化工进展 ›› 2016, Vol. 35 ›› Issue (12): 3919-3927.DOI: 10.16085/j.issn.1000-6613.2016.12.027

• 工业催化 • 上一篇    下一篇

载体结构对锡铁负载型催化剂脱硝性能的影响

陈凯歌1,2, 肖峰2, 蒋晓萍2, 许琦2   

  1. 1 常州大学石油化工学院, 江苏 常州 213000;
    2 盐城工学院, 江苏 盐城 224000
  • 收稿日期:2016-03-16 修回日期:2016-08-08 出版日期:2016-12-05 发布日期:2016-12-05
  • 通讯作者: 徐琦,教授,研究方向为大气污染治理技术(NOx、CO2、VOC等)。E-mail:xgsteve@ycit.cn。
  • 作者简介:陈凯歌(1992-),男,硕士研究生,研究方向为氮氧化物的催化转化。E-mail:m13851068451_2@163.com。

Effect of pore structure on the performance of Sn-Fe supported catalyst in denitration

CHEN Kaige1,2, XIAO Feng2, JIANG Xiaoping2, XU Qi2   

  1. 1 School of Petrochemical Engineering, ChangZhou University, Changzhou 213000, Jiangsu, China;
    2 Yancheng Institute of Technology, Yancheng 224000, Jiangsu, China
  • Received:2016-03-16 Revised:2016-08-08 Online:2016-12-05 Published:2016-12-05

摘要: 利用凹凸棒土(ATP)、活性炭(AC)、介孔硅(MCM-41)、二氧化钛(TiO2)这4种孔结构不同的载体,通过水热法制备了以Fe2O3为催化剂主活性组分、SnO2为辅活性组分的锡铁负载型催化剂。催化剂的微观结构通过BET和SEM测试,并在催化剂评价装置中模拟烟气组成,考察锡铁负载型催化剂在反应温度为80~280℃、脱硝空速为32000~48000h-1范围内的选择性催化还原(SCR)性能。同时考察了SO2与H2O对1/2SnFe/ATP催化剂的影响。实验表明,载体可能为催化剂提供大量Brønsted酸性位点,有利于反应气体吸附。1/2SnFe/ATP催化剂表现出最佳的SCR脱硝性能,在200℃时实现最高96.4%的NO转化率,而且由其抗硫性及其抗水性实验表明:SO2单独作用于催化剂时,脱硝效率降低迟缓,切断二氧化硫后仍能恢复到85%以上。同时加入水和二氧化硫后,将会导致脱硝效率急剧下降。停止加入后,催化剂效率又开始慢慢恢复,效率可以恢复达到70%以上。

关键词: 载体结构, 脱硝, 负载型催化剂, 选择性催化还原

Abstract: Four catalyst supports of different pore structures,namely attapulgite(ATP),activated carbon(AC),mesoporous silica(MCM-41)and titanium dioxide(TiO2),were used to prepare a series of Sn-Fe supported catalysts by the hydrothermal synthesis method with the Fe2O3 as active component,and SnO2 as auxiliary active component. The materials before and after preparation were characterized by BET and SEM. The denitration performance of the prepared catalysts for artificial flue gas were tested in a catalyst evaluation device in a temperature range of(80-280℃)and space velocity range of(32000-48000h-1). Meanwhile,the impact of SO2 and H2O on the catalyst(1/2SnFe/ATP)was investigated. The results showed that carriers might provide a large number of Brønsted acid sites,which was beneficial for the gas adsorption reaction. Among all the test catalysts,the 1/2SnFe/ATP had the best SCR denitration performance. At 200℃,the conversion of NO could reach by 96.4%. It was also found,when there was only SO2,the NO removal efficiency decreased slowly,and would still be higher than 85% if SO2 input was cut off. But when H2O and SO2 were simultaneously added,the NO removal efficiency fell sharply and would went back to above 70% if H2O and SO2 input was cut off.

Key words: support structure, denitration, supported catalysts, selective catalytic reduction(SCR)

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn