化工进展 ›› 2019, Vol. 38 ›› Issue (04): 1947-1952.DOI: 10.16085/j.issn.1000-6613.2018-1377

• 精细化工 • 上一篇    下一篇

氨基甲酸酯基丙烯酸酯的合成及其光固化性能

邹建军,鲁婷,王家喜()   

  1. 河北工业大学化工学院,天津300130
  • 收稿日期:2018-07-04 修回日期:2018-08-24 出版日期:2019-04-05 发布日期:2019-04-05
  • 通讯作者: 王家喜
  • 作者简介:<named-content content-type="corresp-name">邹建军</named-content>(1993—),男,硕士研究生。|王家喜,教授,博士生导师,主要从事功能高分子材料及其应用研究。E-mail:<email>wangjiaxi@hebut.edu.cn</email>。

Syntheses and UV curing properties of urethane acrylates

ZOU Jianjun,LU Ting,WANG Jiaxi()   

  1. School of Chemical Engineering and Technology, Hebei University of Technology, Tianjin 300130, China
  • Received:2018-07-04 Revised:2018-08-24 Online:2019-04-05 Published:2019-04-05
  • Contact: WANG Jiaxi

摘要:

利用碳酸亚乙酯与1,6-己二胺、异佛尔酮二胺反应,制备出两种含氨基甲酸酯基的二元醇,基于氨基甲酸酯二元醇与1,6-己二醇二丙烯酸酯(HDDA)、新戊二醇二丙烯酸酯(NPGDA)及三羟甲基丙烷三丙烯酸酯(TMPTA)本体条件下的Oxa-Michael加成反应及酯交换反应,合成出6种含氨基甲酸酯基的丙烯酸酯混合物。利用FTIR及高分辨质谱分析了产物结构,用FTIR考察了所合成氨基甲酸酯基丙烯酸酯光固化过程的动力学,测定了光固化膜的性能。结果表明,在含占总质量分数3% 的2-羟基-2-甲基-1-苯基-1-丙酮(1173)光引发剂的引发下,氨基甲酸酯基丙烯酸酯能在30s内固化形成表面平整、柔韧性(0.5~2.5mm)良好、透明或半透明的膜;固化膜的凝胶率及铅笔硬度分别为92%~96%、4~5H,对玻璃的附着力为0~1级。

关键词: UV光固化, Oxa-Michael加成, 酯交换, 氨基甲酸酯丙烯酸酯, 聚合, 动力学,

Abstract:

Ethylene carbonate reacted with 1,6-hexanediamine and isophoronediamine to produce two carbamate diols, respectively. Six different urethane acrylate mixtures were obtained by the reaction of those carbamate diols with 1,6-hexanediol diacrylate(HDDA),neopentyl glycol diacrylate (NPGDA) and trimethylolpropane triacrylate (TMPTA) in the absence of solvent through Oxa-Michael addition and transesterification. The structure of the reaction products was investigated by FTIR and high resolution mass spectrometry,and the UV curing kinetics of the synthesized urethane acrylates was studied by FTIR. The properties of cured film were evaluated. The results showed that the urethane acrylate resin could be UV cured within 30s under promotion of initiated by 3% (total mass fraction) of 2-hydroxy-2-methyl-1-phenylpropan-1-one(1173)under irradiation of UV light,forming to form a smooth, transparent or translucent film with good flexibility (0.5—2.5mm). The gelation rate and the pencil hardness of the film was 92%—96% and 4—5H,respectively. The adhesion of film to the glass was 0—1 level.

Key words: UV curing, Oxa-Michael addition, transesterification, urethane acrylate, polymerization, kinetics, film

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn