化工进展 ›› 2022, Vol. 41 ›› Issue (1): 192-200.DOI: 10.16085/j.issn.1000-6613.2021-0372

• 能源加工与技术 • 上一篇    下一篇

化学链重整制氢NiO-CeO2/γ-Al2O3复合载氧体的性能

韩丹华(), 郭雪岩(), 王志远   

  1. 上海理工大学能源与动力工程学院,上海 200093
  • 收稿日期:2021-02-23 修回日期:2021-06-17 出版日期:2022-01-05 发布日期:2022-01-24
  • 通讯作者: 郭雪岩
  • 作者简介:韩丹华(1994—),女,硕士研究生,研究方向为固定床化学链重整制氢技术。E-mail:handanhua@126.com

Performance of NiO-CeO2/γ-Al2O3 composite oxygen carriers for hydrogen generation with chemical looping reforming

HAN Danhua(), GUO Xueyan(), WANG Zhiyuan   

  1. School of Energy and Power Engineering, University of Shanghai for Science and Technology, Shanghai 200093, China
  • Received:2021-02-23 Revised:2021-06-17 Online:2022-01-05 Published:2022-01-24
  • Contact: GUO Xueyan

摘要:

采用浸渍法制备了结构型NiO-CeO2/γ-Al2O3复合载氧体,研究了Ni/Ce质量比对化学链重整制氢反应性能的影响。固定床反应器实验表明,随着Ni/Ce质量比的降低,氢气的选择性先升高后降低,比例为3∶1时氢的选择性和氢产物浓度最高。循环实验测试表明,3∶1载氧体在20个循环后仍保持催化活性,积炭量最低。XRD结果表明,加入CeO2后有固溶体形成,增加了氧空位,在一定程度上减弱了NiO与γ-Al2O3之间的相互作用,提高了活性物质的分散度。进一步分析XRD结果发现3∶1载氧体粒径最小,更有利于制氢反应。SEM分析发现,经过20次循环3∶1载氧体颗粒的微观形貌变化相对较小。进一步的固定床实验研究表明较高的反应温度有利于制氢反应,800℃时3∶1载氧体的性能表现最佳;此外3∶1载氧体在较高水碳比下仍能保持较高的产物选择性。

关键词: 化学链重整, 复合载氧体, 制氢, 固定床, 活性, 甲烷

Abstract:

NiO-CeO2/γ-Al2O3 oxygen carrier was prepared with the impregnation method and the effects of Ni/Ce mass ratios on the performance of chemical looping reforming hydrogen production were studied. The experiments with fixed bed reactor revealed that the selectivity of hydrogen first increased and then decreased as the ratio decreases. For the ratio of 3∶1, there was a maximal selectivity of hydrogen together with the highest concentration of hydrogen produced. The cycle test showed that the 3∶1 oxygen carrier still maintained good reaction activity and the lowest carbon deposited after 20 cycles. Meanwhile, the XRD results showed that addition of CeO2 was leads to formation of Ce-O-Ni solid solution, which weakened the interaction between NiO and γ-Al2O3 to a certain extent, and subsequently increased oxygen vacancies and improved the dispersion of active materials. Further analyses on the XRD results indicated that the 3∶1 oxygen carrier had the smallest particle size, which was more conducive to hydrogen production by reaction. In fact, the microscopic morphology of the 3∶1 oxygen carrier particles only changes slightly after 20 cycles of testing according to SEM analyses. The further fixed bed experiments indicated that higher temperature was conducived to the hydrogen production reactions and the 3∶1 oxygen carrier performed significantly better than the others. Meanwhile, it was found the 3∶1 oxygen carrier could still maintain high product selectivity under higher water-to-carbon ratio.

Key words: chemical looping reforming, composite oxygen carrier, hydrogen production, fixed-bed, reactivity, methane

中图分类号: 

版权所有 © 《化工进展》编辑部


本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn