化工进展 ›› 2022, Vol. 41 ›› Issue (8): 4425-4431.DOI: 10.16085/j.issn.1000-6613.2021-2164

• 材料科学与技术 • 上一篇    下一篇

氯化锰/氨热化学吸附储热的特性

王震(), 闫霆(), 霍英杰   

  1. 上海电力大学能源与机械工程学院,上海 201306
  • 收稿日期:2021-10-21 修回日期:2021-12-20 出版日期:2022-08-25 发布日期:2022-08-22
  • 通讯作者: 闫霆
  • 作者简介:王震(1999—),男,硕士研究生,研究方向为热能储存。E-mail:wz990314@163.com

Performance of thermochemical sorption heat storage using manganese chloride/ammonia

WANG Zhen(), YAN Ting(), HUO Yingjie   

  1. College of Energy and Mechanical Engineering, Shanghai University of Electric Power, Shanghai 201306, China
  • Received:2021-10-21 Revised:2021-12-20 Online:2022-08-25 Published:2022-08-22
  • Contact: YAN Ting

摘要:

热化学吸附储热具有储热损失小、储热密度高、可实现冷热复合储存等优点,近年来得到了广泛的关注。本文以MnCl2/NH3作为吸附储热工质对,基于热化学吸附技术构建了热化学吸附储热实验平台,对MnCl2/NH3热化学吸附系统的储热性能进行了理论分析和实验研究。结果表明:在解吸充热温度、吸附放热温度、冷凝/蒸发温度分别为162℃、45℃和25℃的运行条件下,试验获得的吸附储热密度最大,其值为1296.36kJ/kg MnCl2或1101.90kJ/kg固化复合吸附剂。当放热温度从45℃增大到85℃时,热化学吸附储热系统的吸附储热效率从38.98%降低至24.08%。由于传热传质、化学反应动力学等因素的影响,相同运行工况下吸附储热系统实际所获得的储热性能要低于理论值。

关键词: 热能储存, 热化学吸附, 储热密度, 储热效率, 氯化锰/氨

Abstract:

Thermochemical sorption heat storage has attracted extensive attention in recent years because of its advantages such as low heat storage loss, high heat storage density and cold and hot composite storage. An experimental test system of thermochemical sorption heat storage was established based on the thermochemical sorption technology. For direct thermal energy storage and release mode of thermochemical sorption heat storage, theoretical analysis and experimental research were conducted by employing the MnCl2/NH3 as the working pair. The results showed that the highest thermochemical sorption heat storage density was 1296.36kJ/kg MnCl2 or 1101.90kJ/kg consolidated composite sorbent under the charging temperature of 162℃, discharging temperature of 45℃ and condensation/evaporation of 25℃. The thermochemical sorption heat storage efficiency decreased from 38.98% to 24.08% when the discharging temperature increased from 45℃ to 85℃. Due to the influence of heat and mass transfer, chemical reaction kinetics and other factors, the actual heat storage performance of the sorption heat storage system under the same operating conditions was lower than the theoretical value. Thermochemical sorption heat storage was a very promising way for thermal energy storage, which could be used in the efficient recovery and utilization of medium and low temperature thermal energy, such as solar energy and industrial surplus/waste heat. This work could provide the strong technical support and had the important guiding significance for practical industrial application.

Key words: thermal energy storage, thermochemical sorption, heat storage density, heat storage efficiency, manganese chloride/ammonia (MnCl2/NH3)

中图分类号: 

版权所有 © 《化工进展》编辑部


本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn