壁面润湿性对蛇形微通道内两相流流动特性影响的格子Boltzmann模拟

doi:10.16085/j.issn.1000-6613.2016.s1.004

化工进展 ›› 2016, Vol. 35 ›› Issue (S1): 20-25.DOI: 10.16085/j.issn.1000-6613.2016.s1.004

壁面润湿性对蛇形微通道内两相流流动特性影响的格子Boltzmann模拟

周云龙, 常赫

东北电力大学能源与动力工程学院, 吉林吉林 132012

收稿日期:2016-03-22 修回日期:2016-04-28 出版日期:2016-06-30 发布日期:2016-07-08
通讯作者: 周云龙(1960-),男,教授,博士生导师,主要从事多相流及传热方面的研究。E-mail ylzhou@mail.nedu.edu.cn。

Lattice boltzmann simulation of gas-liquid flow in serpentine microchannel under different contact angle

ZHOU Yun, CHANG He

Energy and Power Engineering College, Northeast Dianli University, Jilin 132012, Jilin, China

Received:2016-03-22 Revised:2016-04-28 Online:2016-06-30 Published:2016-07-08

摘要/Abstract

摘要： 在90°Y形汇流的矩形截面蛇形微通道内,采用格子Boltzmann方法对不同接触角的蛇形微通道内气液两相流动进行了数值计算。首先以空气和水为工作流体对气液两相流动进行模拟研究并通过实验进行验证。验证模型合理性后,根据模拟计算结果,以气液相流速为坐标绘制了不同接触角下的流型图并分析其差异性及原因;同时深入研究了液相黏度和接触角对于弹状流流体力学性质的综合影响;比较了具有不同接触角壁面的蛇形微通道内两相流压降、摩擦因子、壁面摩擦系数和剪切应力的分布规律,并讨论了蛇形微通道内气液两相流动的影响因素。研究表明疏水壁面即接触角大于90°时,微通道内两相流压降、摩擦因子、壁面摩擦系数和剪切应力均低于亲水壁面微通道内相关参数,更利于流体流动。

关键词: 蛇形微通道, 气液两相流, 数值模拟, 格子玻尔兹曼, 流体动力学

Abstract: In order to study the gas-liquid two-phase flow of 90° Y-junction convergence coil, the method of lattice Boltzmann was adopted.The simulation of gas-liquid two-phase flow with air and water as working fluid was carried out in the serpentine microchannels of rectangular cross section.After passing the verification experiment, according to the calculation results, the flow patterns of different contact angles are plotted with the gas-liquid phase velocity as the coordinate and the effect of contact angle on slug flow was in-depth studied;Meanwhile, the difference of pressure drop and friction factor of two-phase flow under different contact angle in serpentine microchannels were compared; Influence factors of wall friction coefficient and shear stress were also discussed.It showed that hydrophobic wall which means the contact angle is greater than 90 degrees, the two-phase flow pressure drop, friction factor, wall friction coefficient and wall shear stress were lower than related parameters in serpentine microchannel with hydrophilic wall, which is beneficial to fluid flow.

Key words: serpentine microchannels, gas-liquid flow, numerical simulation, lattice Boltzmann, hydrodynamics

中图分类号:

TK172

周云龙, 常赫. 壁面润湿性对蛇形微通道内两相流流动特性影响的格子Boltzmann模拟[J]. 化工进展, 2016, 35(S1): 20-25.

ZHOU Yun, CHANG He. Lattice boltzmann simulation of gas-liquid flow in serpentine microchannel under different contact angle[J]. Chemical Industry and Engineering Progree, 2016, 35(S1): 20-25.

参考文献

[1] FIGEYS Daneil,PINTO Devannand.Lab-on-a chip:a revolution in biological and medical sciences[J].Analytical Chemistry, 2000,72(9):330A-335A.
[2] EHRFELD Wolfgang,VOLKER Hessel, LOWE Holger. Microreactors:new technology for modern chemistry[M]. Weinheim:Wiley-VCH,2001.
[3] MAS de Nuria,JACKMAN Rebecca,MARTIN Schmidt,et al. Microchemical systems for direct fluorination of aromatics//Fifth International Conference on Microreaction Technology (IMRET5)[C].Berlin:Springer-Verlag,2001:60-67.
[4] 林宗虎.气液两相流和沸腾传热[M].西安:西安交通大学出版社, 2003.
[5] 施明恒,甘永平,马重芳.沸腾和凝结[M].北京:高等教育出版社,1995.
[6] LEE Chi Yong,LEE Sang Yong.Influence of surface wettability on transition of two-phase flow pattern in round mini-channels[J]. International Journal of Multiphase Flow,2008, 34(7):706-711.
[7] TRIPLETT K A, GHIAASIAAN S M, ABDEL-KHALIK S I,et al.Gas-liquid two-phase flow in microchannels Part Ⅰ:Two-phase flow patterns[J]. International Journal of Multiphase Flow, 1999,25(3):377-394.
[8] SERIZAWA Akimi, FENG Ziping,KAWARA Zensaku. Two-phase flow in microchannels[J].Experimental Thermal and Fluid Science, 2002,26(6/7):703-714.
[9] CHOI Chiwoong,YU Dongin,KIM Moohwan.Surface wettability effect on flow pattern and pressure drop in adiabatic two-phase flows in rectangular microchannels with T-junction mixer[J].Experimental Thermal and Fluid Science,2011,35(6):1086-1096.
[10] GUAN Ning, LIU Zhigang, JIANG Guilin, et al. Experimental and theoretical investigations on the flow resistance reduction and slip flow in super-hydrophobic micro tubes tubes[J]. Experimental Thermal and Fluid Science,2015,69(3):45-57.
[11] 孙俊杰,郝婷婷,马虎兰,等.壁面润湿性对微通道内二氧化碳-水两相流流动及传质性能的影响[J].化工学报,2015,66(9):3405-3412.
[12] ZHU Xiaoyang, ZHU Liu, CHEN Hejuan, et al.Fabrication of multi-scale micro-lens arrays on hydrophobic surfaces using a drop-on-demand droplet generator[J].Optics and Laser Technology,2015,66(8):156-165.
[13] MA Minglin,HILL Randal.Superhydrophobic surfaces[J]. Current Opinion in Colloid and Interface Science,2006,11(4):193-202.
[14] WU Yan,GAO Shengdong.Developent of free adjustable function generator for drop-on-demand droplets generation[C].Berlin Herdelberg:Springer,2012:477-481.
[15] CHEN Weichih, WU Tsungju,WU Wenjong,et al. Fabrication of inkjet-printed SU-8 photoresist microlens using hydrophilic confinement[J]. Journal of Micromechanics and Microengineering,2013, 23(6):65008-65015.
[16] KIM Yeon, PFEIFFER Karl,VOIGT Anja,et al.Directly fabricated multi-scale microlens arrays on a hydrophobic flat surface by a simple ink-jet printing technique[J].Journal of Materials Chemostry,2012,22(7):3053-3058.
[17] HE Xiaoyi, CHEN Shiyi, DOOLEN Gary.A novel thermal model for the lattice Boltzmann method in incompressible limit[J].Journal of Computational Physics,1998,146(1):282-300.
[18] 周云龙,孙振国.蛇形微通道气液两相流动特性[J].化工学报,2015,66(11):4350-4358.
[19] QIAN Dongying, LAWAL Adeniyi.Numerical study on gas and liquid slugs for Taylor flow in a T-junction microchannel[J].Chemical Engineering Science,2006,61(23):7609-7625.
[20] OU Jia,ROTHSTEIN Jonathan.Direct velocity measureme-nts of the flow past drag-reducing ultra hydrophobic surfaces[J].Physics of Fluids,2015,17(10):3379-3392.
[21] 黄桥高,潘光,宋保维.疏水表面滑移流动及减阻特性的格子Boltzmann方法模拟[J].物理学报,2014,63(5):1-7.

壁面润湿性对蛇形微通道内两相流流动特性影响的格子Boltzmann模拟

Lattice boltzmann simulation of gas-liquid flow in serpentine microchannel under different contact angle

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	郭强, 赵文凯, 肖永厚. 增强流体扰动强化变压吸附甲硫醚/氮气分离的数值模拟[J]. 化工进展, 2023, 42(S1): 64-72.
[2]	邵博识, 谭宏博. 锯齿波纹板对挥发性有机物低温脱除过程强化模拟分析[J]. 化工进展, 2023, 42(S1): 84-93.
[3]	王太, 苏硕, 李晟瑞, 马小龙, 刘春涛. 交流电场中贴壁气泡的动力学行为[J]. 化工进展, 2023, 42(S1): 133-141.
[4]	赵晨, 苗天泽, 张朝阳, 洪芳军, 汪大海. 负压状态窄缝通道乙二醇水溶液传热特性[J]. 化工进展, 2023, 42(S1): 148-157.
[5]	黄益平, 李婷, 郑龙云, 戚傲, 陈政霖, 史天昊, 张新宇, 郭凯, 胡猛, 倪泽雨, 刘辉, 夏苗, 主凯, 刘春江. 三级环流反应器中气液流动与传质规律[J]. 化工进展, 2023, 42(S1): 175-188.
[6]	陈匡胤, 李蕊兰, 童杨, 沈建华. 质子交换膜燃料电池气体扩散层结构与设计研究进展[J]. 化工进展, 2023, 42(S1): 246-259.
[7]	刘炫麟, 王驿凯, 戴苏洲, 殷勇高. 热泵中氨基甲酸铵分解反应特性及反应器结构优化[J]. 化工进展, 2023, 42(9): 4522-4530.
[8]	赵曦, 马浩然, 李平, 黄爱玲. 错位碰撞型微混合器混合性能的模拟分析与优化设计[J]. 化工进展, 2023, 42(9): 4559-4572.
[9]	卜治丞, 焦波, 林海花, 孙洪源. 脉动热管计算流体力学模型与研究进展[J]. 化工进展, 2023, 42(8): 4167-4181.
[10]	叶振东, 刘涵, 吕静, 张亚宁, 刘洪芝. 基于钙镁二元盐的热化学储能反应器的性能优化[J]. 化工进展, 2023, 42(8): 4307-4314.
[11]	俞俊楠, 俞建峰, 程洋, 齐一搏, 化春键, 蒋毅. 基于深度学习的变宽度浓度梯度芯片性能预测[J]. 化工进展, 2023, 42(7): 3383-3393.
[12]	单雪影, 张濛, 张家傅, 李玲玉, 宋艳, 李锦春. 阻燃型环氧树脂的燃烧数值模拟[J]. 化工进展, 2023, 42(7): 3413-3419.
[13]	王硕, 张亚新, 朱博韬. 基于灰色预测模型的水煤浆输送管道冲蚀磨损寿命预测[J]. 化工进展, 2023, 42(7): 3431-3442.
[14]	周龙大, 赵立新, 徐保蕊, 张爽, 刘琳. 电场-旋流耦合强化多相介质分离研究进展[J]. 化工进展, 2023, 42(7): 3443-3456.
[15]	卢兴福, 戴波, 杨世亮. 转鼓内圆柱形颗粒混合的超二次曲面离散单元法模拟[J]. 化工进展, 2023, 42(5): 2252-2261.