化工进展

• 研究开发 • 上一篇    下一篇

热分析在磷石膏制酸反应研究中的应用

刘少文,张 茜,吴元欣,包传平   

  1. 武汉工程大学绿色化工过程省部共建教育部重点实验室
  • 出版日期:2008-05-05 发布日期:2008-05-05

Thermal analysis and its application in the investigation of reaction process for sulfuric acid production from phosphogypsum

LIU Shaowen,ZHANG Qian,WU Yuanxin,BAO Chuanping   

  1. Key laboratory for Green Chemical Process of Ministry of Education,Wuhan Institute of Technology
  • Online:2008-05-05 Published:2008-05-05

摘要: 采用热分析方法研究磷石膏制酸过程中CaSO4与焦炭的反应进程。在TG-DTA热分析仪上研究原料配比(C与CaSO4摩尔比)对反应进程及反应温度的影响。通过比较化学反应的实际失重量与理论失重量,发现原料配比为0.4和0.5时,反应先生成CaS,且反应温度随原料配比增加而降低。当原料配比增至0.6时,反应先生成CaO、CO。反应产物的XRD表征也进一步证实分别生成了CaS和CaO,因此可以认为热分析方法用于磷石膏制酸反应研究是可行的。最后对反应机理进行了初步的探讨。

Abstract: Thermal analysis was used in the investigation of reaction process for sulfuric acid production from phosphogypsum. The effects of different raw material C/CaSO4 molar ratios on reaction process and reaction temperature were investigated with TG-DTA thermal analyzer. Through the comparison for the difference between experimental and theoretical weight loss values,it was found that CaSO4 was reduced to CaS by C during the first reaction step when raw material molar ratios was 0.4 and 0.5. At the same time,the reaction temperature decreased with increasing raw material molar ratio. However,the products were CaO and CO,etc. during the first reaction step when raw material molar ratio increased to 0.6. XRD results of samples also confirmed that the reaction resultants included CaS and CaO respectively. Therefore it was concluded that the use of thermal analysis in the investigation of reaction process for sulfuric acid production from phosphogypsum was feasible. Finally a discussion on the reaction mechanism was given.

京ICP备12046843号-2;京公网安备 11010102001994号
版权所有 © 《化工进展》编辑部
地址:北京市东城区青年湖南街13号 邮编:100011
电子信箱:hgjz@cip.com.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn