Chemical Industry and Engineering Progress ›› 2020, Vol. 39 ›› Issue (10): 4051-4060.DOI: 10.16085/j.issn.1000-6613.2020-0011

• Industrial catalysis • Previous Articles     Next Articles

Preparation and performance of SAPO-34 based SCR catalyst derived from fly ash

Ziran MA1(), Baodong WANG1(), Guangjie LU2, Yuting XIAO3, Jianhui YANG2, Jinfeng LU3, Ge LI1, Jiali ZHOU1, Hongyan WANG1, Chunlin ZHAO1   

  1. 1.National Institute of Clean-and-Low-Carbon Energy, Beijing 102211, China
    2.Beijing Guodian Longyuan Environmental Engineering Co. , Ltd. , Beijing 100039,China
    3.Jiangsu Longyuan Catalyst Co. , Ltd. , Wuxi 214123, Jiangsu, China
  • Online:2020-10-09 Published:2020-10-05
  • Contact: Baodong WANG

粉煤灰基SAPO-34分子筛脱硝催化剂的合成及其脱硝性能

马子然1(), 王宝冬1(), 路光杰2, 肖雨亭3, 杨建辉2, 陆金丰3, 李歌1, 周佳丽1, 王红妍1, 赵春林1   

  1. 1.北京低碳清洁能源研究院, 北京 102211
    2.北京国电龙源环保工程有限公司, 北京 100039
    3.江苏龙源催化剂有限公司,江苏 无锡 214123
  • 通讯作者: 王宝冬
  • 作者简介:马子然(1988—),男,博士,工程师,研究方向为环境材料及催化。E-mail:ziran.ma@chnenergy.com.cn
  • 基金资助:
    中组部青年千人启动经费“洁净煤(燃煤电厂)污染物控制”(GB9300120001);国家能源集团项目科技创新项目“宽温运行窗口脱硝催化剂关键技术与应用研究”(ST930019SH08)

Abstract:

A combined acid-alkali hydrothermal method was used to prepare SAPO-34 molecular sieves from the fly ash of a thermal power plant in Inner Mongolia Zhungeer(China). Cu-SAPO-34 catalysts were then prepared by impregnation of the fly-ash-derived SAPO-34 molecular sieves as the support, and using ammonium carbonate as the ammonium salt, and copper nitrate as the copper source. The prepared Cu-SAPO-34 catalysts were tested in the selective catalytic reduction of NH3 (NH3-SCR) after aging in 8% H2O/N2 at 500℃ and their physicochemical properties were characterized. The results showed that the SCR activity was closely related to the isolated Cu2+ at the ion exchange sites, which act as the main active center of the Cu-SAPO-34 catalyst in the NH3-SCR reaction. The low temperature activity of the catalyst increased with the Cu content, while the high temperature activity also increased until the loading of Cu reached 1.50% and then decreased with further loading. The 1.50Cu-SAPO-34 catalyst having the highest isolated Cu2+ content showed a broad operation window (>80%) between 300℃ and 500℃ under a GHSV of 200000h-1. Compared with the vanadium-based catalyst, Cu-SAPO-34 catalyst is more suitable for high temperature. This work opens up new avenues for recycling the fly ash formed in coal-fired power plants and developing SCR catalysts for NOx pollution control.

Key words: zeolite, catalyst, waste treatment, ion exchange, selective catalytical reduction(SCR)

摘要:

以内蒙准格尔电厂粉煤灰为原料,采用酸碱联合法,制备了粉煤灰基SAPO-34微孔分子筛。以SAPO-34分子筛为载体,以碳酸铵为铵盐、硝酸铜为铜源,采用离子交换法制备了不同Cu担载量的Cu-SAPO-34分子筛催化剂。在500℃、8% H2O/N2气氛下老化处理后,对催化剂的选择性催化还原脱硝性能和物理化学特性进行了测试分析。结果表明,SCR活性与Cu物种种类密切相关,位于离子交换位的孤立态的Cu2+是Cu-SAPO-34催化剂在NH3-SCR反应中的主要活性中心,随着Cu担载量的增加,催化剂的低温SCR活性提高,而高温活性在Cu质量分数达到1.50%上达到最高而后降低。1.50 Cu-SAPO-34催化剂在空速高达200000h-1、350~500℃范围内可达到80%以上的NOx转化率,显示出较宽的脱硝温度窗口。文中指出该催化剂因更好的高温活性和抗烧结能力,相比钒钛系催化剂更适用于高温工况。这项工作开辟了燃煤电厂粉煤灰无害化处理用于制备SCR催化剂的新途径。

关键词: 沸石, 催化剂, 废物处理, 离子交换, 选择性催化还原

CLC Number: 

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd