化工进展 ›› 2019, Vol. 38 ›› Issue (05): 2142-2149.DOI: 10.16085/j.issn.1000-6613.2018-1580

• 化工过程与装备 • 上一篇    下一篇

电磁振动给料机内颗粒物料的定量加料特性

彭美豹1(),刘义伦1,2(),赵先琼1,刘驰1,刘思琪1,付卓3   

  1. 1. 中南大学机电工程学院,湖南 长沙 410083
    2. 中南大学轻合金研究院,湖南 长沙 410083
    3. 长沙学院机电;工程学院,湖南 长沙 410022
  • 收稿日期:2018-08-02 修回日期:2018-12-13 出版日期:2019-05-05 发布日期:2019-05-05
  • 通讯作者: 刘义伦
  • 作者简介:<named-content content-type="corresp-name">彭美豹</named-content>(1993—),男,硕士研究生,主要从事散体颗粒物质的传热传质机理研究。E-mail:<email>pmb989@126.com</email>。
  • 基金资助:
    国家自然科学基金(51375500);长沙市科技计划重点项目(K1508090-11);湖南省教育厅科学研究项目(16C0140);长沙市科技计划(k1705052)

Quantitative feeding characteristics of granular materials in electromagnetic vibration feeder

Meibao PENG1(),Yilun LIU1,2(),Xianqiong ZHAO1,Chi LIU1,Siqi LIU1,Zhuo FU3   

  1. 1. College of Mechanical and Electrical Engineering, Central South University, Changsha 410083, Hunan, China
    2. Light Alloy Research Institute, Central South University, Changsha 410083, Hunan, China
    3. College of Mechanical and Electrical Engineering, Changsha University, Changsha 410022, Hunan, China
  • Received:2018-08-02 Revised:2018-12-13 Online:2019-05-05 Published:2019-05-05
  • Contact: Yilun LIU

摘要:

为提高电磁振动给料机定量加料性能,采用离散单元法建立振幅和闸门开度双重控制参数下电振机的计算模型,从颗粒群运动状态和力学特性的角度研究控制参数对加料流量快速性和稳定性的影响,并通过实验验证了计算模型的可靠性。结果表明:加料流量均值随振幅、闸门开度的增加分别呈二次曲线和线性增长,且料层厚度的变化引起加料速度的改变使得振幅与闸门开度间存在交互因子;提升振幅,闸门内侧外层颗粒紊流区域增加,闸门口弧状流流速加快;减小振幅至2.0mm或增大闸门开度至16mm,都能有效降低颗粒与颗粒、颗粒与槽面之间法向、切向上的平均接触力和最大接触力,颗粒群流动密实性增加,颗粒体系受力更为均衡,流动一致性更好,进而使加料流量变异系数减小,定量加料快速性和稳定性综合性能提高。

关键词: 电磁振动给料机, 离散单元法, 定量加料, 流动行为

Abstract:

To improve the quantitative feeding performance of electromagnetic vibratory feeder, the simulation model of vibrator under the dual control method of amplitude and gate opening was established based on the discrete element method. The influence of control parameters on the stability and accuracy of the feeding flow was studied from the perspective of the particle group motion state and mechanical properties, and the reliability of the model was validated by experiments. The results showed that the mean value of the feed flow respectively appears a quadratic curve and linear growth with the increase of amplitude and gate opening, and the change of feeding velocity caused by the change of layer thickness makes the interaction factor between amplitude and gate opening. With the increase of amplitude, the turbulent flow area of the outer layer particles of the inner side of the gate increases, and the velocity of the arc flow at the gate is also accelerated. When the amplitude is reduced to 2.0mm or the gate opening is increased to 16mm, the normal and tangential average contact force and the maximum contact force between particle-particle and particle-groove can be effectively reduced, and the flow density of the particle group can be increased. The force of the particle system is more uniform, the flow consistency is better. Furthermore, the variation coefficient of the feeding flow is reduced, and the comprehensive performance of the rapidity and stability of the quantitative feeding is improved.

Key words: electromagnetic vibration feeder, discrete element method, precision dosing, flow behavior

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn