化工进展 ›› 2021, Vol. 40 ›› Issue (1): 386-393.DOI: 10.16085/j.issn.1000-6613.2020-0524

• 精细化工 • 上一篇    下一篇

淘洗六水氯化铝过程中晶体沉降速度与纯化规律分析

梁高峰1(), 陈学青2, 王德武1, 张少峰1, 刘燕1, 张继军1()   

  1. 1.河北工业大学化工学院,天津 300130
    2.河北工业大学材料科学与工程学院,天津 300130
  • 收稿日期:2020-04-07 出版日期:2021-01-05 发布日期:2021-01-12
  • 通讯作者: 张继军
  • 作者简介:梁高峰(1993—),男,硕士研究生,研究方向为化工过程强化与优化。E-mail:309596617@qq.com
  • 基金资助:
    国家重点研发计划子课题(2016YFB0600504);河北省“巨人计划”第三批创新创业团队(161082)

Analysis of crystal settling velocity and purification law in the elutriation process of aluminum chloride hexahydrate

Gaofeng LIANG1(), Xueqing CHEN2, Dewu WANG1, Shaofeng ZHANG1, Yan LIU1, Jijun ZHANG1()   

  1. 1.School of Chemical Engineering, Hebei University of Technology, Tianjin 300130, China
    2.School of Materials Science and Engineering, Hebei University of Technology, Tianjin 300130, China
  • Received:2020-04-07 Online:2021-01-05 Published:2021-01-12
  • Contact: Jijun ZHANG

摘要:

针对粉煤灰酸法制氧化铝工艺中六水氯化铝结晶纯度难以控制、需进一步纯化的问题建立液固淘洗过程模拟实验,考察了液相密度、黏度、颗粒粒度及体积分数对颗粒沉降速度的影响,并用液体对颗粒的抵抗阻力对其修正,建立了关于沉降速度的计算模型,相对误差小于10%,能够较好地预测该体系下颗粒的沉降速度。按照淘洗过程模拟实验条件及对应的颗粒沉降速度设计静态实验,考察了钠、钙、镁和钾4种杂质离子随淘洗时间的变化规律,得到较优淘洗时间为60s。实验结果表明,杂质离子脱除率依次为Na+>Ca2+>Mg2+>K+,且最高脱除率均可达80%以上,杂质离子脱除率随着液固比的增大而提高,与沉降速度计算模型趋势一致,研究结果可为淘洗工艺的设计计算和优化提供参考。

关键词: 六水氯化铝, 淘洗, 液固两相流, 沉降速度, 晶体纯化

Abstract:

Aiming at the problem that the crystal purity of aluminum chloride hexahydrate was difficult to control in the process of preparing alumina from the fly ash by acid method and further purification was needed, a simulation experiment of liquid-solid elutriation process was established. The effects of liquid phase density, viscosity, particle size, and particle volume fraction on the settling velocity of the particles were investigated and corrected by the resistance of the liquid to the particles, and a calculation model for settling velocity was established, which had relative error of less than 10% and could better describe the settling velocity under the system. Designing the static test according to the simulated experimental conditions of the elutriation process and the corresponding particle settling velocity, the change rule of four impurity ions of sodium, calcium, magnesium and potassium with elutriation time was investigated, and the better elutriation time was 60s. Experimental results show the removal rate of impurity ion is Na+>Ca2+>Mg2+>K+, and the highest removal rate of each ion can reach more than 80%; the impurities elutriation removal rate of the crystals increase with the increase of the liquid-solid ratio, which is consistent with the settling velocity calculation model; and the research result provides a reference for the design calculation and optimization of the elutriation process.

Key words: aluminum chloride hexahydrate, elutriation, liquid-solid two-phase flow, settling velocity, crystal purification

中图分类号: 

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn