Chemical Industry and Engineering Progree

• 应用技术 • Previous Articles     Next Articles

Preparation and application of loaded catalyst on the process of
catalytic wet air oxidation to emulsification wastewater

ZENG Xinping,TANG Wenwei,ZHAO Jianfu,GU Guowei   

  1. School of Life Science and Technology,Tongji University; Department of Chemistry,
    Tongji University; State Key Laboratory of Pollution Control and Resource Reuse,
    Tongji University
  • Online:2006-02-25 Published:2006-02-25

乳化液废水催化湿式氧化处理工艺中的
负载型催化剂的研制与应用

曾新平,唐文伟,赵建夫,顾国维   

  1. 同济大学生命科学与技术学院; 同济大学化学系;
    同济大学污染控制与资源化研究国家重点试验室

Abstract: This article systematically studied the influence of concentration of soaked liquid, the roasting time and the roasting temperature to activeness and the stable performance of CuO/γ–Al2O3 catalyst on system of catalyzed wet air oxidation, and the best preparation condition has been determined .The experimental results indicated that CuO/γ–Al2O3 catalyst was applied in the treatment of emulsification wastewater resulted in 88.4% CODCr removal after 2hrs’ oxidation at 200 ℃ (13.0%’s improvement compared to non-catalytic oxidation).

摘要: 研究了在催化湿式氧化体系中浸渍液浓度、焙烧时间和焙烧温度等制备条件对CuO/γ–Al2O3催化剂的催化活性和稳定性的影响;确定了最佳制备条件。结果表明:优化制备的CuO/γ–Al2O3催化剂,用于处理高浓度难降解的乳化液废水时,具有良好的催化活性,在200 ℃时反应2 h的CODCr去除率为88.4%,比未加催化剂的常规工艺提高了13.0%。

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd