406@zznu.edu.cn。
  • 基金资助:
    国家自然科学基金(21273205,21543011,U1304204)、河南省科技攻关项目(162102210333)、河南省高等学校重点科研项目(16A150025)及河南省高校科技创新团队支持计划(16IRTSTHN001)项目。

Effect of reduction medium and reduction temperature on the performance of Ru-Zn catalysts for selective hydrogenation of benzene to cyclohexene

SUN Haijie1, CHEN Lingxia1, HUANG Zhengxu1, SUN Liangling1, LI Yongyu1, LIU Shouchang2, LIU Zhongyi2   

  1. 1. Institute of Environmental and Catalytic Engineering, Department of Chemistry, Zhengzhou Normal University, Zhengzhou 450044, Henan, China;
    2. College of Chemistry and Molecular Engineering, Zhengzhou University, Zhengzhou 450001, Henan, China
  • Received:2016-12-05 Revised:2017-02-28 Online:2017-08-05 Published:2017-08-05

摘要: 用共沉淀法分别在5% NaOH溶液、蒸馏水、0.035mol/L ZnSO4溶液和0.145mol/L ZnSO4溶液中用H2还原制备了Ru-Zn(5% NaOH)催化剂、Ru-Zn(H2O)催化剂、Ru-Zn(0.035mol/L ZnSO4)催化剂和Ru-Zn(0.145mol/L ZnSO4)催化剂。结果表明,它们催化苯选择加氢制环己烯的活性高低顺序为Ru-Zn(5% NaOH)催化剂 > Ru-Zn(H2O)催化剂 > Ru-Zn(0.035mol/L ZnSO4)催化剂≈Ru-Zn(0.145mol/L ZnSO4)催化剂,环己烯选择性高低顺序与活性顺序正好相反。因为还原介质可以影响Ru-Zn催化剂的组成和织构性质,进而影响它的催化性能。Ru-Zn(H2O)催化剂的环己烯收率最高,说明蒸馏水作还原介质最好。随还原温度升高,Ru-Zn(H2O)催化剂比表面积逐渐减小,催化剂活性逐渐降低。同时粒径逐渐增大,Ru粒子上有利于环己烯加氢生成环己烷的楞位和顶点位减少,环己烯选择性升高。在100℃还原温度下制备的Ru-Zn(H2O)催化剂的环己烯收率可达58.1%。

关键词: 苯, 加氢, 环己烯, 催化剂, 钌,

Abstract: The catalysts of Ru-Zn(5%NaOH),Ru-Zn(H2O),Ru-Zn(0.035mol/L ZnSO4) and Ru-Zn(0.145mol/L ZnSO4) were prepared by H2 reduction in 5% NaOH,distilled water,0.035mol/L ZnSO4 and 0.145mol/L ZnSO4 using a co-precipitation method. The activities of the catalysts for selective hydrogenation of benzene to cyclohexene were in the order of:Ru-Zn(5%NaOH) > Ru-Zn(H2O) > Ru-Zn(0.035mol/L ZnSO4)≈Ru-Zn(0.145mol/L ZnSO4),but their selectivities to cyclohexene were in the inverse order. The reason is that the reduction media could influence the composition and texture properties of the Ru-Zn catalysts,and further affects their catalytic performance. The Ru-Zn(H2O) catalyst gave the highest cyclohexene yield among these catalysts,suggesting that the distilled water was the best reduction medium. The specific surface of Ru-Zn(H2O) catalysts decreased with the increase of the reduction temperature,and the activity of the catalysts was lowered. Meanwhile,the particle sizes of the Ru-Zn catalysts increased resulting in the decrease of numbers of the corner sites and the edge sites on the catalysts suitable for hydrogenation of cyclohexene to cyclohexane. Thus the selectivity to cyclohexene increased with the increase of the reduction temperature. The Ru-Zn(H2O) catalyst reduced at 100℃ gave a cyclohexene yield of 58.1%.

Key words: benzene, hydrogenation, cyclohexene, catalyst, ruthenium, zinc

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn