化工进展

• 工业催化 • 上一篇    下一篇

载体成型条件对低温脱硝Mn-Ce/TiO2催化剂的影响

耿春香1,刘文蓉1,2,张丙华1,柴倩倩1   

  1. 1中国石油大学化学工程学院,山东 青岛 266555;2天津市联合环保工程设计有限公司,天津 300191
  • 出版日期:2012-07-05 发布日期:2012-07-05

Influences of carrier forming conditions on SCR denitration Mn-Ce/TiO2 catalysts at low temperature

GENG Chunxiang1,LIU Wenrong1、2,ZHANG Binghua1,CHAI Qianqian1   

  1. 1School of Chemical Engineering,China University of Petroleum,Qingdao 266555,Shandong,China;2 Tianjin United Environmental Protection Engineering Design Co.,Ltd.,Tianjin 300191,China
  • Online:2012-07-05 Published:2012-07-05

摘要: 以磷酸为原料,制备成型TiO2载体采用焙烧成型的方法, 考察制备过程中焙烧时间、焙烧温度、黏合剂配比等对TiO2成型载体性能的影响。采用X线衍射仪(XRD)、比表面检测定仪(BET)和扫描电子显微镜(SEM)等手段对载体进行表征。结果表明: 在干燥温度105 ℃、煅烧温度为800 ℃、煅烧时间4 h条件下,成型载体TiO2有利于催化剂活性物质的负载,且催化剂的载体主要以锐钛矿型TiO2晶型存在。

关键词: 低温脱硝, 成型载体, 黏合剂, Mn-Ce/TiO2

Abstract: Phosphoric acid solution was used as the raw material to make TiO2. The effects of adhesive proportion,calcination time,calcination temperature in the preparation process were investigated. The characteristics of the carrier were determined by using X-ray diffraction (XRD),surface detection system (BET) and scanning electron microscopy (SEM). The results showed that the carrier of the catalyst was in the form of anatase under the following conditions:drying temperature at 105 ℃,calcination temperature at 800 ℃,calcination time of 4 h.

Key words: low temperature denitration, forming carrier, adhesive, Mn-Ce/TiO2

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn