化工进展 ›› 2015, Vol. 34 ›› Issue (12): 4375-4378,4397.DOI: 10.16085/j.issn.1000-6613.2015.12.040

• 资源与环境化工 • 上一篇    下一篇

碱化度对聚合氯化铝混凝除硅的影响

赵晓非1, 张晓阳1, 杨腾飞1, 范蕾1, 王顺武1, 于庆龙2   

  1. 1 东北石油大学化学化工学院石油与天然气化工省重点实验室, 黑龙江 大庆 163318;
    2 大庆油田有限责任 公司第四采油厂试验大队试验一队, 黑龙江 大庆 163511
  • 收稿日期:2015-06-05 修回日期:2015-06-24 出版日期:2015-12-05 发布日期:2015-12-05
  • 通讯作者: 赵晓非(1967—),男,教授,主要从事油田化学添加剂的开发及现场应用。E-maildqpifxz@163.com。
  • 作者简介:赵晓非(1967—),男,教授,主要从事油田化学添加剂的开发及现场应用。E-maildqpifxz@163.com。
  • 基金资助:
    黑龙江省教育厅科学技术研究项目(12531061)。

Influence of basicity of polyaluminum chloride on removal of silicon

ZHAO Xiaofei1, ZHANG Xiaoyang1, YANG Tengfei1, FAN Lei1, WANG Shunwu1, YU Qinglong2   

  1. 1 Provincial Key Laboratory of Oil & Gas Chemical Technology, School of Chemistry & Chemical Engineering, Northeast Petroleum University, Daqing 163318, Heilongjiang, China;
    2 The Fourth Production Experiment Group Team of Daqing Oilfield Company Ltd., Daqing 163511, Heilongjiang, China
  • Received:2015-06-05 Revised:2015-06-24 Online:2015-12-05 Published:2015-12-05

摘要: 通过对实验室现有工业级聚合氯化铝进行碱化度分析,向多个化学试剂厂调研得出,现场常用聚合氯化铝的碱化度在1.5~2.7之间。通过合成不同碱化度(2.0~2.4)的聚合氯化铝,对模拟成垢水进行系统的混凝实验,考察碱化度对聚合氯化铝混凝除硅的影响。研究表明,碱化度会决定铝形态的分布,进而影响混凝除硅的效果。随着碱化度的升高,Ala含量逐渐降低,Alb含量先增大后减小,Alc含量逐渐增加。对模拟污水处理后,残余硅酸形态有很大差异,用聚合氯化铝(2.0)除硅后Sia含量变为32.1mg/L,Sic含量变为15.3mg/L;聚合氯化铝(2.2)除硅后Sia含量变为28.71mg/L,Sic含量变为30.5mg/L;聚合氯化铝(2.4)除硅后Sia含量变为22.4mg/L,Sic含量变为41.2mg/L。聚合氯化铝(2.0)除硅后Sia降低的比例最大,聚合氯化铝(2.4)除硅后Sic降低的比例最大。随着碱化度的升高,全硅剩余含量依次为47.4mg/L、59.5mg/L、63.6mg/L,表明碱化度越低,除硅效果越好。

关键词: 聚合氯化铝, 碱化度, 铝形态, 硅形态, 混凝除硅

Abstract: By analyzing the alkalization degree of existing industrial-grade polymeric aluminum chloride in the laboratory and investigating several chemical reagent factories,we obtained that the alkalization degree of polymeric aluminum chloride commonly used on site is between 1.5—2.7. By synthesizing polymeric aluminum chloride with different alkalization degrees (2.0—2.4),we conducted a systematic coagulation experiment on the simulation of scale-forming water,and investigated the influence of alkalization degree on the coagulation silica removal of polymeric aluminum chloride. The results show that the alkalization degree will determine the distribution of aluminum speciation and therefore influence the effect of coagulation silicon removal. As the alkalization degree increases,the content of Ala gradually decreases,the content of Alb first increases and then decreases,while the content of Alc gradually increases. After simulation of wastewater treatment,the residual silicate speciation is largely different. After silicon removal of polymeric aluminum chloride (2.0),the content of Sia changes to 32.1mg/L,and the content of Sic changes to 15.3mg/L;after silicon removal of polymeric aluminum chloride (2.2),the content of Sia changes to 28.71mg/L,and the content of Sic changes to 30.5mg/L;after silicon removal of polymeric aluminum chloride (2.4),the content of Sia changes to 22.4mg/L,and the content of Sic changes to 41.2mg/L. The proportion in the decrease of Sia is the largest after silicon removal of polymeric aluminum chloride (2.0),and the proportion in the decrease of Sic is the largest after silicon removal of polymeric aluminum chloride (2.4). With the increase of alkalization degree,the total residual silicon contents are respectively 47.4mg/L,59.5mg/L and 63.6mg/L. Within the author's scope of research,the lower the alkalization degree,the better the effect of silica removal.

Key words: polyaluminum chloride, basicity, aluminum speciation, silicon speciation, coagulation for silica removal

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn