化工进展 ›› 2020, Vol. 39 ›› Issue (9): 3583-3589.DOI: 10.16085/j.issn.1000-6613.2019-1998

• 化工过程与装备 • 上一篇    下一篇

基于蒸汽压缩技术的热泵蒸汽系统热力性能分析

李帅旗1,2,3,4(), 何世辉2,3,4, 宋文吉2,3,4, 冯自平1,2,3,4()   

  1. 1.中国科学技术大学热科学与能源工程系,安徽 合肥 230026
    2.中国科学院广州能源研究所,广东 广州 510640
    3.中国科学院可再生能源重点实验室,广东 广州 510640
    4.广东省新能源与可再生能源研究开发与应用重点实验室,广东 广州 510640
  • 出版日期:2020-09-05 发布日期:2020-09-11
  • 通讯作者: 冯自平
  • 作者简介:李帅旗(1991—),男,博士研究生,研究方向为空调及热泵技术应用。E-mail:lisq@ms.giec.ac.cn
  • 基金资助:
    广州市科技计划(201903010029)

Performance analysis of heat pump steam system based on vapor compression technology

Shuaiqi LI1,2,3,4(), Shihui HE2,3,4, Wenji SONG2,3,4, Ziping FENG1,2,3,4()   

  1. 1.Department of Thermal Science and Energy Engineering, University of Science and Technology of China, Hefei 230026, Anhui, China
    2.Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, Guangzhou 510640, Guangdong, China
    3.CAS Key Laboratory of Renewable Energy, Guangzhou 510640, Guangdong, China
    4.Guangdong Provincial Key Laboratory of New and Renewable Energy Research and Development, Guangzhou 510640, Guangdong, China
  • Online:2020-09-05 Published:2020-09-11
  • Contact: Ziping FENG

摘要:

热泵蒸汽技术相比电锅炉及燃煤、燃气锅炉制取蒸汽,具有更高的一次能源利用效率,并且不产生CO2和NOx,符合我国节能环保发展战略。本文提出一种基于蒸汽压缩技术的热泵蒸汽系统,采用两级冷凝直接制取低压蒸汽,再通过蒸汽压缩升压至0.7MPa。并基于EES软件建立数值模型,分析冷凝温度Tcond、蒸发温度Tevap、经济器温度Tecon、喷气率βg对冷媒压缩机功耗Wrefri、蒸汽压缩机功耗Wvapor和系统能效系数COP的影响。结果如下:基于蒸汽压缩的热泵蒸汽系统,制取165℃的饱和蒸汽,在Tevap为50℃、Tcond为93℃时,系统COP为2.996,制取1t蒸汽消耗功率仅为247kW·h;系统COP随Tevap的升高逐渐增大,但是Tevap的升高需要更高的热源温度;蒸发温度不变时,系统存在最佳的Tcond、中间冷却温度Tecon和喷气率βg,当蒸发温度Tevap为50℃,最佳冷凝温度Tcond为93℃时,最佳经济器温度Tecon为65℃,最佳喷气率βg为0.13。

关键词: 蒸汽压缩, 热泵, 热工质

Abstract:

Heat pump steam technology has higher primary energy utilization efficiency, and does not produce CO2 and NOx, compared with electric boilers, coal-fired boilers and gas-fired boilers, which are in line with China’s energy-saving and environmental protection development strategy. This paper presented a heat pump steam engine based on vapor compression technology, which produced low pressure vapor by two-stage condensation and then boost to 0.7MPa by using vapor compressor. A mathematical model has been developed using the EES software. The effects of condensation temperature (Tcond), economizer temperature (Tecon), evaporation temperature (Tevap) on the refrigerant compressor power consumption (Wrefc), vapor compressor power consumption (Wvapc), the coefficient of performance (COP) were studied in detail. The results showed that the heat pump steam engine based on vapor compression technology obtain a COP of 2.996 under Tevap is 50℃ and Tcond is 93℃. The power consumption is 247kW·h for producing 1ton saturated steam of 165℃. The COP increases gradually with the increase of Tevap, but it requires a higher temperature heat source. There exists a highest COP with the optimum Tcond, Tecon, βg, when Tevap is 50℃, they are 93℃, 65℃ and 0.13, respectively.

Key words: vapor compression, heat pump, heat medium

中图分类号: 

版权所有 © 《化工进展》编辑部


本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn