化工进展 ›› 2018, Vol. 37 ›› Issue (08): 2976-2983.DOI: 10.16085/j.issn.1000-6613.2017-1965

• 能源加工与技术 • 上一篇    下一篇

采用不同集热器的太阳能有机朗肯-闪蒸循环性能分析

卜宪标1,2,3, 刘茜1,2,3,4, 李华山1,2,3, 王令宝1,2,3,4, 谢宁5   

  1. 1 中国科学院广州能源研究所, 广东 广州 510640;
    2 中国科学院可再生能源重点实验室, 广东 广州 510640;
    3 广东省新能源和可再生能源研究开发与应用重点实验室, 广东 广州 510640;
    4中国科学院大学, 北京 100049;
    5广东电网有限责任公司电力科学研究院, 广东 广州 510080
  • 收稿日期:2017-09-18 修回日期:2017-10-30 出版日期:2018-08-05 发布日期:2018-08-05
  • 通讯作者: 李华山,副研究员,研究方向为低焓热能利用技术。
  • 作者简介:卜宪标(1979-),男,博士,研究方向为低温热发电。
  • 基金资助:
    国家重点研发计划(2017YFB0903201)、广东省自然科学基金(2016A030313174)、中国科学院可再生能源重点实验室基金(Y607j11001)、广州市科技计划(201607010106)及中国科学院青年创新促进会项目(2017402)。

Performance analysis of solar binary-flashing cycle driven by flat-plate collector and evacuated tube collector

BU Xianbiao1,2,3, LIU Xi1,2,3,4, LI Huashan1,2,3, WANG Lingbao1,2,3,4, XIE Ning5   

  1. 1 Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, Guangzhou 510640, Guangdong, China;
    2 Key Laboratory of Renewable Energy, Chinese Academy of Sciences, Guangzhou 510640, Guangdong, China;
    3 Guangdong Key Laboratory of New and Renewable Energy Research and Development, Guangzhou 510640, Guangdong, China;
    4 University of Chinese Academy of Sciences, Beijing 100049, China;
    5 Electric Power Research Institute of Guangdong Power Grid Co., Ltd., Guangzhou 510080, Guangdong, China
  • Received:2017-09-18 Revised:2017-10-30 Online:2018-08-05 Published:2018-08-05

摘要: 针对太阳能有机朗肯-闪蒸循环(SBFC),本文基于EES(engineering equation solver)软件建立数学模型,以R245fa为循环工质,在集热器出口热水温度介于353.15~373.15K范围内,对平板集热器(FPC)和真空管集热器(ETC)驱动的SBFC系统热力性能以及投资成本进行了对比分析。选用的性能指标参数包括净输出功、热效率、第二定律效率、不可逆损失以及比初始投资。结果表明,随着集热器出口热水温度的增大,SBFC系统的热力性能显著升高,且采用ETC的系统比FPC系统在热力性能上更具优势,该优势随着热水温度的升高而持续增大。研究同时表明,在SBFC的投资成本中,太阳能集热器投资占比最大,且采用ETC的系统比初始投资远大于采用FPC的系统;此外,集热器出口热水温度的升高有利于降低SBFC系统的比初始投资。

关键词: 平板集热器, 真空管集热器, 有机朗肯-闪蒸循环, 热力性能, 投资成本

Abstract: A mathematical model for solar binary-flashing cycle (SBFC) driven by flat-plate collectors and evacuated tube collectors was developed based on EES (engineering equation solver) software in this paper. With R245fa as working fluids, the effect of hot water temperatures at solar collector outlet, ranging from 353.15K to 373.15K, on the thermodynamic performance and investment cost of the SBFC system has been analyzed. In the analysis, the net power output, thermal efficiency, exergy efficiency, exergy loss and specific investment cost were selected as performance indicators. Results showed that under the given working conditions, an increase in the hot water temperature at solar collector outlet could significantly improve the thermodynamic performance of the SBFC system. The thermodynamic performance of the system with ETC outperformed that of with FPC; and the advantage increased with the increased hot water temperature at solar collector outlet. Meanwhile, it was also found that the investment cost of solar collector accounted for the largest proportion of the total investment cost and the system with ETC had higher investment cost than that of with FPC. Besides, the specific investment cost decreased with the increased hot water temperature at solar collector outlet.

Key words: flat-plate collector, evacuated tube collector, binary-flashing cycle, thermodynamic performance, investment cost

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn