化工进展

• 应用技术 • 上一篇    下一篇

SQ112异丁烯脱含氧化合物剂工业侧线试验

周广林1,吴全贵2,扈文青2,周红军1,张文慧1   

  1. 1中国石油大学新能源研究中心,北京102249;2东营科尔特新材料有限公司,山东 东营 255400
  • 出版日期:2011-09-05 发布日期:2011-09-05

Industrial side stream test of SQ112 oxygenate scavenger for isobutene

ZHOU Guanglin1,WU Quangui2,HU Wenqing2,ZHOU Hongjun1,ZHANG Wenhui1   

  1. 1 Energy Research Center China Petroleum University(Beijing),Beijing 102249,China;2New Materials Co. Ltd. Dongying Coulter,Dongying 255400,Shandong,China
  • Online:2011-09-05 Published:2011-09-05

摘要:

按照小试制备的工艺条件放大生产了600 kg SQ112脱含氧化合物剂,并将其用于脱除异丁烯中的微量含氧化合物杂质;在1 L的工业侧线装置上,考察了SQ112脱含氧化合物剂在室温条件下的脱二甲醚情况以及再生性能。侧线试验结果表明:SQ112脱含氧化合物剂在0.6 MPa1 h1、室温的条件下,将异丁烯中的二甲醚含量从12001300 mg/L降至小于2 mg/L达到了聚合异丁烯的工艺指标,二甲醚的穿透吸附容量约5%,净化后的乙烯中没有其它副产物生成,该吸附剂可以再生,并且再生性能良好。

Abstract:

600 kg SQ112 oxygenate scavenger were prepared by scaling up laboratory test and used for removal of trace oxygenate in isobutene in a 1L fixed-bed reactor with industrial side stream feedstock. The performance of removing dimethyl ether in isobutene and its regeneration at room temperature were studied. The result showed that under 0.6 MPaliquid space velocity 1 h1 and room temperaturethe oxygenate scavenger SQ112 could remove dimethyl ether from 1200—1300 mg/L to less than 2 mg/L in isobutenemeeting the specification of polymer grade isobutene. The penetration adsorption capacity of SQ112 for dimethyl ether was about 5%. No byproduct was found in the isobutene after deoxygenation. This adsorbent could be regenerated and the performance was good after regeneration.

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn