高黏介质中内插扭带对换热管换热性能影响

doi:10.16085/j.issn.1000-6613.2015.09.004

化工进展 ›› 2015, Vol. 34 ›› Issue (09): 3232-3237.DOI: 10.16085/j.issn.1000-6613.2015.09.004

高黏介质中内插扭带对换热管换热性能影响

胡斐, 陆晓峰, 朱晓磊

南京工业大学机械与动力工程学院, 江苏南京 211816

收稿日期:2015-02-05 修回日期:2015-03-16 出版日期:2015-09-05 发布日期:2015-09-05
通讯作者: 陆晓峰,教授,研究方向为强化传热机理及技术与流体机械的结构与强度。E-mail:xflu@njtech.edu.cn
作者简介:胡斐(1989-),男,硕士研究生,研究方向为新型高效传热传质设备。E-mail:1015271990@qq.com

Influences of an inserted twisted tape on the heat transfer performances of a tube with high viscous medium

HU Fei, LU Xiaofeng, ZHU Xiaolei

College of Mechanical and Power Engineering, Nanjing Tech. University, Nanjing 211816, Jiangsu, China

Received:2015-02-05 Revised:2015-03-16 Online:2015-09-05 Published:2015-09-05

摘要/Abstract

摘要： 某石化公司炼油厂第二套常减压装置中换热器的热交换介质为高黏度的原油及其附属产品,在对流换热过程中传热系数低,动能消耗大。针对这一现状,本文设计了一种换热管内插间歇半扭带,利用计算流体力学软件Fluent对内插间歇半扭带换热管在实际工况下的换热过程进行数值模拟,与光滑管、内插连续扭带换热管进行了对比,并给出了间歇半扭带传热元件的优化设计参数。结果表明:内插间歇半扭带大幅提高了换热管内流体的努塞尔数Nu,同时也使换热管内摩擦阻力系数f增大;间歇半扭带换热管的换热效率η比内插连续扭带换热管提高8%~12%;当间歇半扭带的扭曲率y为10、连接杆长度s为345mm时,换热效率η最高,达到2.06。研究结果为该常减压装置换热器强化传热的研究提供了理论依据。

关键词: 传热, 内插扭带, 高黏度, 层流, 数值模拟

Abstract: The high viscosity of the heat transfer medium in the crude oil distillation unit in oil refinery process will normally lead to low heat transfer efficiency and high kinetic energy consumption. To solve the problem,this research designed a segmented semi-twisted tape to conduct numerical simulation of the heat transfer process of the tube with a segmented semi-twisted tape under actual conditions,using FLUENT. The heat transfer parameters in plain tube and tube with a continuous twisted tape were compared. The simulation provided optimum design parameters of the segmented semi-twisted tape. The results showed that the segmented semi-twisted tape improved Nu (Nusselt number) of the fluid in a heat transfer tube as well as f (friction factor),and η (heat transfer efficiency) of the tube with a segmented semi-twisted tape was increased by 8%-12% compared the tube with a continuous twisted tape. The value of η reached the highest number of 2.06 when y (twist ratio of the segmented semi-twisted tape)was 10 and s (length of the connection rod) was 345mm. The results provided a theoretical basis for the study of enhanced heat transfer of a heat exchanger in a crude oil unit.

Key words: heat transfer, inserted tape, high viscosity, laminar flow, numerical simulation

中图分类号:

TK124

胡斐, 陆晓峰, 朱晓磊. 高黏介质中内插扭带对换热管换热性能影响[J]. 化工进展, 2015, 34(09): 3232-3237.

HU Fei, LU Xiaofeng, ZHU Xiaolei. Influences of an inserted twisted tape on the heat transfer performances of a tube with high viscous medium[J]. Chemical Industry and Engineering Progree, 2015, 34(09): 3232-3237.

参考文献

[1] 彭炳初,罗伟明. 空气压缩机后冷却器传热强化试验研究[J]. 化学工程,1996,24(5):13-16.

[2] 曾敏,王秋旺,屈治国,等. 波纹管内强制对流换热与阻力特性的实验研究[J]. 西安交通大学学报,2002,36(3):237-240.

[3] 陈克平,张锁龙. 波纹管传热特性的数值模拟与实验研究[J]. 石油机械,2008(1):61-63.

[4] 张登庆,李忠堂,王宗明,等. 波节管管内换热与阻力特性的实验研究[J]. 石油机械,2002,30(4):4-6.

[5] 李治滨. 螺旋槽管强化传热原理及在石化装置上的应用前景[J]. 石油化工设备技术,2002,23(2):8-10.

[6] 阎昌琪,侯山高,曹夏昕. 滑油冷却器强化换热试验研究[J]. 核动力工程,2008,29(2):16-19.

[7] Agrawal K N,Varma H K,Lal S. Pressure drop during forced convection boiling of R-12 under swirl flow[J]. Journal of Heat Transfer,1982,104(4):758-762.

[8] 张永福,李方钺. 管内螺旋线圈强化传热的研究及在锅炉的应用[J]. 热能动力工程,1993,8(1):10-14.

[9] Uttarwar S B,Rao M R. Augmentation of laminar flow heat transfer in tubes by means of wire coil inserts[J]. Journal of Heat Transfer,1985,107(4):930-935.

[10] 肖宏亮,朱冬生. 管内在线防垢及强化传热的实验研究[J]. 热能动力工程,1997,12(4):275-277.

[11] Date A W,Singham J R. Numerical prediction of friction and heat transfer characteristics of fully developed laminar flow in tubes containing twisted tapes[J]. Journal of Heat Transfer,1972:ASME Paper No.72-HT-17.

[12] Date A W,Gaitonde U N. Development of correlations for predicting characteristics of laminar flow in a tube fitted with regularly spaced twisted-tape elements[J]. Experimental Thermal and Fluid Science,1990,3(4):373-382.

[13] Eiamsa-Ard S,Thianpong C,Eiamsa-Ard P,et al. Convective heat transfer in a circular tube with short-length twisted tape insert[J]. International Communications in Heat and Mass Transfer,2009,36(4):365-371.

[14] Eiamsa-Ard S,Promvonge P. Performance assessment in a heat exchanger tube with alternate clockwise and counter-clockwise twisted-tape inserts[J]. International Journal of Heat and Mass Transfer,2010,53(7):1364-1372.

[15] 孙东亮,王良璧. 含扭曲带管内流动与传热的数值模拟[J]. 化工学报,2004,55(9):1422-1427.

[16] 谢洪虎,江楠. 连续形螺旋折流板管壳式换热器强化传热机理的数值模拟[J]. 石油化工设备,2009,38(B08):6-11.

[17] Salman S D,Kadhum A A H,Takriff M S,et al. CFD simulation of heat transfer and friction factor augmentation in a circular tube fitted with elliptic-cut twisted tape inserts[J]. Mathematical Problems in Engineering,2013. DOI:10.1155/2013/163839.

高黏介质中内插扭带对换热管换热性能影响

Influences of an inserted twisted tape on the heat transfer performances of a tube with high viscous medium

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	肖辉, 张显均, 兰治科, 王苏豪, 王盛. 液态金属绕流管束流动传热进展[J]. 化工进展, 2023, 42(S1): 10-20.
[2]	王太, 苏硕, 李晟瑞, 马小龙, 刘春涛. 交流电场中贴壁气泡的动力学行为[J]. 化工进展, 2023, 42(S1): 133-141.
[3]	赵晨, 苗天泽, 张朝阳, 洪芳军, 汪大海. 负压状态窄缝通道乙二醇水溶液传热特性[J]. 化工进展, 2023, 42(S1): 148-157.
[4]	陈匡胤, 李蕊兰, 童杨, 沈建华. 质子交换膜燃料电池气体扩散层结构与设计研究进展[J]. 化工进展, 2023, 42(S1): 246-259.
[5]	郭强, 赵文凯, 肖永厚. 增强流体扰动强化变压吸附甲硫醚/氮气分离的数值模拟[J]. 化工进展, 2023, 42(S1): 64-72.
[6]	邵博识, 谭宏博. 锯齿波纹板对挥发性有机物低温脱除过程强化模拟分析[J]. 化工进展, 2023, 42(S1): 84-93.
[7]	陈林, 徐培渊, 张晓慧, 陈杰, 徐振军, 陈嘉祥, 密晓光, 冯永昌, 梅德清. 液化天然气绕管式换热器壳侧混合工质流动及传热特性[J]. 化工进展, 2023, 42(9): 4496-4503.
[8]	刘炫麟, 王驿凯, 戴苏洲, 殷勇高. 热泵中氨基甲酸铵分解反应特性及反应器结构优化[J]. 化工进展, 2023, 42(9): 4522-4530.
[9]	赵曦, 马浩然, 李平, 黄爱玲. 错位碰撞型微混合器混合性能的模拟分析与优化设计[J]. 化工进展, 2023, 42(9): 4559-4572.
[10]	卜治丞, 焦波, 林海花, 孙洪源. 脉动热管计算流体力学模型与研究进展[J]. 化工进展, 2023, 42(8): 4167-4181.
[11]	汪健生, 张辉鹏, 刘雪玲, 傅煜郭, 朱剑啸. 多孔介质结构对储层内流动和换热特性的影响[J]. 化工进展, 2023, 42(8): 4212-4220.
[12]	王云刚, 焦健, 邓世丰, 赵钦新, 邵怀爽. 冷凝换热与协同脱硫性能实验分析[J]. 化工进展, 2023, 42(8): 4230-4237.
[13]	叶振东, 刘涵, 吕静, 张亚宁, 刘洪芝. 基于钙镁二元盐的热化学储能反应器的性能优化[J]. 化工进展, 2023, 42(8): 4307-4314.
[14]	俞俊楠, 俞建峰, 程洋, 齐一搏, 化春键, 蒋毅. 基于深度学习的变宽度浓度梯度芯片性能预测[J]. 化工进展, 2023, 42(7): 3383-3393.
[15]	单雪影, 张濛, 张家傅, 李玲玉, 宋艳, 李锦春. 阻燃型环氧树脂的燃烧数值模拟[J]. 化工进展, 2023, 42(7): 3413-3419.