化工进展 ›› 2016, Vol. 35 ›› Issue (11): 3707-3713.DOI: 10.16085/j.issn.1000-6613.2016.11.048

• 资源与环境化工 • 上一篇    下一篇

甲苯分子在铝基金属-有机骨架材料上的吸附特性

刘航希1, 隋红1,2,3, 李鑫钢1,2,3, 何林1,3   

  1. 1. 天津大学化工学院, 天津300072;
    2. 天津大学精馏技术国家工程研究中心, 天津 300072;
    3. 天津化学化工协同创新中心, 天津 300072
  • 收稿日期:2016-03-08 修回日期:2016-04-22 出版日期:2016-11-05 发布日期:2016-11-05
  • 通讯作者: 何林,博士,主要从事非常规石油分离、土壤修复、VOCs治理等研究。E-mail:linhe@tju.edu.cn。
  • 作者简介:刘航希(1991-),女,硕士研究生。
  • 基金资助:

    国家自然基金面上项目(41471258)及天津市科技支撑计划美丽天津专项(14ZCDGSF00029)项目。

Adsorption profiles of toluene molecules on Al-based metal organic framework

LIU Hangxi1, SUI Hong1,2,3, LI Xingang1,2,3, HE Lin1,3   

  1. 1. School of Chemical Engineering and Technology, Tianjin University, Tianjin 300072, China;
    2. National Engineering Research Centre for Distillation Technology, Tianjin University, Tianjin 300072, China;
    3. Collaborative Innovation Center of Chemical Science and Engineering (Tianjin), Tianjin 300072, China
  • Received:2016-03-08 Revised:2016-04-22 Online:2016-11-05 Published:2016-11-05

摘要: 应用巨正则系综蒙特卡罗模拟(GCMC)方法研究了298K下甲苯在4种铝基金属-有机骨架材料(Al-MOF)上的吸附特征。通过对比模拟与实验结果,发现Dreiding力场能够较好地描述甲苯在Al-MOF上的吸附行为。由于4种Al-MOF材料均具有丰富的微孔结构,使得其甲苯吸附量(取1.5kPa时吸附量值比较)均高于传统吸附剂的吸附量(一般小于400mg/g),分别为1375mg/g (MIL-101)、866mg/g(CYCU-3)、807mg/g(MOF-519)、504mg/g(CAU-3-BDC)。通过Snapshot图和密度分布曲线分析了甲苯在Al-MOF中的吸附位,结果表明,在低压(低负载量)时,甲苯优先吸附在骨架中的小孔道内,随压力(负载量)的增大,甲苯分子逐渐填充到大孔道。此外,甲苯与有机配体的相互作用强于与金属簇的相互作用,说明有机配体处为优先吸附位。将298K、1.5kPa条件下甲苯吸附量与MOF的物理性质相关联,结果发现甲苯吸附量的大小与吸附剂的比表面积、孔容积成线性正相关,而与骨架密度成反比关系。

关键词: 蒙特卡罗模拟, 吸附, 金属-有机骨架材料, 甲苯

Abstract: Adsorption of toluene on four aluminium based metal-organic framework (Al-MOF) was investigated by grand canonical Monte Carlo simulation (GCMC) method and laboratory adsorption tests. It was found that the adsorption of toluene on Al-MOF could be well described by the Dreiding force field. Due to the Al-MOF's high surface areas and abundant pore volumes, the adsorbed capacity of toluene molecules at 298K, 1.5kPa reached 1375mg/g, 866mg/g, 807mg/g and 504mg/g for MIL-101, CYCU-3, MOF-519 and CAU-3-BDC respectively, which were all higher than that of most traditional adsorbents (<400mg/g). The preferential adsorption sites of Al-MOF for toluene molecules were analyzed using snapshot and density distribution profile. Results demonstrated that toluene molecules were preferentially adsorbed into small pores when the loading amount was small. Subsequently, more molecules were adsorbed into large pores when the loading amount increased. In addition, the interaction between toluene molecules and organic ligand was stronger than that between toluene and metal cluster, which indicated that organic ligands are preferential sites. The adsorbed amount of toluene on MOF at 298K and 1.5kPa were found to change linearly with the BET surface area, pore volume and density of frameworks, respectively.

Key words: Monte Carlo simulation, adsorption, metal-organic framework, toluene

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn