化工进展 ›› 2020, Vol. 39 ›› Issue (10): 3892-3899.DOI: 10.16085/j.issn.1000-6613.2019-2091

• 化工过程与装备 • 上一篇    下一篇

不同润湿表面液体沸腾的分子动力学模拟

张石重(), 陈占秀(), 杨历, 苗瑞灿, 张子剑   

  1. 河北工业大学能源与环境工程学院,天津 300401
  • 出版日期:2020-10-05 发布日期:2020-10-09
  • 通讯作者: 陈占秀
  • 作者简介:张石重(1994—),男,硕士研究生,研究方向为强化传热及节能技术。E-mail:zhangszwork@qq.com
  • 基金资助:
    河北省高等学校科学技术研究项目(ZD2016163)

Molecular dynamics simulation of liquid boiling on different wetting surfaces

Shizhong ZHANG(), Zhanxiu CHEN(), Li YANG, Ruican MIAO, Zijian ZHANG   

  1. School of Energy and Environmental Engineering, Hebei University of Technology, Tianjin 300401, China
  • Online:2020-10-05 Published:2020-10-09
  • Contact: Zhanxiu CHEN

摘要:

采用分子动力学方法研究纳米尺度下液氩在过热基板上的沸腾过程。通过调节固液间相互作用的方式改变壁面润湿性,模拟并分析了壁面润湿性对沸腾过程中能量传递和液体运动情况的影响。结果表明:不同润湿性表面均会发生固液分离的现象,但是固体表面附近吸附的氩原子数密度随润湿性增强而增大;润湿性较强时,液体的能量上升快,热通量高,液体内部温度梯度大,发生固液分离时间早,系统中氩的温度和能量低,上升过程中液氩密度、厚度变化小;润湿性较弱时,液体的能量上升慢,热通量小,液体内部温度梯度小,发生固液分离时间延后,系统中氩的温度、能量更高,上升过程中液氩密度、厚度变化较大。下部气体压力整体上大于上部气体压力,发生固液分离时润湿性越强的表面上液体上下压差越大,首次上升过程能达到的高度越高,所需时间越短。

关键词: 润湿性, 沸腾, 传热, 微尺度, 分子模拟

Abstract:

The boiling process of liquid argon on superheated substrates at nanoscale was investigated by molecular dynamics simulations. The wall wettability was changed by changing the way of solid-liquid interaction. The effects of wall wettability on energy transfer and liquid motion during boiling were simulated and analyzed. The results showed that solid-liquid separation occurs on different wettable surfaces. As the wettability increases, the number density of argon atoms adsorbed near the solid surface increases. When the wettability is strong, the energy of the liquid rises faster. The heat flux is greater and the temperature gradient inside the liquid is larger. The solid-liquid separation phenomenon occurs earlier, and the temperature and energy of argon in the system are lower. The density and thickness of the liquid change less during the ascent. When the wettability is weak, the energy of the liquid rises more slowly. The heat flux density is smaller, and the temperature gradient inside the liquid is smaller. The solid-liquid separation phenomenon takes more time, and the temperature and energy of argon in the system are higher. The density and thickness of the liquid change more significantly during the ascent. The lower gas pressure is generally greater than the upper gas pressure. When solid-liquid separation occurs, the pressure difference between the liquid on the surface with strong wettability is more obvious, and the height of the first ascent process can reach a higher height and take less time.

Key words: wettability, boiling, heat transfer, microscale, molecular dynamic

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn