化工进展 ›› 2022, Vol. 41 ›› Issue (7): 3564-3572.DOI: 10.16085/j.issn.1000-6613.2021-1626

• 能源加工与技术 • 上一篇    下一篇

热电联产机组热电解耦技术对比分析

王子杰1(), 顾煜炯1,2(), 刘浩晨1, 李长耘1   

  1. 1.华北电力大学能源动力与机械工程学院,北京 102206
    2.华北电力大学国家火力发电工程技术研究中心,北京 102206
  • 收稿日期:2021-08-02 修回日期:2021-11-01 出版日期:2022-07-25 发布日期:2022-07-23
  • 通讯作者: 顾煜炯
  • 作者简介:王子杰(1992—),男,博士研究生,研究方向为火电厂机组灵活性改造。E-mail:wzjncepu@163.com
  • 基金资助:
    北京市自然科学基金(3172031)

Comparison and analysis of heat-power decoupling technologies for CHP units

WANG Zijie1(), GU Yujiong1,2(), LIU Haochen1, LI Changyun1   

  1. 1.School of Energy Power and Mechanical Engineering, North China Electric Power University, Beijing 102206, China
    2.National Thermal Power Engineering Technology Research Center, North China Electric Power University, Beijing 102206, China
  • Received:2021-08-02 Revised:2021-11-01 Online:2022-07-25 Published:2022-07-23
  • Contact: GU Yujiong

摘要:

增加热电联产机组运行的灵活性可以提高可再生能源利用率,减小“弃风”和“弃光”率,然而对于灵活性改造技术的对比分析研究相对较少。本文基于Ebsilon建立了600MW案例机组的热力学模型,采用Matlab调用模拟数据构建了该机组的能耗模型。基于此模型对比分析了热泵、电锅炉、蓄热罐及采用汽轮机本体改造等热电解耦技术对机组供热可行域及可行域内机组热力性能的影响规律。研究结果表明,采用热电解耦技术可以扩大机组的供热可行域,当机组热负荷为500MW时,采用热电解耦技术后,机组最小调峰能力由大到小排列为:电锅炉>低压缸光轴运行>低压缸零出力>压缩式热泵>蓄热罐。但电锅炉的能量利用率与?效率在所有热电解耦技术中最低。综合对比分析,在热电联产机组中采用压缩式热泵或热泵与蓄热罐耦合运行是一种节能的热电解耦方式。

关键词: 热电联产, 热电解耦技术, 解耦能力, 能量利用率, ?效率

Abstract:

Increasing the flexibility of combined heat and power (CHP) unit operation can improve the utilization rate of renewable energy and reduce the "abandoned wind energy" and "abandoned solar energy". However, there have been few comparison and analysis studies of the flexible modification techniques. In this paper, Ebsilon software was used to establish thermodynamic model of a 600MW unit, and an associated energy consumption model was established by passing simulation results to a Matlab routine. The influence of heat-power decoupling technologies, such as heat pump, electric boiler, heat storage tank, and steam turbine retrofit technologies on the operation feasible region and thermodynamic performance within the operation feasible region was analyzed using thermodynamic and energy consumption models. The results showed that the heat-power decoupling technologies can expand the operation feasible region of the unit. When heat load of the unit was 500MW, minimum peaking capability of the unit can be ranked from the largest to the smallest after using the heat-power decoupling technologies: electric boiler>bladeless shaft operation of low pressure cylinder>low pressure cylinder near zero output>compression heat pump>heat storage tank. However, energy and exergy efficiency of electric boiler were the lowest among all heat-power decoupling technologies. After analysis, it is an energy-saving decoupling way to use compression heat pump or compression heat pump coupled with heat storage tank in CHP units.

Key words: combined heat and power (CHP), heat-power decoupling technologies, decoupling ability, energy efficiency, exergy efficiency

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn