乙醇溶液液滴降压蒸发过程传热传质特性

doi:10.16085/j.issn.1000-6613.2016.03.010

化工进展 ›› 2016, Vol. 35 ›› Issue (03): 717-721.DOI: 10.16085/j.issn.1000-6613.2016.03.010

乙醇溶液液滴降压蒸发过程传热传质特性

王茉, 刘璐, 王鹏程, 米梦龙, 刘彦丰

华北电力大学能源动力与机械工程学院, 河北保定 071003

收稿日期:2015-09-14 修回日期:2015-10-10 出版日期:2016-03-05 发布日期:2016-03-05
通讯作者: 刘璐,讲师,研究方向为相变传热传质。E-mail:122446254@qq.com.
作者简介:王茉(1990-),女,硕士研究生。
基金资助:
国家自然科学基金(51406055)、河北省自然科学基金(E2012502069)及中央高校基本科研业务费专项资金项目(2014MS106).

Heat and mass transfer characteristics of an ethanol solution droplet during depressurized evaporation process

WANG Mo, LIU Lu, WANG Pengcheng, MI Menglong, LIU Yanfeng

School of Energy Power and Mechanical Engineering, North China Electric Power University, Baoding 071003, Hebei, China

Received:2015-09-14 Revised:2015-10-10 Online:2016-03-05 Published:2016-03-05

摘要/Abstract

摘要： 针对单个乙醇溶液液滴在降压环境下蒸发的传热传质过程建立了数学模型。模型基于液相的能量守恒和传质扩散理论,利用经典拓展模型计算液滴的质量蒸发率,并引入活度系数考虑液滴表面的蒸气分压。采用液滴悬挂法进行实验,分别记录了乙醇溶液液滴和乙酸溶液液滴在降压蒸发过程中的液滴内温度变化。将实验数据与计算结果对比,验证了模型的有效性。通过模型计算获得了液滴内部温度分布以及浓度分布随时间的变化。结果表明:快速降压阶段空气流动较快,加之乙醇工质易挥发,液滴表面温度下降迅速,液滴内部温差和乙醇浓度梯度较大;压力稳定后,空气流速为零,液滴内部温差和乙醇浓度梯度逐渐减小。由于液滴内部的热扩散速率大于传质扩散系数,内部温度随时间的变化比浓度随时间的变化更快。

关键词: 液滴, 蒸发, 传热, 传质, 数值模拟

Abstract: A mathematical model was constructed to simulate the temperature change and the concentration variation of a single ethanol solution droplet during depressurized evaporation. The present model was based on energy conservation in liquid phase,as well as the species diffusion in liquid phase. Film model was used to calculate the droplet evaporation rate. The activity coefficient was introduced to calculate the partial vapour pressure at the droplet surface. Using the droplet suspension method,the droplet temperatures during depressurized evaporation of ethanol solution droplets and acetic acid solution droplets were recorded,respectively. The present model was verified by comparing the numerical results with the experimental data. By numerical calculations,the variations of temperature and concentration profile within a droplet were discussed. Results showed that during the fast pressure dropping stage,the droplet evaporation rate was rapid due to the strong air flow,leading to a fairly large temperature difference inside the droplet. The concentration gradient inside the droplet was also very great. When the ambient pressure maintained constant,the temperature difference inside the droplet diminished gradually,and the concentration gradient within the droplet was also decreased. Because the thermal diffusivity is greater than the mass transfer coefficient,the droplet internal temperature change with time is faster than the concentration change versus time.

Key words: droplet, evaporation, heat transfer, mass transfer, numerical simulation

中图分类号:

TK121

王茉, 刘璐, 王鹏程, 米梦龙, 刘彦丰. 乙醇溶液液滴降压蒸发过程传热传质特性[J]. 化工进展, 2016, 35(03): 717-721.

WANG Mo, LIU Lu, WANG Pengcheng, MI Menglong, LIU Yanfeng. Heat and mass transfer characteristics of an ethanol solution droplet during depressurized evaporation process[J]. Chemical Industry and Engineering Progree, 2016, 35(03): 717-721.

参考文献

[1] OWEN I,JALIL J M. Heterogeneous flashing in water drops[J]. International Journal of Multiphase Flow,1991,17(5):653-660.

[2] SATOH I,FUSHINOBU K,HASHIMOTO Y. Freezing of a water droplet due to evaporation-heat transfer dominating the evaporationfreezing phenomena and the effect of boiling on freezing characteristics[J]. International Journal of Refrigeration,2002,25 (2):226-234.

[3] 刘伟民,毕勤成,刘璐,等. 低压闪蒸液滴形态和温度变化的研究[J]. 工程热物理学报,2007,28(6):957-960.

[4] SHIN H T,LEE Y P,JURNG J. Spherical-shaped ice particle production by spraying water in vacuum chamber[J]. Applied Thermal Engineering,2000,20(5):439-454.

[5] KIM B S,SHIN H T,LEE Y P,et al. Study on ice slurry production by water spray[J]. International Journal of Refrigeration, 2001,24(2):176-184.

[6] 章学来,王为,李志伟,等. 静止水滴真空闪蒸模型及实验研究[J]. 工程热物理学报,2012,33(8):1419-1422.

[7] 骆骞,毕勤成,韩彦宁,等. 盐水液滴降压环境下蒸发过程[J]. 化工学报,2013,64(6):2001-2006.

[8] 高文忠,时亚茹,韩笑生,等. 混合除湿盐溶液液滴闪蒸机理[J]. 化工学报,2012,63(11):3453-3459.

[9] 刘伟民. 真空闪蒸过程中换热与流动机理的研究[D]. 西安:西安交通大学,2006.

[10] MUTHUNAYAGAM A E,RAMAMURTHI K R,PADEN J R. Modelling and experiments on vaporization of saline water at low temperatures and reduced pressures[J]. Applied Thermal Engineering,2005,25(5/6):941-952.

[11] LIU L,MI M L. Theoretical investigation on rapid evaporation of a saline droplet during depressurization[J]. Microgravity Science and Technology,2014,25:295-302.

[12] 刘璐,王茉,刘琰,等. 盐水液滴降压蒸发析盐过程传热传质特性研究[J]. 化工学报,2015,66(7):2426-2432.

[13] 刘璐,舒盼盼,王茉,等. 盐水液滴降压蒸发析盐过程数值模拟研究[J]. 化工进展,2015,34(1):49-53.

[14] SAZHIN S S,ELWARDANY A,KRUTITSKII P A,et al. A simplified model for bi-component droplet heating and evaporation[J]. International Journal of Heat and Mass Transfer,2010,53(21/22): 4495-4505.

[15] MAQUA C,CASTANET G,LEMOINE F. Bicomponent droplets evaporation:temperature measurements and modelling[J]. Fuel, 2008,87:2932-2942.

[16] YARIN A L , BRENN G , RENSINK D. Evaporation of acoustically levitated droplets of binary liquid mixtures[J]. International Journal of Heat and Fluid Flow,2002,23:471-486.

[17] 田章福,陶玉静,苏凌宇,等. 多组分液滴蒸发过程的理论模型及试验研究[J]. 推进技术,2006,27(6):568-571.

[18] ABRAMZON B,SIRIGNANO W A. Droplet vaporization model for spray combustion calculations[J]. International Journal of Heat and Mass Transfer,1989,32:1605-1618.

乙醇溶液液滴降压蒸发过程传热传质特性

Heat and mass transfer characteristics of an ethanol solution droplet during depressurized evaporation process

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	肖辉, 张显均, 兰治科, 王苏豪, 王盛. 液态金属绕流管束流动传热进展[J]. 化工进展, 2023, 42(S1): 10-20.
[2]	王太, 苏硕, 李晟瑞, 马小龙, 刘春涛. 交流电场中贴壁气泡的动力学行为[J]. 化工进展, 2023, 42(S1): 133-141.
[3]	盛维武, 程永攀, 陈强, 李小婷, 魏嘉, 李琳鸽, 陈险峰. 微气泡和微液滴双强化脱硫反应器操作分析[J]. 化工进展, 2023, 42(S1): 142-147.
[4]	赵晨, 苗天泽, 张朝阳, 洪芳军, 汪大海. 负压状态窄缝通道乙二醇水溶液传热特性[J]. 化工进展, 2023, 42(S1): 148-157.
[5]	黄益平, 李婷, 郑龙云, 戚傲, 陈政霖, 史天昊, 张新宇, 郭凯, 胡猛, 倪泽雨, 刘辉, 夏苗, 主凯, 刘春江. 三级环流反应器中气液流动与传质规律[J]. 化工进展, 2023, 42(S1): 175-188.
[6]	杨寒月, 孔令真, 陈家庆, 孙欢, 宋家恺, 王思诚, 孔标. 微气泡型下向流管式气液接触器脱碳性能[J]. 化工进展, 2023, 42(S1): 197-204.
[7]	陈匡胤, 李蕊兰, 童杨, 沈建华. 质子交换膜燃料电池气体扩散层结构与设计研究进展[J]. 化工进展, 2023, 42(S1): 246-259.
[8]	郭强, 赵文凯, 肖永厚. 增强流体扰动强化变压吸附甲硫醚/氮气分离的数值模拟[J]. 化工进展, 2023, 42(S1): 64-72.
[9]	邵博识, 谭宏博. 锯齿波纹板对挥发性有机物低温脱除过程强化模拟分析[J]. 化工进展, 2023, 42(S1): 84-93.
[10]	陈林, 徐培渊, 张晓慧, 陈杰, 徐振军, 陈嘉祥, 密晓光, 冯永昌, 梅德清. 液化天然气绕管式换热器壳侧混合工质流动及传热特性[J]. 化工进展, 2023, 42(9): 4496-4503.
[11]	刘炫麟, 王驿凯, 戴苏洲, 殷勇高. 热泵中氨基甲酸铵分解反应特性及反应器结构优化[J]. 化工进展, 2023, 42(9): 4522-4530.
[12]	赵曦, 马浩然, 李平, 黄爱玲. 错位碰撞型微混合器混合性能的模拟分析与优化设计[J]. 化工进展, 2023, 42(9): 4559-4572.
[13]	卜治丞, 焦波, 林海花, 孙洪源. 脉动热管计算流体力学模型与研究进展[J]. 化工进展, 2023, 42(8): 4167-4181.
[14]	汪健生, 张辉鹏, 刘雪玲, 傅煜郭, 朱剑啸. 多孔介质结构对储层内流动和换热特性的影响[J]. 化工进展, 2023, 42(8): 4212-4220.
[15]	王云刚, 焦健, 邓世丰, 赵钦新, 邵怀爽. 冷凝换热与协同脱硫性能实验分析[J]. 化工进展, 2023, 42(8): 4230-4237.