进水流量对新型储热水箱分层特性影响的实验研究

doi:10.16085/j.issn.1000-6613.2016.02.010

化工进展 ›› 2016, Vol. 35 ›› Issue (02): 403-408.DOI: 10.16085/j.issn.1000-6613.2016.02.010

进水流量对新型储热水箱分层特性影响的实验研究

王崇愿¹, 王子龙¹, 张华¹, 车敏²

1 上海理工大学制冷及低温工程研究所, 上海 200093;
2 海尔集团技术研发中心, 山东青岛 266103

收稿日期:2015-08-17 修回日期:2015-09-05 出版日期:2016-02-05 发布日期:2016-02-05
通讯作者: 王子龙,讲师,主要从事太阳能高聚光电池的冷却及相关技术方面的研究。E-mail:usst_wzl@163.com。
作者简介:王崇愿(1988-),男,硕士研究生,研究内容为太阳能及热泵热水器储热水箱。

An experimental analysis of inlet flow rate influence on stratification characteristics of a new water storage tank

WANG Chongyuan¹, WANG Zilong¹, ZHANG Hua¹, CHE Min²

1 Institute of Refrigeration and Cryogenics, University of Shanghai for Science and Technology, Shanghai 200093, China;
2 Technology R&D Center, Haier Group, Qingdao 266103, Shandong, China

Received:2015-08-17 Revised:2015-09-05 Online:2016-02-05 Published:2016-02-05

摘要/Abstract

摘要： 储热水箱被广泛使用在太阳能集热系统以及家用电加热热水器中,是决定集热系统和热水器性能的关键因素之一,储热水箱分层效果越好,越能提高集热系统效率及热水器的热水出水量。本文设计了一种新型均流器,安装在圆柱形储热水箱底部,并搭建了一套储热水箱分层特性测试实验台。在初始水温50℃、进水温度20℃的工况下,分析对比了3组不同流量(0.69L/min、2.14L/min、6.17L/min)时储热水箱的分层特性,结果显示,大流量比小流量温度曲线的斜率更大,温度下降速度更快。同时,基于热力学定律,分别计算了3组流量水箱的取出效率、用能效率、出于能量品质的考虑而采用的(火用)效率,在流量为0.69L/min、2.14L/min、6.17L/min时的取出效率分别为91.8%、95.7%、94.3%,用能效率分别为96.6%、98.6%、97.5%、(火用)效率分别为78.5%、83.1%、77.0%。

关键词: 储热水箱, 分层, 效率, ?, 流动, 热力学

Abstract: Water storage tank is widely applied in solar heating systems and domestic electrical water heaters. It is one of the key points which determine the performance of the system and the heater. A better stratification can improve the efficiency of solar heating system and the discharge amount of hot water in electrical water heaters. A new stratifier was designed and installed at the bottom of a cylindrical water storage tank. The test rig was established to measure the stratification characteristics of the tank. The initial temperature of the water in the tank is 50℃,the inlet temperature of the water is 20℃,the flow rate is 0.69L/min,2.14L/min,6.17L/min,respectively. The results showed that,when the larger the flow rate is,the larger is the slope of the sudden change in temperature curves,and the speed of temperature decrease is faster. Based on the thermodynamic laws,extraction efficiency,discharge efficiency and exergy efficiency were used to describe the stratification characteristics of the tank. The results showed that,when the flow rate is 0.69L/min,2.14L/min,6.17L/min,the extraction efficiency is 91.8%,95.7%,94.3%,the discharge efficiency is 96.6%,98.6%,97.5%,the exergy efficiency is 78.5%,83.1%,77.0%.

Key words: water storage tank, stratification, efficiency, exergy, flow, thermodynamics

中图分类号:

TK114

王崇愿, 王子龙, 张华, 车敏. 进水流量对新型储热水箱分层特性影响的实验研究[J]. 化工进展, 2016, 35(02): 403-408.

WANG Chongyuan, WANG Zilong, ZHANG Hua, CHE Min. An experimental analysis of inlet flow rate influence on stratification characteristics of a new water storage tank[J]. Chemical Industry and Engineering Progree, 2016, 35(02): 403-408.

参考文献

[1] 张凇源,关欣,王殿华,等. 太阳能光伏光热利用的研究进展[J]. 化工进展,2012,31(s1):323-327.
[2] BAHNFLETH W P,SONG J. Constant flow rate charging characteristics of a full-scale stratified chilled water storage tank with double-ring slotted pipe diffusers[J]. Applied Thermal Engineering,2005,25:3067-3082.
[3] ANDERSEN E,FURBO S,FAN J H. Multilayer fabric stratification pipes for solar tanks[J]. Solar Energy,2007,81(10):1219-1226.
[4] CRISTOFARI C,NOTTON G,POGGI P,et al. Influence of the flow rate and the tank stratification degree on the performances of a solar flat-plate collector[J]. International Journal of Thermal Sciences,2003,42(5):455-469.
[5] ZURIGAT Y H,LICHE P R,GHAJAR A J. Influence of inlet geometry on mixing in thermocline thermal energy storage[J]. Heat Mass Transfer,1991,34:115-125.
[6] ORÓ E,CASTELL A. Stratification analysis in packed bed thermal energy storage systems[J]. Applied Energy,2013,109:476-487.
[7] HAN Y M,WANG R Z,DAI Y J,et al. Analysis and experimental studies on heat storage performance within a horizontal thermal partition solar water tank[J]. Acta Energiae Solaris Sinica,2008,29(3):277-282.
[8] FERNANDEZ-SEARA J,UHIA F J. Experimental analysis of a domestic hot water storage tank[J]. Applied Thermal Energy,2007,27:137-144.
[9] LI S H,ZHANG Y X,LI Y,et al. Experimental study of inlet structure on the discharging performance of a solar water storage tank[J]. Energy and Buildings,2014,70:490-496.
[10] DAVIDSON J H,ADAMS D A. A coefficient to characterize mixing in solar water storage tanks[J]. Sol. Energy Eng.,1994,116:94-99.
[11] MUSSER A,BAHNFLETH W. Evolution of temperature distributions in a full-scale stratified chilled water storage tank[J]. ASHRAE Transactions,1998,104 (1):55-67.
[12] HAHNE E,CHEN Y. Numerical study of flow and heat transfer characteristics in hot-water stores[J]. Solar Energy,1998,64:9-18.
[13] NAJEM N M,MARAFIE A. Analytical and experimental investigation of thermal stratification in storage tanks[J]. International Journal of Energy Research,1993,17:77-88.
[14] ISMAIL K A R,LEAL J F B,ZANARDI M A. Models of liquid storage tanks[J]. International Journal of Energy Research,1997,22:805-15.
[15] HEGAZY A A. Effect of inlet design on the performance of storage-type domestic electrical water heaters[J]. Applied Energy,2007,84:1338-1355.
[16] LAVAN Z,THOMPSON J. Experimental study of thermally stratified hot water storage tanks[J]. Solar Energy,1977,19:519-24.
[17] HAN Y M,WANG R Z,DAI Y J. Thermal stratification within the water tank[J]. Renewable and Sustainable Energy Reviews,2009,13:1014-1026.
[18] ZURIGAT Y H,GHAJAR A J. Thermal energy storage systems and applications[M]. New York:John Wiley & Sons,2002:264-270.
[19] SHAH L J,FURBO S. Entrance effects in solar storage tanks[J]. Solar Energy,2003,75:337-348.
[20] ROSEN M A,TANG R,DINCER I. Effect of stratification on energy and exergy capacities in thermal storage systems[J]. Int. J. Energy Res.,2004,28:177-193.

进水流量对新型储热水箱分层特性影响的实验研究

An experimental analysis of inlet flow rate influence on stratification characteristics of a new water storage tank

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	盛维武, 程永攀, 陈强, 李小婷, 魏嘉, 李琳鸽, 陈险峰. 微气泡和微液滴双强化脱硫反应器操作分析[J]. 化工进展, 2023, 42(S1): 142-147.
[2]	赵晨, 苗天泽, 张朝阳, 洪芳军, 汪大海. 负压状态窄缝通道乙二醇水溶液传热特性[J]. 化工进展, 2023, 42(S1): 148-157.
[3]	王胜岩, 邓帅, 赵睿恺. 变电吸附二氧化碳捕集技术研究进展[J]. 化工进展, 2023, 42(S1): 233-245.
[4]	陈林, 徐培渊, 张晓慧, 陈杰, 徐振军, 陈嘉祥, 密晓光, 冯永昌, 梅德清. 液化天然气绕管式换热器壳侧混合工质流动及传热特性[J]. 化工进展, 2023, 42(9): 4496-4503.
[5]	董佳宇, 王斯民. 超声强化对二甲苯结晶特性及调控机理实验[J]. 化工进展, 2023, 42(9): 4504-4513.
[6]	罗成, 范晓勇, 朱永红, 田丰, 崔楼伟, 杜崇鹏, 王飞利, 李冬, 郑化安. 中低温煤焦油加氢反应器不同分配器中液体分布的CFD模拟[J]. 化工进展, 2023, 42(9): 4538-4549.
[7]	朱传强, 茹晋波, 孙亭亭, 谢兴旺, 李长明, 高士秋. 固体高分子脱硝剂选择性非催化还原NO _x 特性[J]. 化工进展, 2023, 42(9): 4939-4946.
[8]	杨莹, 侯豪杰, 黄瑞, 崔煜, 王兵, 刘健, 鲍卫仁, 常丽萍, 王建成, 韩丽娜. 利用煤焦油中酚类物质Stöber法制备碳纳米球用于CO₂吸附[J]. 化工进展, 2023, 42(9): 5011-5018.
[9]	张东, 刘鹏飞, 刘春阳, 侯刚, 惠博, 安周建. 太阳能PV/T光储直驱热电联产系统性能[J]. 化工进展, 2023, 42(6): 2895-2903.
[10]	孙征楠, 李洪晶, 荆国林, 张福宁, 颜飚, 刘晓燕. EVA及其改性聚合物在原油降凝剂领域的应用[J]. 化工进展, 2023, 42(6): 2987-2998.
[11]	杨许召, 李庆, 袁康康, 张盈盈, 韩敬莉, 吴诗德. 含Gemini离子液体低共熔溶剂热力学性质[J]. 化工进展, 2023, 42(6): 3123-3129.
[12]	宋民航, 赵立新, 徐保蕊, 刘琳, 张爽. 基于入口分散相重排序的旋流强化分离研究进展[J]. 化工进展, 2023, 42(5): 2219-2232.
[13]	陈伟良, 高鑫, 李洪, 李鑫钢. 泡沫碳化硅波纹规整填料骨架结构对其传质性能的影响机理[J]. 化工进展, 2023, 42(5): 2289-2297.
[14]	张晨宇, 王宁, 徐洪涛, 罗祝清. 纳米颗粒强化传热的多级潜热储热器性能评价[J]. 化工进展, 2023, 42(5): 2332-2342.
[15]	郭文杰, 翟玉玲, 陈文哲, 申鑫, 邢明. Al₂O₃-CuO/水混合纳米流体对流传热性能及热经济性分析[J]. 化工进展, 2023, 42(5): 2315-2324.