Chemical Industry and Engineering Progree ›› 2016, Vol. 35 ›› Issue (12): 4076-4081.DOI: 10.16085/j.issn.1000-6613.2016.12.048

Previous Articles     Next Articles

Treatment of methylene blue wastewater with a compound photo-catalyst TiO2-HNTs combined with dielectric barrier discharge

YU Fang, CHEN Yuantao, ZHANG Wei, HE Wenfang, WANG Yunsheng, LIU Chen   

  1. Department of Chemistry, Qinghai Normal University, Xining 810008, Qinghai, China
  • Received:2016-05-04 Revised:2016-07-04 Online:2016-12-05 Published:2016-12-05

TiO2-HNTs催化剂协同介质阻挡放电等离子体降解亚甲基蓝废水

余芳, 陈元涛, 张炜, 赫文芳, 王雲生, 刘晨   

  1. 青海师范大学化学系, 青海 西宁 810008
  • 通讯作者: 陈元涛,教授,硕士生导师。E-mail:chenyt@qhnu.edu.cn。
  • 作者简介:余芳(1993-),女,硕士研究生,研究方向为资源循环与利用。

Abstract: In order to further improve methylene blue (MB) removal efficiency,a method of discharge plasma combined with photo-catalyst was adopted in this research. A compound photo-catalyst(TiO2-HNTs) was made by a sol-gel process,which was characterized by XRD,FTIR and GTA. Photo-catalytic ability and influencing factors were tested. The kinetics of the reaction was studied. The results showed that TiO2-HNTs has a synergetic effect when combined with dielectric barrier discharge,and significantly increases methylene blue removal rate. The removal rate of methylene blue was 85.37% after a 60 minutes reaction. The degradation of methylene blue is in accordance with the apparent pseudo-second-order. The degradation of methylene blue is influenced by many factors,including MB concentration,TiO2-HNTs concentrations,calcination temperature,discharge power and air flow. The degradation is optimal when MB concentration is 100mg/L,TiO2-HNTs concentrations is 70mg/L,calcination temperature is 300℃,discharge power is 200W and air flow is 200mL/min.

Key words: dielectric barrier discharge, compound photo-catalyst, methylene blue, removal rate

摘要: 为进一步提高介质阻挡放电等离子体(DBD)降解亚甲基蓝(MB)的效率,研究了采用介质阻挡放电等离子体和光催化剂协同技术。实验采用溶胶-凝胶法制备TiO2-HNTs复合光催化材料,并利用XRD、FTIR、TGA方法对催化剂进行表征分析。考察了该材料的光催化性能,以及它与介质阻挡放电的联合降解过程中操作因素的影响,并对反应进行动力学研究。研究结果表明,TiO2-HNTs复合光催化材料与介质阻挡放电产生协同作用,并能有效地提高MB的去除率,处理60min后,协同体系对MB的降解率为85.37%,MB的降解过程符合表观一级反应动力学方程。MB的去除率与MB的初始浓度,TiO2-HNTs的投加量、煅烧温度、放电功率和通气量有关。当MB的初始浓度为100mg/L、TiO2-HNTs的投加量为70mg/L、煅烧温度为300℃、放电功率为200W、通气量为200mL/min时,MB的去除效果较好。

关键词: 介质阻挡放电等离子体, 复合光催化材料, 亚甲基蓝, 去除率

CLC Number: 

京ICP备12046843号-2;京公网安备 11010102001994号
Copyright © Chemical Industry and Engineering Progress, All Rights Reserved.
E-mail: hgjz@cip.com.cn
Powered by Beijing Magtech Co. Ltd