Chemical Industry and Engineering Progress ›› 2025, Vol. 44 ›› Issue (8): 4526-4535.DOI: 10.16085/j.issn.1000-6613.2025-0183

• Reactors and process equipment modeling and simulation • Previous Articles    

Drag/lift coefficients of flow around two circular cylinders at low Reynolds numbers and high Knudsen numbers

LONG Kai1,2(), CHEN Feiguo2(), XIONG Qingang1()   

  1. 1.School of Light Industry and Engineering, South China University of Technology, Guangzhou 510641, Guangdong, China
    2.State Key Laboratory of Mesoscience and Engineering, Institute of Process Engineering, Chinese Academy of Sciences, Beijing 100190, China
  • Received:2025-02-10 Revised:2025-03-02 Online:2025-09-08 Published:2025-08-25
  • Contact: CHEN Feiguo, XIONG Qingang

低雷诺数高克努森数下的双圆柱绕流阻力/升力系数

龙凯1,2(), 陈飞国2(), 熊勤钢1()   

  1. 1.华南理工大学轻工科学与工程学院,广东 广州 510641
    2.中国科学院过程工程研究所,介科学与工程全国 重点实验室,北京 100190
  • 通讯作者: 陈飞国,熊勤钢
  • 作者简介:龙凯(2000—),男,硕士研究生,研究方向为流体力学模拟。E-mail:klong@ipe.ac.cn
  • 基金资助:
    国家自然科学基金(22478390);广东省自然科学基金(2023A1515011419)

Abstract:

Flow around two cylinders is a fundamental model for a deep understanding of the flow around complex structures, which has been extensively studied by numerous researchers, yet scarcely touches upon the flow at low Reynolds numbers and high Knudsen numbers. In this study, pseudo-particle modeling was employed to simulate the drag and lift forces on the flow around two circular cylinders in both side-by-side and tandem arrangements under the conditions of 0.5≤Re≤5 and 0.1≤Kn≤1.5. The results were as follows: for side-by-side cylinders, the drag coefficient increased with the increase of the distance between them, and once the distance exceeded a critical value, the drag coefficient approached that of the flow around a single cylinder. This critical value decreased with the increase of Re and was independent of Kn; the lift coefficient initially increased and then gradually decreased to zero as the distance widened, with the peak value corresponding distance influenced by both Re and Kn. The minimum distance required for the lift coefficient to approach zero decreased with the increase of Re and Kn. For tandem cylinders, the drag coefficients of both the upstream and downstream cylinders decreased; the drag coefficient of the upstream cylinder first decreased and then increased with the widening of the distance; the drag coefficient of the downstream cylinder increased with the distance and was significantly affected by the upstream cylinder, which was consistent with the situation in the continuous flow region; Kn affected the distance at which the upstream cylinder influenced the downstream cylinder, as the smaller the Kn, the greater the interference distance.

Key words: fluid mechanics, computer simulation, microfluidics, flow around two cylinders, low Reynolds number, high Knudsen number

摘要:

双圆柱绕流是深入理解复杂结构周围流动的基础模型,已有众多研究者进行了广泛研究,但鲜有涉及低雷诺数高克努森数的流动。本文采用拟颗粒模型,模拟研究0.5≤Re≤5和0.1≤Kn≤1.5条件下,并排及串排双圆柱绕流的阻力及升力情况。研究发现,圆柱并排时,阻力系数随间距增大而增大,并在间距超过临界值后,阻力系数接近单圆柱绕流结果,该临界值随Re增大而减小且与Kn无关;升力系数随间距增大先增大再逐渐减小趋于0,峰值所对应的间距受ReKn的影响,升力系数趋于0所需的最小间距随ReKn的增大而减小。圆柱串排时,上下游圆柱阻力系数均会降低;上游圆柱阻力系数随间距增大先减小后增大;下游圆柱阻力系数随间距增大而增大,且受上游圆柱影响明显,与连续流区域情况相符;Kn会影响上游圆柱对下游圆柱产生干扰的距离,表现为Kn越小,干扰距离越大。

关键词: 流体力学, 计算机模拟, 微流体, 双圆柱绕流, 低雷诺数, 高克努森数

CLC Number: 

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd