The continuous butanol fermentation of symbiotic system TSH06

doi:10.16085/j.issn.1000-6613.2017.04.035

Abstract

Abstract: The traditional butanol producing strain was strict anaerobic bacteria. A facultative anaerobic symbiotic system TSH06 was isolated in our lab,which could produce butanol under micro-aerobic conditions. This work studied the continuous butanol fermentation of TSH06 under the micro-aerobic condition. The effect of dilution rate on the cell growth and butanol production was investigeted. The test results indicated that the lower dilution rate enhanced the butanol production and the higher dilution rate was beneficial for the acid accumulation. However,the butanol productivity decreased when the dilution rate was higher than 0.2h^-1. The optimized dilution rate was 0.2h^-1 with the butanol productivity of 1.06 g/(L·h). The results provided the theoretical basis for the further optimization of butanol continuous fermentation under micro-aerobic conditions.

Key words: butanol, micro-aerobic fermentation, continuous fermentation, dilution rate, productivity

摘要： 传统的产丁醇生产菌均为严格厌氧，本实验室分离出一株兼性厌氧共生菌系TSH06，可在微氧条件下发酵生产丁醇。本文研究了共生菌系TSH06微氧条件下的丁醇连续发酵，考察了稀释率对TSH06细胞生长及丁醇合成的影响。结果表明，低稀释率有利于丁醇的生成，高稀释率有利于酸的积累，丁醇浓度随着稀释率的增大而减小，而生产强度随稀释率的增大而增大。当稀释率大于0.2h^-1时，生产强度呈下降趋势。最优化的稀释率为0.2h^-1，丁醇生产强度可达1.06g/（L·h）。研究结果可为微氧条件下丁醇连续发酵的进一步优化提供理论依据。

关键词: 丁醇, 微氧发酵, 连续发酵, 稀释率, 生产强度

CLC Number:

Q815

LI Dongyue, LI Xianglong, LIN Zhangnan, LIU Hongjuan, ZHANG Jian'an. The continuous butanol fermentation of symbiotic system TSH06[J]. Chemical Industry and Engineering Progress, 2017, 36(04): 1418-1423.

李冬月, 李祥龙, 林樟楠, 刘宏娟, 张建安. 共生菌系TSH06连续发酵生产丁醇[J]. 化工进展, 2017, 36(04): 1418-1423.

References

[1] 刘力强,李丽萍,李立强,等. 生物丁醇燃料产业化制造中的问题及发展趋势[J]. 生物产业技术,2008,(5):36-44. LI L Q,LI L P,LI L Q,et al. Problems and development tendency of biological butanol fuel industry manufacture[J]. Biotechnology & Business,2008(5):36-44.
[2] 闫永亮,刘宏娟,张建安. 代谢工程在生物丁醇生产中的应用及研究进展[J]. 现代化工,2012,32(4):25-29. YAN Y L,LIU H J,ZHANG J A. Application and research progress of metabolic engineering in butanol production[J]. Modern Chemical Industry,2012,32(4):25-29.
[3] 靳孝庆,王桂兰,何冰芳,等.丙酮丁醇发酵的研究进展及其高产策略[J].化工进展,2007,26(12):1727-1732. JIN X Q,WANG G L,HE B F,et al. Research progress and high yield strategy of acetone-butanol fermentation[J]. Chemical Industry and Engineering Progress,2007,26(12):1727-1732.
[4] 陈春燕,张俊青,崔海娣,等.PDMS膜生物反应器封闭循环连续发酵生产ABE[J]. 高校化学工程学报,2013,27(3):465-475. CHEN C Y,ZHANG J Q,CUI H D,et al. ABE Fermentation in a continuous and closed-circulating fermentation system with PDMS membrane bioreactor[J]. Journal of Chemical Engineering of Chinese Universities,2013,27(3):465-475.
[5] 华连滩,王义强,彭牡丹,等.生物发酵产丁醇研究进展[J].微生物学通报,2014,41(1):146-155. HUA L T,WANG Y Q,PENG M D,et al. Butanol fermentation production[J]. Microbiology China,2014,41(1):146-155
[6] 黄格省,李振宇,张兰波,等.生物丁醇的性能优势及技术进展[J].石化技术与应用,2012,30(3):254-259. HUANG G S,LI Z Y,ZHANG L B,et al. Performance advantage and technology progress in biobutanol[J]. Petrochemical Technology & Application,2012,30(3):254-259.
[7] 顾阳,蒋宇,吴辉,等.生物丁醇制造技术现状和展望[J]. 生物工程学报,2010,26(7):914-923. GU Y,JIANG Y,WU H,et al. Current status and prospects of biobutanol manufacturing technology[J]. Chinese Journal of Biotechnology,2010,26(7):914-923.
[8] 段晓瑞,王根宇,刘宏娟,等.兼性厌氧芽孢杆菌TSH1丁醇代谢途径中关键酶的检测[J].生物工程学报,2013,29(5):620-629 DUAN X R,WANG G Y,LIU H J,et al. Key enzymes in butanol fermentation by a facultative anaerobe Bacillus sp. TSH1[J]. China Journal of Biotechnology,2013,29(5):620-629.
[9] NI Y,SUN Z H. Recent progress on Industrial fermentative production of acetone-butanol-ethanol by Clostridium acetobutylicum in China[J]. Applied Microbiology Biotechnology,2009,83(3):415-423.
[10] ANDRADE J C,VASCONCELOS I. Continuous cultures of Clostridium acetobutylicum:culture stability and low-grade glycerol utilization[J]. Biotechnol. Lett.,2003,25(2):121-125.
[11] TASHIRO Y,TAKEDA K,KOBAYASHI G,et al. High production of acetone-butanol-ethanol with high cell density culture by cell-recycling and bleeding[J]. Journal of Biotechnology,2005,120(2):197-206.
[12] ZHENG J,TASHIRO Y,YOSHIDA T,et al. Continuous butanol fermentation from xylose with high cell density by cell recycling system[J]. Bioresource Technology,2013,129(2):360-365.
[13] CHEN Y,ZHOU T,LIU D,et al. Production of butanol from glucose and xylose with immobilized cells of Clostridium acetbutylicun[J]. Biotechnology and Bioprocess Engineering,2013,18(2):234-241.
[14] CHANG Z,CAI D,WANG Y,et al. Effective multiple stages continuous acetone-butanol-ethanol fermentation by immobilized bioreactors:making full use of fresh corn stalk[J]. Bioresource Technology,2016,205:82-89.
[15] CHANG Z,CAI D,WANG C,et al. Sweet sorghum bagasse as an immobilized carrier for ABE fermentation by using Clostridium acetobutylicum ABE 1201[J]. RSC Advances,2014,4(42):21819-21825.
[16] SURVASE S A,HEININGEN A V,GRANSTRÖM T. Continuous bio-catalytic conversion of sugar mixture to acetone-butanol-ethanol by immobilized Clostridium acetobutylicum DSM 792[J]. Applied Microbiology & Biotechnology,2012,93(6):2309-2316.
[17] VIIKILÄ M,WALLENIUS J,OJAMO H,et al. Impact of varying lignocellulosic sugars on continuous solvent production in an immobilized column reactor[J]. Bioresource Technology,2013,147(11):299-306.
[18] PAREKH M,FORMANEK J,BLASCHEK HP. Development of a cost-effective glucose-corn steep medium for production of butanol by Clostridium beijerinckii[J]. Journal of Industrial Microbiology & Biotechnology,1998,21(4):187-191.
[19] WANG G Y,WU P F,LIU Y,et al. Isolation and characterization of non-anaerobic butanol-producing symbiotic system TSH06[J]. Applied Microbiology & Biotechnology,2015,99(20):8803-8813.
[20] WU P F,WANG G Y,WANG G H,et al. Butanol production under microaerobic conditions with a symbiotic system of Clostridium Acetobutylicum and Bacillus cereus[J]. Mcrobial Cell Factories,2016,15(1):1-11
[21] 夏子义,倪晔,孙志浩,等.利用Clostridium saccharobutylicum DSM 13864连续发酵生产丁醇[J].化工进展,2013,32(1):156-160. XIA Z Y,NI Y,SUN Z H,et al. Continuous butanol fermentation by Clostridium saccharobutylicum DSM 13864[J]. Chemical Industry and Engineering Progress,2013,32(1):156-160.