化工进展

• 化工过程与装备 • 上一篇    下一篇

四种不同比表面积双曲型高效填料的流体力学与传质性能

李群生,于 丹,胡晓丹,杨 明   

  1. 北京化工大学化学工程学院,北京 100029
  • 出版日期:2010-10-05 发布日期:2010-10-05

Hydrodynamic and mass transfer performance of 4 SQ type high efficiency structured packing

LI Qunsheng,YU Dan,HU Xiaodan,YANG Ming   

  1. College of Chemical Engineering,Beijing University of Chemical Technology,Beijing 100029,China
  • Online:2010-10-05 Published:2010-10-05

摘要:

4种不同比表面积双曲SQ型金属波纹填料进行冷模实验。通过研究SQ型填料的流体力学和传质性能可知,双曲填料特殊的弧形波纹结构降低了塔压降,改善了气液分布。研究表明,SQ填料的塔压降要明显的低于BHS型填料,当L =20.38 m3 /m2·h时,SQ800压降比BHS800降低81.5%SQ1500在常压操作下每米理论级数最高可达到30,比SQ800的传质效率高,能耗高,但是操作范围小;板波纹SQ125填料操作范围最大但是分离效率低,适合原料粗分离;板波纹SQ250填料有较好的分离效率和较宽的操作范围,适合旧塔改造等。

Abstract:

A cold pilot model was constructed with four SQ type packings. The structurehydrodynamics and mass transfer performance of the new packing were investigated. Results showed that pressure drop was reduced by a special arc-shaped corrugation of SQ type packing and improved gas and liquid distribution was afforded. The pressure drop of SQ800 was far below that of BHS800when L=20.38 m3 /m2·hthe pressure drop of SQ800 was 81.5% lower than that of BHS800. The highest number of theoretical stages of SQ1500 could be achieved up to 30 at atmospheric pressure. Although the efficiency of SQ1500with a larger specific surface area than SQ800showed a significant increase compared with SQ800it occured with high energy consumption and narrow operational range. Sheet corrugated SQ125 has the best operation flexibility but the lowest separation efficiencywhich is suitable for crude separation of raw materials. Sheet corrugated SQ250 has better separation efficiency and narrower operational rangewhich can be applied to old tower reform.

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn