Chemical Industry and Engineering Progree ›› 2015, Vol. 34 ›› Issue (05): 1401-1405.DOI: 10.16085/j.issn.1000-6613.2015.05.036

Previous Articles     Next Articles

Phosphate regulate the microstructure and surface hydroxyl density of nano-titanium dioxide

TAO Yugui, ZHENG Jie, ZHU Longbao, GE Fei, LIANG Mindong   

  1. College of Biochemistry Engineering, Anhui Polytechnic University, Wuhu 241000, Anhui, China
  • Received:2014-11-05 Revised:2014-12-22 Online:2015-05-05 Published:2015-05-05

磷酸盐调控纳米TiO2微结构及其表面羟基密度

陶玉贵, 郑洁, 朱龙宝, 葛飞, 梁敏东   

  1. 安徽工程大学生物与化学工程学院, 安徽 芜湖 241000
  • 通讯作者: 陶玉贵(1965—),男,硕士,教授,主要研究方向为生物功能材料.E-mailtaoyugui@126.com.
  • 作者简介:陶玉贵(1965—),男,硕士,教授,主要研究方向为生物功能材料.E-mailtaoyugui@126.com.
  • 基金资助:

    安徽省自然科学基金(1308085MC51)、安徽省高校自然科学基金重点项目(KJ2012A034)及全国大学生创新创业训练计划(201410363023)项目.

Abstract: Titanium dioxide was prepared by adding phosphate in the sol-gel process and acetic acid used as an inducer. The effect of phosphate on nano-titanium dioxide micro-structure and surface hydroxyl density were studied in this paper. The process of phase transition and surface structural change were investigated by powder X-ray diffraction(XRD),Brunauer–Emmett–Teller (BET),X-ray energy-dispersive (EDS),scanning electron microscope (SEM),fourier-transformed infrared (FT-IR) and thermogravimetric analysis (TGA). The results showed that the surface hydroxyl groups of nano-titanium dioxide were significantly increased with the adding amount of phosphate. The surface hydroxyl densities were 10.74nm-2 and 4.03nm-2 of the samples calcined at the temperature of 500℃ and 700℃,respectively. However,the control sample with none phosphate was 4.95 DOH/nm2 at 500℃. Moreover,the thermal stability of the phase transition was enhanced by adding phosphate in sol-gel process. Until the phase change temperature reached 800℃ did it have been begun to ransform anatase to rutile. The may be due to the bonding of PO43- in these multidentate modes occupy one full face of [TiO6] octahedra and inhibit the growing of chain along the opposite edges and hence inhibit the formation of rutile.

Key words: TiO2 nanoparticle, phosphate, rutile, anatase, surface hydroxyl density

摘要: 以冰乙酸作诱导剂,研究磷酸盐在溶胶-凝胶法合成纳米二氧化钛过程中对其微结构及其表面羟基密度的影响,并利用XRD、BET、EDS、SEM、FT-IR和TGA等方法对二氧化钛相变过程和表面结构变化进行表征.结果表明:合成过程中添加磷酸根可增加纳米二氧化钛的表面羟基密度,500℃、700℃煅烧6h,其表面羟基密度分别为10.74nm-2、4.03nm-2,而对照样在500℃煅烧条件下其表面羟基密度为4.95nm-2;同时磷酸根的添加,有利于锐钛型晶相结构的热稳定性,锐钛型向金红石转变的相变温度达800℃.这可能是由于PO43-与TiO2晶相生长基元[TiO6]八面体易发生多齿螯合,不利于金红石相形成.

关键词: 纳米TiO2, 磷酸根, 金红石, 锐钛矿, 表面羟基密度

CLC Number: 

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd